2016 Hyundai Creta engine

7-50
Maintenance
Reset items
Items should be reset after the bat
tery has been discharged or the bat
tery has been disconnected.
• Auto up/down window (See chapter 3)
• Climate control system (See chapter 3)
• Audio (See chapter 3)
• Clock (See chapter3)
• Trip computer (See chapter 3)
When recharging the battery,
observe the following precautions:
•Before performing maintenance or
recharging the battery, turn off all
accessories and stop the engine.
•Do not allow cigarettes, sparks, or
flame near the battery.
•Wear eye protection when
checking the battery during
charging.
•The battery must be removed
from the vehicle and placed in
an area with good ventilation.
•Watch the battery during charg
ing, and stop or reduce the
charging rate if the battery cells
begin gassing (boiling) violently
or if the temperature of the elec
trolyte of any cell exceeds 49°C
(120°F).
(Continued)
WARNING (Continued)
•The negative battery cable must
be removed first and installed
last when the battery is discon
nected.
•Disconnect the battery charger in
the following order.
1. Turn off the battery charger
main switch.
2. Unhook the negative clamp
from the negative battery ter
minal.
3. Unhook the positive clamp
from the positive battery ter
minal.

7-63
7
Maintenance
FuSES
A vehicle’s electrical system is pro
tected from electrical overload dam
age by fuses.
This vehicle has 2 fuse panels, one
located in the driver’s side panel bol
ster, the other in the engine compart
ment near the battery.
If any of your vehicle’s lights, acces
sories, or controls do not work, check
the appropriate circuit fuse. If a fuse
has blown, the element inside the
fuse will be melted.
If the electrical system does not
work, first check the driver’s side
fuse panel.
Before replacing a blown fuse, dis
connect the negative battery cable.
Always replace a blown fuse with
one of the same rating.
If the replacement fuse blows, this
indicates an electrical problem. Avoid
using the system involved and imme
diately consult an authorized
HYUNDAI dealer.
Three kinds of fuses are used: blade
type for lower amperage rating, SlowBlow type and multi fuse for higheramperage ratings.
Do not use a screwdriver or any
other metal object to remove fuses
because it may cause a short circuit
and damage the system.
Information
The actual fuse/relay panel label may
differ from equipped items. i
NOTICE
OTA070039
Normal
Normal
■ Slow Blow type
■ Multi fuse
BBlloowwnn
Normal
■
Blade type
BBlloowwnn
BBlloowwnn
Fuse replacement
•Never replace a fuse with any
thing but another fuse of the
same rating.
•A higher capacity fuse could
cause damage and possibly a
fire.
•Never install a wire or aluminum
foil instead of the proper fuse
even as a temporary repair. It
may cause extensive wiring
damage and a possible fire.
WARNING

7-65
7
Maintenance
3. Pull the suspected fuse straight
out. Use the fuse puller provided in
the engine compar tment fusepanel.
4. Check the removed fuse; replace it if it is blown.
5. Push in a new fuse of the same rating, and make sure it fits tightly
in the clips.
If it fits loosely, we recommend that
you consult an authorized HYUNDAI
dealer.
If you do not have a spare, use a fuse of the same rating from a circuityou may not need for operating thevehicle, such as the cigarette lighterfuse.
If the electrical components do not
work and the fuses are OK, check
the fuse panel in the engine com
partment. If a fuse is blown, it must
be replaced. Fuse switch
Always, put the fuse switch at the ON position.
If you move the switch to the OFF
position, some items such as audio
and digital clock must be reset and
transmitter (or smart key and burglar
alarm) may not work properly.
Always place the fuse switch in the
ON position while driving the vehicle.
NOTICE
OGS075064
OGS075018

7-66
Maintenance
Information
If the fuse switch is OFF, the above
message will appear on instrument
cluster display.Engine compartment panel fuse
replacement
1. Turn the ignition switch and all other switches off.
2. Remove the fuse box cover by pressing the tab and pulling up the
cover.
3. Check the removed fuse; replace it if it is blown. To remove or insert
the fuse, use the fuse puller in the
engine compartment fuse panel.
4. Push in a new fuse of the same rating, and make sure it fits tightly
in the clips. If it fits loosely, we rec
ommend that you consult an
authorized HYUNDAI dealer.
After checking the fuse panel in the
engine compartment, securely install
the fuse panel cover. If not, electrical
failures may occur from water leak
ing in.
iNOTICE
OGS075019
OGS045120

7-72
Maintenance
ITEMNameSymbolFuse RatingCircuit Protected
FUSE
POWER
OUTLET POWER
OUTLET
R R20APower Outlet Rear
STARTSTART10APCU/ECU, Inhibitor Switch, Clutch Pedal Assy,Start Relay, Start Inhibitor Relay
SENSORS10AD4FC, D4FB : Fuel HTR Relay, Fuel Water Sensor
ENGE10AAirflow Sensor(D4FB), Smart key Control Module, ECU/PCU(G4FC,D4FC,D4FB)
ABS10AABS/ ESC Control Module, Rheostat & ESC Switch, Engine Room Diagnosis Connector
AIRBAG 10AAirbag Control Unit
CLUSTERCLUSTER10AInstrument Cluster
* G4FC : Gamma 1.6 (Gasoline), D4FC : UII 1.4 (Diesel), D4FB : UII 1.6 (Diesel)

7-73
7
Maintenance
Engine compartment fuse panel
Inside the fuse/relay panel covers, you
can find the fuse/relay label describing
fuse/relay name and capacity.
Information
Not all fuse panel descriptions in this
manual may be applicable to your
vehicle. It is accurate at the time of printing. When you inspect the fuse
panel in your vehicle, refer to the fuse
panel labeli
OGS075017
OGS075024
■Gasoline Engine

7-74
Maintenance
OGS075025
■Diesel Engine

7-75
7
Maintenance
Engine Compartment Fuse Panel
ItemNameSymbolFuse RatingCircuit Protected
MULTIFUSEMDPS80AMDPS(Motor Power Steering)
ALTALT125A/150AG4FC (125A): Alternator, Battery, All Fuses connected to Alternator fuse
D4FC/D4FB (150A): Alternator, Battery, All Fuses connected to Alternator fuse
FUSE
ECU 2E210A/15AG4FC(10A): ECU (M/T), PCU(A/T)
D4FC(15A): CAM SNSR, Glow RLY, WGT,EGR Control Valve, Air Flow SNSR, IMMO
D4FB (15A): CAM SNSR, VGT Vacuum, IMMO
HEAD LAMPHIGH BEAM10AHead Lamp High Solenoid Relay (BiFunctional Type)
ABS 240AABS / ESC Control Module
ECU 4E425A/15AG4FC(25A): ECU (M/T), PCU(A/T)
D4FC(15A): Inlet Meter Valve,
D4FB(15A): Glow Plug Relay, Fuel Meter Unit
TCU 1625AD4FB: TCU(A/T)
B+540AInstrument Panel Fuse Block Fuse: FS01
ABS 140AABS / ESC Control Module, Engine Room Diagnosis
B+450AInstrument Panel Fuse Block Fuse: FS06, IPS1, IPS2, IPS3
* G4FC : Gamma 1.6 (Gasoline), D4FC : UII 1.4 (Diesel), D4FB : UII 1.6 (Diesel)