Page 177 of 477
Check fuse "BRAKE SWITCH"
This warning message illuminatesif the brake switch fuse is discon-
nected.
You need to replace the fuse with a new one. If not possible, you can
start the engine by pressing the
Engine Start/Stop button for 10
seconds in the ACC position.
Turn on "FUSE SWITCH"
This warning message illuminatesif the fuse switch under the steer-
ing wheel is OFF.
You should turn ON the fuse switch.
❈ For further information, refer to
“Fuses” in the chapter 7.
Low Tire Pressure
This warning message illumi-
nates, when the tire is under-inflat-
ed with the Engine Start/Stop but-
ton ON.
❈ For further information, refer to
"Tire Pressure Monitoring System
(TPMS)" in the chapter 6.
Check Fuel Cap
This warning message illumi-
nates, when the fuel filler cap is
open or is not securely tightened.
Securely close the fuel filler cap.
3-82
Convenient features of your vehicle
OVI045738
OVI045739
OVI045740
OVI045741
Page 261 of 477

Information
• When the battery is weak, or whenthe Smart Key does not properly
operate, you can start the engine by
pressing the Smart Key onto the
Engine Start/Stop button.
The Smart Key edge near the lock
button should be directly contacted
onto the Engine Start/Stop button.
When you press the Smart Key onto
the Engine Start/Stop button, the
Smart Key should be contacted onto
the button at a right angle.
(Continued)(Continued)
• When the stop light fuse is blown
out, you cannot normally start the
engine. Replace the blown-out fuse
with a new one. If you are not able
to replace the fuse, you can start the
engine by pressing the Smart Key
onto the Engine Start/Stop button
for 10 seconds. The engine can start
without depressing the brake pedal.
However, for your safety, always
depress the brake pedal before
starting the engine.
Do not press the Engine
Start/Stop Button for more than 5
seconds except when the stop
light fuse is disconnected.
NOTICE
i
5-10
Driving your vehicle
OVI055003N
■Type A
OVI055004N
■ Type B
Page 268 of 477

Power brakes
Your vehicle is equipped with the
power-assisted brakes that automat-
ically adjust themselves in a normal
driving condition.
In the event that the power-assisted
brakes lose power because of a
stalled engine or some other rea-
sons, you can still stop your vehicle
by depressing the brake pedal hard-
er than you do in normal driving. A
braking distance, however, will be
longer.
When the engine is OFF, the reserve
brake power becomes partially
depleted each time the brake pedal
is depressed. Do not repeatedly
depress the brake pedal when the
power brake is automatically set.
Pump the brake pedal only when
necessary to maintain the steering
control on slippery surfaces.
B BR
RA
A K
KE
E
S
S Y
Y S
ST
T E
EM
M
5-17
Driving your vehicle05
- Brakes
Do not put your foot on the
brake pedal while driving. This
may abnormally increase the
brake temperatures, wear
down the brake lining/pad,
and increase the braking dis-
tances.
When driving down on a long or steep slope, shift to a lower
gear and avoid depressing the
brakes in a continuous man-
ner. Depressing brakes in a
continuous manner may over-
heat the brakes, resulting in a
temporary loss of braking per-
formance.
(Continued)
(Continued)
Wet brakes may impair thevehicle’s ability to safely slow
down. The vehicle may also be
swerved to one side when the
wet brakes are depressed.
Lightly depress the brakes to
verify whether the brakes are
wet and show the above
symptom. Always test your
brakes in this fashion after
driving through deep water.
To dry the wet brakes, lightly
depress the brakes, while
maintaining a safe driving
speed until the brake perform-
ance returns to normal.
Always confirm the positions of the brake and accelerator,
before driving. If you do not
so, you may be confused and
depress the accelerator
instead of the brake pedal. It
may cause a serious accident.
WARNING
Page 360 of 477

Fuses ......................................................................7-\
56
Inner panel fuse replacement ......................................7-57
Engine compartment fuse replacement ....................7-59
Fuse/relay panel description .......................................7-60
Light bulbs.............................................................7-69
Headlight, position light, turn signal light,
side marker light and front fog light bulb
replacement ......................................................................7-\
70
Side repeater light bulb replacement.........................7-74
Rear combination light bulb replacement .................7-75
High mounted stop light ................................................7-75
License plate lamp replacement ..................................7-79
Interior light bulb replacement ....................................7-82
Appearance care ..................................................7-83
Exterior care ....................................................................7-83\
Interior care......................................................................7-\
88
Emission control system .....................................7-89
Crankcase emission control system ...........................7-89
Evaporative emission control system.........................7-89
Exhaust emission control system ...............................7-90
California perchlorate notice .............................7-92
Page 361 of 477
1. Engine coolant reservoir
2. Radiator cap
3. Brake fluid reservoir
4. Air cleaner
5. Engine oil dipstick6. Engine oil filler cap
7. Windshield washer fluid reservoir
8. Fuse box
9. Power steering fluid reservoir
10. Jumper terminal
E E
N
N G
GI
IN
N E
E
C
C O
O M
M P
PA
A R
RT
TM
M E
EN
N T
T
7-4
OVI015006N
Maintenance
❈ The actual engine compartment in the vehicle may differ from the illustration.
❈ The battery is in the trunk.
Page 413 of 477

7-56
Maintenance
A vehicle’s electrical system is pro-
tected from a possible electrical
overloading damage by fuses.
This vehicle has 4 fuse panels - two
on the driver’s side, another on the
panel bolster of the passenger's
side, and the other in the engine
compartment.
When any of your lights, acces-
sories, or controls does not operate,
check the appropriate circuit fuse.
When a fuse is out, some elements
may melt inside.
When the electrical system does not
operate, check the fuse panel on the
driver's side first.
Before replacing the fuse, disconnect
the negative battery cable. Always
replace it with a fuse of the same rat-
ing. When the newly-replaced fuse
blows, there may be an electrical
problem. Avoid using any pertinent
systems. Immediately consult an
authorized EQUUS dealer.
Three kinds of fuses are to be used:
a blade type for lower amperage rat-ing, and a cartridge type and a fusiblelink for higher amperage ratings.
Information
The actual fuse, relay panels, and
labels may differ from the equipped
items.
i
F F U
U S
SE
E S
S
OVI075172N
Normal
Normal
Blade type
Cartridge type
Fusible link Blown
Blown
Normal Blown
- Fuse replacement
Never replace a fuse with the
one of a different rating.
A higher capacity fuse may cause damage or a fire.
Never use a wire or an alu- minum foil, instead of a prop-
er fuse - even as an emergent
measure. It may damage
extensive wirings and cause a
fire.
WARNING
Do not use a screwdriver or any
other metal object to remove a
fuse. It may cause a short cir-
cuit and damage the system.
CAUTION
Page 414 of 477
7-57
Maintenance07
When replacing a blown fuse orrelay with a new one, make sure
the new fuse or relay fits tightly
into the clips The incomplete
fastening fuse or relay may
cause the vehicle wiring and
electric systems damage and a
possible fire.
Do not remove fuses, relays and terminals fastened with bolts or
nuts. The fuses, relays and ter-
minals may be fastened incom-
pletely, and it may cause a pos-
sible fire. If fuses, relays and ter-
minals fastened with bolts or
nuts are blown, consult an
authorized EQUUS dealer.
Do not input any other objects except fuses or relays into
fuse/relay terminals such as a
driver or wiring. It may cause
contact failure and system mal-
function.
Inner panel fuse replacement
1. Turn OFF the ignition switch and all the other switches.
2. Open the fuse panel cover.
NOTICE
OVI075100N
Driver’s side
OVI075173N
Front passenger’s side
Page 415 of 477

7-58
Maintenance
3.Pull straight out a fuse, which is suspected to be out. Use the fuse
puller provided in the panels either
on the driver’s side or the front pas-
senger’s side.
4. Check the removed fuse. When the fuse is out, replace it.
Spare fuses are provided in the
fuse panels in the front passen-
ger's side. (or in the fuse panel of
the engine compartment)
5. Install a new fuse of the same rat- ing, and tightly secure it in the
clips.
When it is loosely fit, consult an
authorized EQUUS dealer.
When you do not have a spare fuse,
use a fuse of the same rating from a
circuit, such as a cigarette lighter fuse,
which may not be needed to drive. When the headlamps or other electri-
cal components do not operate, but
when the fuses are not blown out,
check the fuse panel in the engine
compartment. In case that a fuse is
blown out, it must be replaced.fuse is
blown, it must be replaced.
Fuse switch
Always set the transportation fuse
switch in the "ON" position. When
you press it OFF, some devices,
such as the audio and the digital
clock, must be reset. Also, the Smart
Key may not properly operate.
Always set the transportation
fuse switch in the "ON" position
while driving.
Do not repeatedly press the transportation fuse switch. The
fuse switch may be worn out.
Information
When you do not drive your vehicle
more than 1 month, press OFF the
transportation fuse switch to prevent
a battery discharge.
i
NOTICE
OVI075101N
Driver’s side
OVI075174N
Front passenger’s side
OVI075102N