2016 Hyundai Creta WINDSHIELD

3-83
Convenient features of your vehicle
•To prevent possible damage to the
washer pump, do not operate the
washer when the fluid reservoir is
empty.
•To prevent possible damage to the
wipers or windshield, do not oper
ate the wipers when the windshield
is dry.
•To prevent damage to the wiper
arms and other components, do
not attempt to move the wipers
manually.
•To prevent possible damage to the
wipers and washer system, use anti
freezing washer fluids in the winter
season or cold weather.
Rear window wiper and washer
switch (if equipped)
The rear window wiper and washer
switch is located at the end of the
wiper and washer switch lever. Turn
the switch to the desired position to
operate the rear wiper and washer.
HI – High wiper speed
LO – Low wiper speed
OFF – OffPush the lever away from you to
spray rear washer fluid and to run the
rear wipers 1~3 cycles. The spray
and wiper operation will continue until
you release the lever. (if equipped)
NOTICE
OGS045073L
OGS045074L


Type A

Type B
OGS045075L
OGS045076L

Type A

Type B

3-88
Convenient features of your vehicle
3
Defroster
To prevent damage to the conduc
tors bonded to the inside surface of
the rear window, never use sharp
instruments or window cleaners con
taining abrasives to clean the win
dow.
If you want to defrost and defog the
front windshield, refer to “Windshield
defrosting and defogging” in this sec
tion.
Rear window defroster
(if equipped)
In case of the Righthand drive vehicle,the switches are in the symmetrically
opposite order. The defroster heats the window to
remove frost, fog and thin ice from
the interior and exterior of the rear
window, while engine is running.
To activate the rear window defroster,
press the rear window defroster but
ton located in the climate control sys
tem. The indicator on the rear window
defroster button illuminates when the
defroster is ON.
To turn off the defroster, press the
rear window defroster button again.
Information
• If there is heavy accumulation of snow on the rear window, brush it
off before operating the rear
defroster.
• The rear window defroster automat ically turns off after approximately
20 minutes or when the ignition
switch is turned off.
Outside rearview mirror defroster
(if equipped)
If your vehicle is equipped with out
side rearview mirror defrosters, they
will operate at the same time you
turn on the rear window defroster.
i
NOTICE
CLiMAtE CoNtRoL SYStEM

Manual Climate Control System
OGS045079L

Automatic Climate Control SystemOGS045078L
• Type A
• Type BOGS045077L

3-91
Convenient features of your vehicle
Mode selection
The mode selection knob controls
the direction of the air flow through
the ventilation system.
Air can be directed to the floor, dash
board outlets, or windshield. Fivesymbols are used to represent Face,
BiLevel, Floor, FloorDefrost and Defrost air position.
FaceLevel (B, D, E)
Air flow is directed toward the upper
body and face. Additionally, each
outlet can be controlled to direct the
air discharged from the outlet.
BiLevel (B, D, C, E)
Air flow is directed towards the face
and the floor.
FloorLevel (A, C, D)
Most of the air flow is directed to the
floor, with a small amount of the air
being directed to the windshield, side
window defrosters and side vents.
Floor/DefrostLevel (A, C, D)
Most of the air flow is directed to the
floor and the windshield with a small
amount directed to the side window
defrosters and side vents.
DefrostLevel (A, D)
Most of the air flow is directed to the
windshield with a small amount of air
directed to the side vents. (a/c &
fresh mode automatically on)OGC044116

3-93
Convenient features of your vehicle
Recirculated air position
With the recirculated air
position selected, air from
the passenger compart
ment will be drawn
through the heating sys
tem and heated or cooled
according to the functionselected.
Outside (fresh) air position
With the outside (fresh)
air position selected, air
enters the vehicle from
outside and is heated or
cooled according to the
function selected.
Information
It should be noted that prolonged
operation of the heater in the recircu
lated air position (without air condi
tioning selected) will cause fogging of
the windshield and side windows and
the air within the passenger compart
ment will become stale.
In addition, prolonged use of the air
conditioning with the recirculated air
position selected will result in exces
sively dry air in the passenger compartment. i
•Continuous operation of the cli
mate control system in the recir
culated air position may allow
humidity to increase inside the
vehicle which may fog the glass
and obscure visibility.
•Do not sleep in a vehicle with air
conditioning or heating system
on. It may cause serious harm
or death due to a drop in the
oxygen level and/or body tem
perature.
•Continuous operation of the cli
mate control system in the recir
culated air position can cause
drowsiness or sleepiness, and
loss of vehicle control. Set the
air intake control to the outside
(fresh) air position as much as
possible while driving.
WARNING

3-94
Convenient features of your vehicle
3
Fan speed control
Turn the knob to the right to increase
the fan speed and airflow. Turn the
knob to the left to decrease fanspeed and airflow.
Air conditioning (A/C)
(if equipped)
Press the A/C button to turn the air
conditioning system on (indicator
light will illuminate). Press the button
again to turn the air conditioning sys
tem off.
System operation
Ventilation
1. Select the Face Level mode.
2. Set the air intake control to the outside (fresh) air position.
3. Set the temperature control to the desired position.
4. Set the fan speed control to the desired speed.
Heating
1. Select the Floor Level mode.
2. Set the air intake control to theoutside (fresh) air position.
3. Set the temperature control to the desired position.
4. Set the fan speed control to the desired speed.
5. If dehumidified heating is desired, turn the air conditioning system (if
equipped) on.
If the windshield fogs up, select the
Floor & Defrost mode or select
the Front Defroster mode.OGC044205
OGS045085L

3-95
Convenient features of your vehicle
Operation Tips
• To keep dust or unpleasant fumesfrom entering the car through the
ventilation system, temporarily set
the air intake control to the recircu
lated air position. Return the con
trol to the fresh air position when
the irritation has passed. This will
help keep the driver alert and com
fortable.
• To prevent inside of the windshield from fogging, set the air intake con
trol to the fresh air position and fan
speed to the desired position, turn
on the air conditioning system, and
adjust the temperature control to
desired temperature.Air conditioning (if equipped)
HYUNDAI Air Conditioning Systems
are filled with environmentally friendly
refrigerant.
1. Start the engine.
2. Push the air conditioning button.
3. Set the mode to the Face Level mode.
4. Set the air intake control to the recirculated air position. However,
prolonged operation of the recircu
lated air position will excessively
dry the air. In this case, change the
air position.
5. Adjust the fan speed control and temperature control to maintainmaximum comfort.
When maximum cooling is desired,
set the temperature control to the
extreme left position then set the fan
speed control to the highest speed.When using the air conditioning sys
tem, monitor the temperature gauge
closely while driving up hills or in
heavy traffic when outside tempera
tures are high. Air conditioning sys
tem operation may cause engine
overheating. Continue to use the
blower fan but turn the air condition
ing system off if the engine tempera
ture gauge indicates engine over
heating.
NOTICE

3-96
Convenient features of your vehicle
3
Air conditioning system operation
tips
•If the vehicle has been parked in
direct sunlight during hot weather,
open the windows for a short time
to let the hot air inside the vehicle
escape.
• After sufficient cooling has been achieved, switch back from the
recirculated air to the fresh outside
air position.
• To help reduce moisture inside of the windows on rainy or humid
days, decrease the humidity inside
the vehicle by operating the air
conditioning system with the win
dows closed.
• Use the air conditioning system every month only for a few minutes
to ensure maximum system per
formance. • If you operate air conditioner
excessively, the difference between
the temperature of the outside air
and that of the windshield could
cause the outer surface of the
windshield to fog up, causing loss
of visibility. In this case, set the
mode selection knob or button to
the position and fan speed
control to the lower speed.
System maintenance
Climate control air filter
This filter is installed behind the glove
box. It filters the dust or other pollu
tants that enter the vehicle through the
heating and air conditioning system.
We recommend the climate control air
filter be replaced by an authorized
HYUNDAI dealer according to the
maintenance schedule. If the car is
being driven in severe conditions
such as dusty or rough roads, more
frequent air conditioner filter inspec
tions and changes are required.
1LDA5047
Outside air
Recirculatedair
Climate control air filter Blower
Evaporatorcore Heater core

3-98
Convenient features of your vehicle
3
Automatic climate control system (if equipped)
OGS045086L
1. Temperature control konb
2. Fan speed control knob
3. AUTO (automatic control) button
4. A/C (Air conditioning) button
5. OFF button
6. Front windshield defroster button
7. Rear window defroster button
8. Air intake control button
9. Mode selection button
10. LCD display
11. Color changing mood lighting
In case of the Righthand drive vehicle,
the switches are in the symmetrically
opposite order.