2016 Hyundai Creta air condition

F9
Introduction
Diesel engine
Diesel fuel
Diesel engine must be operated only
on commercially available diesel fuel
that complies with EN 590 or compa
rable standard. (EN stands for
"European Norm"). Do not use
marine diesel fuel, heating oils, or
nonapproved fuel additives, as this
will increase wear and cause dam
age to the engine and fuel system.
The use of nonapproved fuels and /
or fuel additives will result in a limita
tion of your warranty rights.
Diesel fuel of above cetane 51 is
used in your vehicle. If two types of
diesel fuel are available, use summer
or winter fuel properly according to
the following temperature conditions.
• Above 5°C (23°F) ... Summer typediesel fuel.
• Below 5°C (23°F) ... Winter type diesel fuel.
Watch the fuel level in the tank very
carefully : If the engine stops through
fuel failure, the circuits must be com
pletely purged to permit restarting.Do not let any gasoline or water
enter the tank. This would make it
necessary to drain it out and to bleed
the lines to avoid jamming the injec
tion pump and damaging the engine.
Diesel Fuel
(if equipped with DPF)
It is recommended to use the regu
lated automotive diesel fuel for diesel
vehicle equipped with the DPF sys
tem.
If you use diesel fuel including high
sulfur (more than 50 ppm sulfur) and
unspecified additives, it can cause
the DPF system to be damaged and
white smoke can be emitted.
Biodiesel
Commercially supplied Diesel blends
of no more than 7% biodiesel, com
monly known as "B7 Diesel" may be
used in your vehicle if Biodiesel
meets EN 14214 or equivalent spec
ifications. (EN stands for "European
Norm"). The use of biofuels exceed
ing 7% made from rapeseed methyl
ester (RME), fatty acid methyl ester
(FAME), vegetable oil methyl ester
(VME) etc. or mixing diesel exceed
ing 7% with biodiesel will cause
increased wear or damage to the
engine and fuel system. Repair or
replacement of worn or damaged
components due to the use of non
approved fuels will not be covered by
the manufactures warranty.
•Never use any fuel, whether
diesel, B7 biodiesel or otherwise,
that fails to meet the latest petrole
um industry specification.
•Never use any fuel additives or
treatments that are not recom
mended or approved by the vehi
cle manufacturer.
NOTICE
NOTICE
NOTICE

F19F19
Dimensions ..............................................................8-2
Engine ......................................................................8-2
Bulb wattage ...........................................................8-3
Tires and wheels ....................................................8-4
Recommended lubricants and capacities ...........8-5Recommended sae viscosity number ...........................8-7
Vehicle identification number (VIN) ....................8-8
Vehicle certification label .....................................8-8
Tire specification and pressure label .................8-9
Engine number .......................................................8-9
Air conditioner compressor label ......................8-10
8Specifications & consumer information

2-48
Safety system of your vehicle
In case of the Lefthand drive vehi
cle, the sensors and modules are in
the symmetrically opposite order.
The SRSCM continuously monitors
all SRS components while the igni
tion switch is ON to determine if a
crash impact is severe enough to
require air bag deployment or pre
tensioner seat belt deployment.
The SRS air bag warning light on the
instrument panel will illuminate for
about 6 seconds after the ignition
switch is turned to the ON position,
after which the air bag warning light
should go out.The air bag modules are located
both in the center of the steering
wheel and in the front passenger's
panel above the glove box. When the
SRSCM detects a sufficiently severe
impact to the front of the vehicle, it
will automatically deploy the front air
bags.
If any of the following conditions
occurs, this indicates a malfunc
tion of the SRS. We recommend
that the system be inspected by
an authorized HYUNDAI dealer.
•The light does not turn on briefly
when you turn the ignition ON.
•The light stays on after illuminat
ing for approximately 6 seconds.
•The light comes on while the
vehicle is in motion.
•The light blinks when the ignition
switch is in ON position.
WARNING
B240B01L
■
Driver’s front air bag (1)

2-50
Safety system of your vehicle
(Continued)
•When installing a container of
liquid air freshener inside the
vehicle, do not place it near the
instrument cluster nor on the
instrument panel surface.
It may become a dangerous pro
jectile and cause injury if the pas
senger's air bag inflates.
•If an air bag deploys, there may
be a loud noise followed by a fine
dust released in the vehicle.
These conditions are normal and
are not hazardous the air bags
are packed in this fine powder.
The dust generated during air
bag deployment may cause skin
or eye irritation as well as aggra
vate asthma for some persons.
Always wash all exposed skin
areas thoroughly with cold water
and a mild soap after an accident
in which the air bags were
deployed.
(Continued)
WARNING (Continued)
•The SRS can function only
when the ignition switch is in the
ON position.
•Before you replace a fuse or dis
connect a battery terminal, turn
the ignition switch to the LOCK
position and remove the ignition
key. Never remove or replace
the air bag related fuse(s) when
the ignition switch is in the ON
position. Failure to heed this
warning will cause the SRS air
bag warning light to illuminate.

2-54
Safety system of your vehicle
Side impact air bag
(if equipped)
The actual air bags in the vehicle may differ
from the illustration.
Your vehicle is equipped with a side
impact air bag in each front seat. The purpose of the air bag is to pro
vide the vehicle's driver and/or the
front passenger with additional pro
tection than that offered by the seat
belt alone.
The side impact air bags are
designed to deploy only during cer
tain sideimpact collisions, depend
ing on the crash severity, angle,
speed and point of impact. The side
impact air bags are not designed to
deploy in all side impact situations.
OGS035035
OGS035047
Do not allow the passengers to
lean their heads or bodies onto
doors, put their arms on the doors,
stretch their arms out of the win
dow, or place objects between the
doors and passengers when they
are seated on seats equipped with
side and/or curtain air bags.
WARNING
•The side impact air bag is sup
plemental to the driver's and the
passenger's seat belt systems
and is not a substitute for them.
Therefore your seat belts must
be worn at all times while the
vehicle is in motion. The air bags
deploy only in certain side
impact conditions severe
enough to cause significant
injury to the vehicle occupants.
•For best protection from the side
impact air bag system and to
avoid being injured by the
deploying side impact air bag,
both front seat occupants should
sit in an upright position with the
seat belt properly fastened. The
driver's hands should be placed
on the steering wheel at the 9:00
and 3:00 positions. The passen
ger's arms and hands should be
placed on their laps.
(Continued)
WARNING

2-57
Safety system of your vehicle
2
Why didn’t my air bag go off in a collision? (Inflation and noninflationconditions of the air bag)
There are many types of accidents in
which the air bag would not be
expected to provide additional pro
tection.
These include rear impacts, second
or third collisions in multiple impact
accidents, as well as low speed
impacts.
Air bag collision sensors
(1) SRS control module
(2) Front impact sensor(3) Side impact sensor
OGS035020/OGS035019/OGS035021/OGS035033

2-58
Safety system of your vehicle
Air bag inflation conditions
Front air bags are designed to inflate
in a frontal collision depending on
the severity, speed or angles of
impact of the front collision.
•Do not hit or allow any objects to
impact the locations where air
bags or sensors are installed.
This may cause unexpected air
bag deployment, which could
result in serious personal injury
or death.
•If the installation location or
angle of the sensors is altered in
any way, the air bags may
deploy when they should not or
they may not deploy when they
should, causing severe injury or
death.
Therefore, do not try to perform
maintenance on or around the air
bag sensors. We recommend that
the system be serviced by an
authorized HYUNDAI dealer.
(Continued)
WARNING (Continued)
•Problems may arise if the sen
sor installation angles are
changed due to the deformation
of the front bumper, body or B
pillar where side collision sen
sors are installed. We recom
mend that the system be serv
iced by an authorized HYUNDAI
dealer.
•Your vehicle has been designed to
absorb impact and deploy the air
bag(s) in certain collisions.
Installing aftermarket bumper
guards or replacing a bumper with
nongenuine parts may adversely
affect your vehicles collision and
air bag deployment performance.
OGS035027

2-59
Safety system of your vehicle
2
Side and curtain air bags
Side and cur tain air bags are
designed to inflate when an impact is
detected by side collision sensors
depending on the severity, speed or
angles of impact resulting from a
side impact collision. Although the driver’s and front pas
senger’s air bags are designed to
inflate in frontal collisions, they also
may inflate in other types of colli
sions if the front impact sensors
detect a sufficient impact. Side and
curtain air bags are designed to
inflate in side impact collisions, but
they may inflate in other collisions if
the side impact sensors detect a suf
ficient impact.
Also, the side and curtain air bags are
designed to inflate when a rollover is
detected by a rollover sensor. (if
equipped with rollover sensor)
If the vehicle chassis is impacted by
bumps or objects on unimproved
roads, the air bags may deploy. Drive
carefully on unimproved roads or on
surfaces not designed for vehicle traffic to prevent unintended air bag
deployment.
Air bag noninflation conditions
• In certain lowspeed collisions the air bags may not deploy. The air
bags are designed not to deploy in
such cases because they may not
provide benefits beyond the pro
tection of the seat belts in such col
lisions.
OGS035028
OGS035032
OTL035074