2016 Hyundai Creta tow

3-34
Convenient features of your vehicle
Electrochromic mirror (ECM)
(if equipped)
The electric rearview mirror automati
cally controls the glare from the head
lights of the car behind you in night
time or low light driving conditions.
When the engine is running, the
glare is automatically controlled by
the sensor mounted in the rearview
mirror. The sensor detects the light
level around the vehicle, and auto
matically adjusts to control the head
light glare from vehicles behind you.
Whenever the shift lever is placed in
R (Reverse), the mirror will automat
ically go to the brightest setting in
order to improve the drivers view
behind the vehicle.
T o o p e r a t e t h e e l e c t r i c r e a r v i e w
m i r r o r :
• Press the ON/OFF button (1) to turn the automatic dimming func
tion off. The mirror indicator light
will turn off.
Press the ON/OFF button (1) to
turn the automatic dimming func
tion on. The mirror indicator light
will illuminate.
• The mirror defaults to the ON posi tion whenever the ignition switch is
turned on.
When cleaning the mirror, use a
paper towel or similar material damp
ened with glass cleaner. Do not
spray glass cleaner directly on the
mirror as that may cause the liquid
cleaner to enter the mirror housing.
NOTICE
OCF043025
Indicator
Sensor

3-36
Convenient features of your vehicle
E l e c t r i c t y p e ( i f e q u i p p e d )
Adjusting the rearview mirrors:
Move the lever (1) to the L (Left) or R
(Right) to select the rearview mirror
you would like to adjust.
Use the mirror adjustment control (2)
to position the selected mirror up,
down, left or right.
After adjustment, move the lever (1)
to the middle to prevent inadvertentadjustment.
•The mirrors stop moving when
they reach the maximum adjusting
angles, but the motor continues to
operate while the switch is
pressed. Do not press the switch
longer than necessary, the motor
may be damaged.
•Do not attempt to adjust the out
side rearview mirror by hand or the
motor may be damaged.
Folding the outside rearview mir
ror
M a n u a l t y p e
To fold the outside rearview mirror,
grasp the housing of the mirror and
then fold it toward the rear of the
vehicle.
NOTICE
OGC044024
OGS045151L

3-41
Convenient features of your vehicle
3
Engine Coolant Temperature
Gauge
This gauge shows the temperature
of the engine coolant when the igni
tion switch is in the ON position.
If the gauge pointer moves beyond
the normal range area toward the “H
or 130” position, it indicates over
heating that may damage the
engine.
Do not continue driving with an over
heated engine. If your vehicle over
heats, refer to “If the Engine
Overheats” in chapter 6.
NOTICE
Never remove the radiator cap and
reservoir cap when the engine is
hot. The engine coolant is under
pressure and could cause severe
burns. Wait until the engine is cool
before adding coolant to the reser
voir.
WARNING
OGC044145/OGS045147
■Type A
■Type BOGC044144/OGS045144

3-75
Convenient features of your vehicle
High beam operation
To turn on the high beam headlamp,
push the lever away from you. The
lever will return to its original position.
The high beam indicator will light
when the headlamp high beams are
switched on.
To turn off the high beam headlamp,
pull the lever towards you. The low
beams will turn on. To flash the high beam headlights,
pull the lever towards you, then
release the lever. The high beams
will remain ON as long as you hold
the lever towards you.
Rear fog light (if equipped)
Vehicle with front fog light
To turn on the rear fog light:
Position the light switch in the park
ing light position, turn the light switch
(1) to the front fog light position, and
then turn the light switch (1) to the
rear fog light position.
To turn the rear fog lights off, do one
of the following:
• Turn off the parking light switch.
• Turn the light switch to the rear fog light position again.
• When the light switch is in the parking light position, if you turn off
the front fog light, the rear fog light
will also turn off.
OGS045060L
Do not use high beam when there
are other vehicles approaching you.
Using high beam could obstruct the
other driver's vision.
WARNING
OGS045061L
OGS045062L

3-82
Convenient features of your vehicle
3
Windshield wipers
Operates as follows when the igni
tion switch is in the ON position.
MIST : For a single wiping cycle,move the lever to or MIST
position and release. The
wipers will operate continu
ously if the lever is held in thisposition.
OFF : Wiper is not in operation.
INT : Wiper operates intermittently at the same wiping intervals. To
vary the speed setting, move
the speed control lever.
Information
If there is heavy accumulation of snow
or ice on the windshield, defrost the
windshield for about 10 minutes, or
until the snow and/or ice is removed
before using the windshield wipers to
ensure proper operation.
If you do not remove the snow and/or
ice before using the wiper and washer,
it may damage the Wiper and washersystem.
Windshield washers
(if equipped)
In the OFF position, pull the lever
gently toward you to spray washer
fluid on the windshield and to run the
wipers 13 cycles. Use this function
when the windshield is dirty. The
spray and wiper operation will contin
ue until you release the lever. If the washer does not work, check
the washer fluid level. If the fluid level
is not sufficient, you will need to add
appropriate nonabrasive windshield
washer fluid to the washer reservoir.
The reservoir filler neck is located in
the front of the engine compartment
on the passenger side.
i
When the outside temperature is
below freezing, ALWAYS warm the
windshield using the defroster to
prevent the washer fluid from freez
ing on the windshield and obscur
ing your vision which could result in
an accident and serious injury or
death.
WARNING
OGS045071L
OGS045072L


Type A

Type B

3-91
Convenient features of your vehicle
Mode selection
The mode selection knob controls
the direction of the air flow through
the ventilation system.
Air can be directed to the floor, dash
board outlets, or windshield. Fivesymbols are used to represent Face,
BiLevel, Floor, FloorDefrost and Defrost air position.
FaceLevel (B, D, E)
Air flow is directed toward the upper
body and face. Additionally, each
outlet can be controlled to direct the
air discharged from the outlet.
BiLevel (B, D, C, E)
Air flow is directed towards the face
and the floor.
FloorLevel (A, C, D)
Most of the air flow is directed to the
floor, with a small amount of the air
being directed to the windshield, side
window defrosters and side vents.
Floor/DefrostLevel (A, C, D)
Most of the air flow is directed to the
floor and the windshield with a small
amount directed to the side window
defrosters and side vents.
DefrostLevel (A, D)
Most of the air flow is directed to the
windshield with a small amount of air
directed to the side vents. (a/c &
fresh mode automatically on)OGC044116

3-102
Convenient features of your vehicle
3
Floor & Defrost (A, C, D)
Most of the air flow is directed to the
floor and the windshield with a small
amount directed to the side window
defrosters and side vents.
FloorLevel (C, D)
Most of the air flow is directed to the
floor, with a small amount of the air
being directed to the windshield, side
window defrosters, and side vents.
BiLevel (B, C, D, E)
Air flow is directed towards the face
and the floor.
FaceLevel (B, D, E)
Air flow is directed toward the upper
body and face. Additionally, each
outlet can be controlled to direct the
air discharged from the outlet.
Max defrost level
Most of the air flow is directed to the
windshield with a small amount of air
directed to the side window defrosters.
(a/c & fresh mode automatically on)
OGS045088L

Auto defogging system
(only for automatic climate
control system, if equipped)
Auto defogging reduces the possibility
of fogging up the inside of the wind
shield by automatically sensing the
moisture of inside the windshield.
The auto defogging system operates
when the heater or air conditioning is
on.
Information
The auto defogging system may not
operate normally, when the outside
temperature is below 10 °C. When the Auto Defogging
System operates, the indi
cator will illuminate.
If higher level of moisture are sensed
in the vehicle, the Auto Defogging
System will operate in the following
order:
Step 1 : Outside air position
Step 2 : Operating the air conditioning
Step 3 : Blowing air toward the wind shield
Step 4 : Increasing air flow toward the windshield
If the air conditioning is off or recircu
lated air position is manually selected
while Auto Defogging System is ON,
the Auto Defogging System Indicator
will blink 3 times to signal that the
manual operation has been canceled.
To cancel or reset the Auto Defogging
System
Press the front windshield defroster
button for 3 seconds when the ignition
switch is in the ON position. When the
Auto Defogging System is canceled,
ADS OFF symbol will blink 3 times
and the ADS OFF will be displayed on
the climate control information screen.
When the Auto Defogging System is
reset, ADS OFF symbol will blink 6
times without a signal.
Information
• When the air conditioning is turned on by Auto defogging system, if you
try to turn off the air conditioning, the
indicator will blink 3 times and the air
conditioning will not be turned off.
• For efficiency, do not select recircu lated air position while Auto defog
ging system is operating.
Do not remove the sensor cover
located on the upper end of the driv
er side windshield glass.
Damage to system parts could occur
and may not be covered by your
vehicle warranty.
i
i
NOTICE
3-112
Convenient features of your vehicle
3
OGS045095L