2016 Hyundai Creta tire pressure

7-53
7
Maintenance
Checking tire inflation pressure
Check your tires once a month or
more.
Also, check the tire pressure of the
spare tire.
How to check
Use a good quality gage to check tire
pressure. You can not tell if your tires
are properly inflated simply by look
ing at them. Radial tires may look
properly inflated even when they're
underinflated.
Check the tire's inflation pressure
when the tires are cold. "Cold"
means your vehicle has been sitting
for at least three hours or driven no
more than 1.6 km (1 mile).Remove the valve cap from the tire
valve stem. Press the tire gage firm
ly onto the valve to get a pressure
measurement. If the cold tire inflation
pressure matches the recommended
pressure on the tire and loading
information label, no further adjust
ment is necessary. If the pressure is
low, add air until you reach the rec
ommended amount.
If you overfill the tire, release air by
pushing on the metal stem in the
center of the tire valve. Recheck the
tire pressure with the tire gage. Be
sure to put the valve caps back on
the valve stems. They help prevent
leaks by keeping out dirt and mois
ture.
•Inspect your tires frequently for
proper inflation as well as wear
and damage. Always use a tire
pressure gauge.
•Tires with too much or too little
pressure wear unevenly causing
poor handling, loss of vehicle
control, and sudden tire failure
leading to accidents, injuries,
and even death. The recom
mended cold tire pressure for
your vehicle can be found in this
manual and on the tire label
located on the driver's side cen
ter pillar.
•Worn tires can cause accidents.
Replace tires that are worn,
show uneven wear, or are dam
aged.
•Remember to check the pres
sure of your spare tire.
HYUNDAI recommends that you
check the spare every time you
check the pressure of the other
tires on your vehicle.
WARNING

7-54
Maintenance
Tire rotation
To equalize tread wear, it is recom
mended that the tires be rotated
every 12,000 km (7,500 miles) or
sooner if irregular wear develops.
During rotation, check the tires for
correct balance.
When rotating tires, check for uneven
wear and damage. Abnormal wear is
usually caused by incorrect tire pres
sure, improper wheel alignment, out
ofbalance wheels, severe braking or
severe cornering. Look for bumps or
bulges in the tread or side of tire.
Replace the tire if you find either of
these conditions. Replace the tire if
fabric or cord is visible. After rotation,
be sure to bring the front and rear tire
pressures to specification and check
lug nut tightness.
Refer to “Tire and wheels” in chapter
8.Disc brake pads should be inspected
for wear whenever tires are rotated.
Information
Rotate radial tires that have an asym
metric tread pattern only from front
to rear and not from right to left.i
CBGQ0706
CBGQ0707
CBGQ0707A
Without a spare tire
With a fullsize spare tire (if equipped)
Directional tires (if equipped)
•Do not use the compact spare
tire for tire rotation.
•Do not mix bias ply and radial
ply tires under any circum
stances. This may cause unusu
al handling characteristics that
could result in death, severe
injury, or property damage.
WARNING

7-56
Maintenance
Wheel replacement
When replacing the metal wheels for
any reason, make sure the new
wheels are equivalent to the original
factory units in diameter, rim width
and offset.
Replacing tires
To reduce the chance or serious
or fatal injuries from an accident
caused by tire failure or loss of
vehicle control:
•Replace tires that are worn,
show uneven wear, or are dam
aged. Worn tires can cause loss
of braking effectiveness, steer
ing control, and traction.
•Do not drive your vehicle with
too little or too much pressure in
your tires. This can lead to
uneven wear and tire failure.
•When replacing tires, never mix
radial and biasply tires on the
same car. You must replace all
tires (including the spare) if mov
ing from radial to biasply tires.
(Continued)
(Continued)
WARNING •Using tires and wheel other than
the recommended sizes could
cause unusual handling charac
teristics and poor vehicle con
trol, resulting in a serious acci
dent.
•Wheels that do not meet
HYUNDAI's specifications may
fit poorly and result in damage to
the vehicle or unusual handling
and poor vehicle control.
•The ABS works by comparing
the speed of the wheels. Tire
size can affect wheel speed.
When replacing tires, all 4 tires
must use the same size original
ly supplied with the vehicle.
Using tires of a different size can
cause the ABS (Antilock Brake
System) and ESC (Electronic
Stability Control) to work irregu
larly. (if equipped)
A wheel that is not the correct size
may adversely affect wheel and
bearing life, braking and stopping
abilities, handling characteristics,
ground clearance, bodytotire
clearance, snow chain clearance,
speedometer and odometer cali
bration, headlight aim and bumper
height.
WARNING

7-59
7
Maintenance
4. Tire ply composition and materi
al
The number of layers or plies of rub
bercoated fabric in the tire. Tire
manufacturers also must indicate the
materials in the tire, which include
steel, nylon, polyester, and others.
The letter "R" means radial ply con
struction; the letter "D" means diago
nal or bias ply construction; and the
letter "B" means beltedbias ply con
struction.
5. Maximum permissible inflation
pressure
This number is the greatest amount
of air pressure that should be put in
the tire. Do not exceed the maximum
permissible inflation pressure. Refer
to the Tire and Loading Information
label for recommended inflation
pressure.
6. Maximum load rating
This number indicates the maximum
load in kilograms and pounds that
can be carried by the tire. When
replacing the tires on the vehicle,
always use a tire that has the same
load rating as the factory installed
tire.
7. Uniform tire quality grading
Quality grades can be found where
applicable on the tire sidewall
between tread shoulder and maxi
mum chapter width.
For example:
TREAD wear 200
TRACTION AA
TEMPERATURE A
Tire age
Tires degrade over time, even
when they are not being used.
Regardless of the remaining
tread, it is recommended that tires
generally be replaced after six (6)
years of normal service. Heat
caused by hot climates or frequent
high loading conditions can accel
erate the aging process. Failure
to follow this warning could cause
sudden tire failure, which could
lead to a loss of control and an
accident involving serious injury or
death.
WARNING

8
Specifications & Consumer information
8
Specifications & Consumer information
8
Dimensions ..............................................................8-2
Engine ......................................................................8-2
Bulb wattage ...........................................................8-3
Tires and wheels ....................................................8-4
Recommended lubricants and capacities ...........8-5Recommended sae viscosity number ...........................8-7
Vehicle identification number (VIN) ....................8-8
Vehicle certification label .....................................8-8
Tire specification and pressure label .................8-9
Engine number .......................................................8-9
Air conditioner compressor label ......................8-10

8-4
Specifications & Consumer information
tIrES aND whEElS
When replacing tires, use the same size originally supplied with the vehicle.
Using tires of a different size can damage the related parts or make it work irregularly.
CAUTION
*1
: Normal load : Up to 3 persons
ItemTire sizeWheel size
Inflation pressure bar (psi)Wheel lug nut
torque
kgf•m (lbf•ft, N•m)
Normal load *1Maximum load
FrontRearFront Rear
Full size tire 205/65R16 6.0J X 16
230 (33) 230 (33) 250 (36) 250 (36) 9~11
(65~79, 88~107)
215/60R17 6.5J X 17
•It is permissible to add 3 psi to the standard tire pressure specification if colder temperatures are expected soon.
Tires typically loose 1 psi (7 kPa) for every 7°C temperature drop. If extreme temperature variations are expected,
recheck your tire pressure as necessary to keep them properly inflated.
•An air pressure generally decreases, as you drive up to a highaltitude area above sea level. Thus, if you plan to
drive a highaltitude area, check the tire pressures in advance. If necessary, inflate them to a proper level. (Air infla
tion per altitude : +10 kPa/1 km)
NOTICE

The tires supplied on your new vehi
cle are chosen to provide the best
performance for normal driving.
The tire label located on the driver's
side (or front passenger’s side) cen
ter pillar gives the tire pressures rec
ommended for your car. The engine number is stamped on
the engine block as shown in the
drawing.
8-98
Specifications & Consumer information
tIrE SpECIfICatIoN aND
prESSurE labEl
OGS085004
OGS085009L
■Right Hand Drive
■Left Hand Drive
■ Gamma 1.6 MPI
■U2 1.4 TCIOGS085008/OGS085007/OGS085001
■U2 1.6 TCI
ENGINE NumbEr