2016 Hyundai Equus brake sensor

5-57
Driving your vehicle05
Even if there is a malfunctionin AVSM braking, the brake is
normally operable by
depressing the brake pedal.
The AVSM braking does not
operate in certain hazardous
situations.
The AVSM is designed to be active, while driving above
approximately 9.3 mph (15
km/h) and below approximate-
ly 111.8 mph (180 km/h).
The AVSM does not react to: - A person or animal
- An oncoming vehicle inlanes of the opposite direc-
tion or a vehicle in an inter-
section
- A stopped object
The AVSM cannot detect an object in below conditions:
- The sensors are stained orcovered with dirt.
- There is heavy rain or heavy snow.
- There is interference from electromagnetic waves.
- There are strong radar reflections.
- The vehicle drives in a curve.
- The vehicle drives uphill or downhill.
- The vehicle drives in a con- struction area.
- An object in front is very nar- row, such as a motorcycle or
bicycle.
- A vehicle suddenly cuts in front.
(Continued)
(Continued)
The AVSM braking operationin inoperable, when the driver
does not release the accelera-
tor nor depress the brake
pedal.WARNING

Changing a tire with TPMS
When you have a flat tire, both of the
low tire pressure telltale and the low
tire position telltale will illuminate.
Immediately have the flat tire
repaired or replaced by an author-
ized EQUUS dealer.
The spare tire is not equipped with a
tire pressure monitoring sensor.
Thus, when replacing with the spare
tire, the low tire pressure telltale will
remain ON.
Also, the TPMS Malfunction Indicator
will illuminate after 1-minute flashing,
when the vehicle drives at a speed
above 15.5 mph (25 km/h) for
approximately 20 minutes.
When the tire equipped with a tire
pressure monitoring sensor is re-
inflated to the recommended level,
the low tire pressure telltale and
TPMS malfunction indicator will go
OFF for a few minutes.
When the indicator illumination does
not go OFF after a few minutes,
please visit an authorized EQUUS
dealer.Each wheel is equipped with a tire
pressure sensor, inside the tire and
behind the valve stem (except for the
spare tire). You must use the TPMS-
specific wheels. It is recommended
that you always have your tires serv-
iced by an authorized EQUUS deal-
er.
You cannot diagnose under-inflation
of a tire only with eyes. Always use a
tire pressure gauge of good quality to
measure the pressure level. Please
note that a heated tire (from being
driven) has higher pressure meas-
urement criteria than a cold tire.
A cold tire means the vehicle was
driven for less than 1 mile (1.6 km),
or was mostly idle for the last 3
hours.
Cool down the tire before measuring
the inflation pressure. Always make
sure that the tire is cold before inflat-
ing the tire to the recommended
pressure level.
6-10
What to do in an emergency
Never use an unauthorized
puncture-repairing agent to
repair and/or inflate an under-
inflated tire. Unauthorized tire
sealant may damage the tire
pressure sensor.
CAUTION
- TPMS
The TPMS cannot alert the driver to a sudden but severe
tire damage caused by exter-
nal factors, such as nails or
road debris.
When you sense any driving instability, immediately take
your foot off the accelerator,
lightly apply the brakes, and
slowly drive to a safe place off
the road.
WARNING

7-62
Maintenance
Instrument panel (Driver’s side fuse panel)
Fuse Name Fuse ratingCircuit Protected
PDM (B+) 25A Smart Key Control Module
HAZARD 10A Center Facia Switch
EPB 10A Electric Parking Brake Switch, Crash Pad Switch
RF RECEIVER 10A RF Receiver, Security Indicator PDM (IG1) 10A Smart Key Control Module
SHIFT LEVER (IG1) 10A ATM Shift Lever IND. A/BAG IND. 10A Instrument Cluster
SMART KEY 10A Start/Stop Button Switch P/HANDLE 10A Steering Tilt & Telescopic Module
MEMORY 10APower Trunk Lid Control Module, Relax Module
Driver/Passenger Door Module, Rear Door Module
LH/RH, Passenger Door Lamp, Passenger Door Mood
Lamp, Rear Door Lamp LH/RH, Rear Door Mood Lamp
LH/RH Instrument Cluster, Driver IMS Control Module,
BCM, Analogue Clock, LCD Panel Switch,
A/C Control Module, Data Link Connector
TPMS 10A Tire Pressure Monitoring Module
ACTIVE H/REST 10A Active Head Rest Sensor Module CLUSTER 10A Instrument Cluster, Head-Up Display
STOP LAMP 10A Stop Lamp Switch, Smart Key Control Module
SHIFT LEVER (B+) 10A Sport Mode Switch
MULTI MEDIA 15A A/V & Navigation Head Unit, Front Monitor, Split Unit,
MTS Module, Front DIS Switch, Rear Monitor LH/RH,
Rear Console Switch, Rear Audio Switch
BCM 10A BCM
IG1 30AE/R Junction Box (Fuse - B/UP LAMP, ESC, EHPS,
AFLS, INJECTOR (IG1), CRUISE (IG1), ECU (IG1),
TCU)
1 MODULE 10A Head-Up Display, Rain Sensor, Rear Power Seat Switch LH
F/LID 10A Fuel Filler Door Switch, Front Console Switch
FOLD'G MIRR 10A Driver/Passenger Door Module
A/BAG 15ASRS Control Module, Driver/Passenger Pre-Safe Seat
Belt, Center Facia Switch, PODS Module
4 MODULE 10A E/R Junction Box (FAM), Multifunction Switch
Driver/Passenger Door Module
ECS 15A ECS Control Module
AUDIO (IG1) 10A A/V & Navigation Head Unit, MTS Module AFLS 10A Head Lamp LH/RH, Adaptive Front Lighting Module
O/S HDL DRV 15A Driver Power Door Latch, Driver Power Seat Switch,
Driver Door Lamp, Driver Door Mood Lamp, Driver Smart
Key Outside Handle

7-63
Maintenance07
Fuse Name Fuse ratingCircuit Protected
S/HEATER RR 15A Rear CCS Control Module LH, Rear Seat Warmer
Module LH
2 MODULE 10A Power Trunk Lid Control Module, Electro Chromic Mirror,
A/T Console Switch
A/CON 10AA/C Control Module, AQS Sensor, Driver IMS Control
Module Relax Module, Driver/Passenger CCS Control
Module Driver/Passenger Seat Warmer Module,
Rear CCS Control, Module LH/RH, Rear Seat Warmer
Module LH/RH, Alternator Resistor (Alternator,
Instrument Cluster, USB Jack, Rear Console Switch)
O/S HDL RR 15A Rear Power Door Latch LH, Rear Door Window Curtain
LH, Rear Smart Key Outside Handle LH
3 MODULE 10A ECS Control Module, Front Console Switch, Crash Pad
Switch, Blind Spot Detection Radar LH/RH Tire Pressure
Monitoring Module, Stop Lamp Switch, Steering Tilt &
Telescopic Module, LDWS Camera Module Electric
Parking Brake Module, Front/Rear Parking Assist Sensor
LH/RH Front/Rear Parking Assist Sensor LH/RH (Center)
DR LOCK DRV 10A Driver Door Module
S/HEATER DRV 15A Driver CCS Control Module, Driver Seat Warmer Module
DR LOCK PASS 15A Passenger Door Module P/TRUNK 30A Power Trunk Lid Control Module
P/SEAT PASS 30A Relax Module
RH SAFETY
POWER WINDOW 30APassenger Power Window Module,
Rear Power Window Module RH
LH SAFETY
POWER WINDOW 30ADriver Power Window Module,
Rear Power Window Module LH

7-67
Maintenance07
Engine compartment main fuse panel
Fuse Name Fuse ratingCircuit Protected
WIPER (B+) 30A Electronic Control Wiper Module FAM 2 (B+) 40A FAM
FAM 1 (B+) 40A FAM START 30A Start Relay
WASHER 15A Washer Relay
WIPER (IG2) 10A Electronic Control Wiper Module DEICER 15A Deicer Relay
CRUISE (B+) 10A H/Lamp Relay, Smart Cruise Control Module HORN 15A Horn Relay
EPB 2 15A Electric Parking Brake Module
EPB 1 15A Electric Parking Brake Module
A/CON 10A A/C Control Module
BLOWER 40A Blower Relay
PRESAFETY
SEAT BELT LH 40A Driver Pre-Safe Seat Belt
RR HTD 40A RR HTD Relay
PRESAFETY
SEAT BELT RH 40A Passenger Pre-Safe Seat Belt
ECU (IG1) 10A ECM, Alternator ESC 10AESC Module, E/R Fuse &
Relay Box (Multipurpose Check Connector)
EHPS 10A EHPS Module
AFLS 10A Head Lamp LH/RH
TCU 15A TCM, Transmission Range Switch
HTD MIRR 10A Driver/Passenger Power Outside Mirror F/PUMP 20A F/Pump Relay
ROOM LAMP 10A Room Lamp Relay ECU (B+) 15A ECM, TCM
B/UP LAMP 10A Steering Angle Sensor, B/UP LP RLY’S’
CRUISE (IG1) 10A Smart Cruise Control Module
INJECTOR (IG1) 10A Injector Drive Box H/LAMP LH 15A Head Lamp LH
H/LAMP RH 15A Head Lamp RH
3 SENSOR 10A ECM, F/Pump Relay, Camshaft Position Sensor
(BANK1/BANK2) (Intake/Exhaust)
2 SENSOR 10A Canister Close Valve, Oil Control Valve #1 ~ #4, E/R Fuse &
Relay Box (C/Fan Relay), Purge Control Solenoid Valve
1 SENSOR 10A ECM, Oxygen Sensor #1 ~ #4
INJECTOR (B+) 15A Injector Drive Box IGN COIL 20A Condenser #1/#2, Ignition Coil #1 ~ #8ECU 30A ECU Relay

7-83
Maintenance07
A
AP
PP
PE
EA
A R
RA
A N
N C
CE
E
C
C A
A R
RE
E
Exterior care
Exterior general caution
It is very important to follow the label
directions when using any chemical
cleaner or polish. Read all the warn-
ings and cautions on the label.
High-pressure washing
• When using high-pressure wash-
ers, make sure to maintain suffi-
cient distance from the vehicle.
Insufficient clearance or excessive
pressure can lead to component
damage or water penetration.
Do not spray the camera, sensors or its surrounding area directly with
a high pressure washer. Shock
applied from high pressure water
may cause the device to not oper-
ate normally.
Do not bring the nozzle tip close to boots (rubber or plastic covers) or
connectors as they may be dam-
aged if they come into contact with
high pressure water.
Finish maintenance
Washing
To protect your vehicle’s paint from
rust and deterioration, thoroughly
wash the vehicle at least once a
month with lukewarm or cold water.
After each off-road driving, you
should wash the vehicle. Pay special
attention to removing any salty and
muddy substances. Make sure the
drain holes on the lower door edges
and on the rocker panels are kept
clear and clean. Insects, tar, tree sap, bird droppings,
industrial pollutants and similar
deposits damage your vehicle’s fin-
ish, if not immediately removed.
Even prompt washing with plain
water may not completely remove all
these deposits. A mild soap, which is
safe for a painted surface, may be
used.
After soaping, thoroughly rinse the
vehicle body with lukewarm or cold
water. Do not allow soap to dry on
the finish.
• Do not use strong soap, chemical detergents or hot
water. Do not wash the vehicle
when it is under direct sun-
light, or when its body is
warm.
Be careful when washing the side windows of your vehicle.
Especially, with high-pressure
water, water may penetrate
into the windows and wet the
interior.
To prevent damage to plastic parts and lamps, do not wash
the vehicle with chemical sol-
vents or strong detergents.
CAUTION
- Wet brakes
After washing the vehicle, test
the brake operations to check
whether it is affected by water.
When the braking performance
is deteriorated, dry the brakes
by lightly applying them and
driving forward at a slow speed.
WARNING