2016 HONDA CR-Z engine oil

311
uuMaintenance Under the Hood uAdding Engine Oil
Maintenance
Adding Engine Oil
1. Unscrew and remove the engine oil fill cap.
2. Add oil slowly.
3. Reinstall the engine oil fill cap, and tighten
it securely.
4. Wait for three minutes and recheck the
engine oil dipstick.1Adding Engine Oil
If any oil spills, wipe it up immediately. Spilled oil may
damage the engine compartment components.
NOTICE
Do not fill the engine oil above the upper mark.
Overfilling the engine oil can result in leaks and
engine damage.Engine Oil
Fill Cap
16 CR-Z-31SZT6500.book 311 ページ ２０１５年９月１１日　金曜日　午前１１時４７分

312
uuMaintenance Under the Hood uChanging the Engine Oil and Oil Filter
Maintenance
Changing the Engine Oil and Oil Filter
You must change the engine oil and oil filter regularly in order to maintain the
engine's lubrication. The engine may be damaged if they are not changed regularly.
Change the oil and filter in accordance with the maintenance message on the multi-
information display. 1.Remove the engine under cover.
2. Run the engine until it reaches normal
operating temperature, and then turn the
engine off.
3. Open the hood and remove the engine oil
fill cap.
4. Remove the bolts and clips on the
undercarriage and remove the cover.
5. Remove the drain bolt and washer from
the bottom of the engine, and drain the
oil into a suitable container.1Changing the Engine Oil and Oil Filter
NOTICE
You may damage the environment if you do not
dispose of the oil in a suitable way. If you are
changing the oil by yourself , appropriately dispose of
the used oil. Put the oil in a sealed container and take
it to a recycling center. Do not throw the oil away
into a garbage can or onto the ground.
Under
Cover
Bolt Clip
Drain Bolt
Washer
16 CR-Z-31SZT6500.book 312 ページ ２０１５年９月１１日　金曜日　午前１１時４７分

313
uuMaintenance Under the Hood uChanging the Engine Oil and Oil Filter
Maintenance
6. Remove the oil filter and dispose of the
remaining oil.
7. Check that the filter gasket is not stuck to
the engine contact surface.
u If it is stuck, you must detach it.
8. Wipe away dirt and dust adhering to the
contact surface of the engine block, and
install a new oil filter.
u Apply a light coat of new engine oil to
the oil filter gasket.
9. Put a new washer on the drain bolt, then
reinstall the drain bolt.
u Tightening torque:
29 lbf∙ft (39 N∙m, 4.0 kgf∙m)
10. Pour the recommended engine oil into the
engine.
u Engine oil change capacity (including
filter):
3.8 US qt (3.6 L)
11. Reinstall the engine oil fill cap securely and
start the engine.
12. Run the engine for a few minutes, and
then check that there is no leak from the
drain bolt or oil filter.
13. Stop the engine, wait for three minutes,
and then check the oil level on the
dipstick.
u If necessary, add more engine oil.1Changing the Engine Oil and Oil Filter
You will need a special wrench to replace the oil
filter. You can buy this wrench from a dealer.
When installing the new oil filter, follow the
instructions supplied with the oil filter.
Reinstall the engine oil fill cap. Start the engine. The
low oil pressure indicator should go off within five
seconds. If it does not, turn off the engine, and check
your work.
Oil Filter
16 CR-Z-31SZT6500.book 313 ページ ２０１５年９月１１日　金曜日　午前１１時４７分

317
uuMaintenance Under the Hood uTransmission Fluid
Maintenance
Check the fluid level when the engine is at normal operating temperature.
1. Park the vehicle on level ground.
2. Remove the bolts with a wrench and clips
with a flat-tip screwdri ver, then carefully
remove the under cover.
3. Remove the transmission filler bolt and
washer.
Carefully feel inside the bolt hole with your
fingers.
u Check if the fluid leve l is up to the edge
of the bolt hole.
4. If the fluid level is not up to the edge of the
bolt hole, add Honda Manual Transmission
Fluid (MTF) until it runs out of the hole.
5. Put a new washer on the filler bolt, then
reinstall the filler bolt.
u Tightening torque:
33 lbf∙ft (44 N∙m, 4.5 kgf∙m)
6. Reinstall the under cove r with the bolts and
clips.
■Manual Transmission Fluid
Specified fluid: Honda Manual Transmission Fluid (MTF)
1Manual Transmission Fluid
If Honda MTF is not availa ble, you may use the API
certificated SAE 0 W-20 or 5 W-20 viscosity motor oil
as a temporary measure.
Replace with MTF as soon as possible. Motor oil does
not contain the proper addi tives for the transmission
and continued use can cause decreased shifting
performance and lead to transmission damage.
Under CoverBolt Clip
16 CR-Z-31SZT6500.book 317 ページ ２０１５年９月１１日　金曜日　午前１１時４７分

Continued347
uuCleaning uExterior Care
Maintenance
A good coat of automotive body wax helps protect your vehicle’s paint from the
elements. Wax will wear off over time and expose your vehicle’s paint to the
elements, so reapply as necessary.
If you get gasoline, oil, engine coolant, or battery fluid on resin coated parts, they
may be stained or the coating may peel. Prom ptly wipe it away using a soft cloth and
clean water.
Wipe using a glass cleaner.
Aluminum is susceptible to deterioration caused by salt and other road
contaminants. Use a sponge and mild detergent to wipe away promptly.
Be careful not to use harsh chemicals (inc luding some commercial wheel cleaners) or
a stiff brush. They can damage the clear coat of the aluminum alloy wheels that
helps keep the aluminum from corroding and tarnishing.
■Applying Wax
■Maintaining the Bumpers and Other Resin Coated Parts
■Cleaning the Window
■Maintaining Aluminum Wheels
1Applying Wax
NOTICE
Chemical solvents and strong cleaners can damage
the paint, metal, and plasti c on your vehicle. Wipe up
spills immediately.
1 Maintaining the Bumpers an d Other Resin Coated Parts
Ask a dealer about the correct coating material when
you want to repair the pa inted surface of the parts
made of resin.
16 CR-Z-31SZT6500.book 347 ページ ２０１５年９月１１日　金曜日　午前１１時４７分

349
Handling the Unexpected
This chapter explains how to handle unexpected troubles.
ToolsTypes of Tools .................................. 350
If a Tire Goes Flat Temporarily Repairi ng a Flat Tire....... 351
Engine Does Not Start Checking the Engine ........................ 362
If the Smart Entry Remote Battery is Weak .......................................... 364
Emergency Engine Stop ................... 365
Jump Starting .................................... 366
Shift Lever Does Not Move .............. 369Overheating
How to Handle Overheating............. 370
Indicator, Coming On/Blinking
If the Low Oil Pressure Indicator Comes On ............................................. 372
If the 12V Battery Charging System
Indicator Comes On ....................... 373
If the Malfunction Indicator Lamp Comes On or Blinks ................................... 374
If the Brake System Indicator (Red) Comes On or Blinks ................................... 375
If the Electric Power Steering (EPS) System Indicator Comes On............................ 375
If the Brake System Indicator (Red) comes on or blinks at the same time when the Brake
System Indicator (Amber) comes on .... 376
If the IMA Indicator Comes On ........ 377
If the Low Tire Pressure/TPMS Indicator Comes On or Blinks ....................... 377
Fuses
Fuse Locations ................................. 378
Inspecting and Changing Fuses ........ 382
Emergency Towing ........................... 383
When You Cannot Open the Hatch ..... 385
16 CR-Z-31SZT6500.book 349 ページ ２０１５年９月１１日　金曜日　午前１１時４７分

372
Handling the Unexpected
Indicator, Coming On/Blinking
If the Low Oil Pressure Indicator Comes On
■Reasons for the indicator to come on
Comes on when the engine oil pressure is low.
■What to do as soon as the indicator comes on
1. Immediately park the vehicle on level ground in a safe place.
2. If necessary, turn the ha zard warning lights on.
■What to do after parking the vehicle
1. Stop the engine and let it sit for about three minutes.
2. Open the hood and check the oil level.
u Add oil as necessary.
2 Oil Check P. 310
3.Start the engine and check the low oil pressure indicator.
u The light goes off: Start driving again.
u The light does not go off within 10 seconds: Stop the engine and
contact a dealer for repairs immediately.
1If the Low Oil Pressure Indicator Comes On
NOTICE
Running the engine with low oil pressure can cause
serious mechanical damage almost immediately.
16 CR-Z-31SZT6500.book 372 ページ ２０１５年９月１１日　金曜日　午前１１時４７分

389
uuSpecifications u
Information
■Brake/Clutch* Fluid
■ Continuously Variable Transmission
Fluid
■ Manual Transmission Fluid
SpecifiedHonda Heavy Duty Brake Fluid DOT 3
SpecifiedHonda Continuously
Variable Transmission Fluid
Capacity Change 3.0 US qt (2.8 L)
SpecifiedHonda Manual Transmission
Fluid (MTF)
Capacity Change1.5 US qt (1.4 L)
■Engine Oil
■ Engine Coolant
*1: Manual transmission models
*2: Continuously variable transmission models
Recommended·Genuine Honda Motor Oil 0W-20·API Premium-grade 0W-20 detergent oil
Capacity Change 3.6 US qt (3.4 L)
Change
including
filter
3.8 US qt (3.6 L)
SpecifiedHonda Long Life Antifreeze/Coolant Type2
Ratio 50/50 with distilled water
Capacity
1.17 US gal (4.42 L)*1
1.15 US gal (4.35 L)*2
(change including the remaining
0.116 US gal (0.44 L) in the reserve tank)
■ Tire
*1: Optional on Canadian models
Regular
SizeP195/55R16 86V205/45R17 84W*1
Pressure
psi (kPa
[kgf/cm
2])
Front30 (210 [2.1])32 (220 [2.2])*1
Rear30 (210 [2.1])30 (210 [2.1])*1
Wheel SizeRegular16 x 6J17 x 6 1/2J*1
* Not available on all models
16 CR-Z-31SZT6500.book 389 ページ ２０１５年９月１１日　金曜日　午前１１時４７分