Page 50 of 609
49
uuAirbags uSide Airbags
Safe Driving
■When a side airbag deploys with little or no visible damage
Because the airbag systems senses sudden acceleration, a strong impact to the side 
of the vehicle's framework can cause a side  airbag to deploy. In such cases, there 
may be little or no damage, but the side  impact sensors detected a severe enough 
impact to deploy the airbag.
■When a side airbag may not deploy,  even though visible damage appears 
severe
It is possible for a side airbag to not deploy during an impact that results in 
apparently severe damage. This can occu r when the point of impact was towards 
the far front or rear of the vehicle, or when the vehicle's crushable body parts 
absorbed most of the crash  energy. In either case, the side airbag would not have 
been needed nor provided protec tion even if it had deployed.
16 US ACCORD 2D (KA KC KL)-31T3L6300.book  49 ページ  2015年7月23日 木曜日 午後4時11分 
         
        
        
     
        
        Page 53 of 609

uuAirbags uAirbag System Indicators
52
Safe Driving■When the passen ger airbag off 
indicator comes on
The indicator comes on  to alert you that the 
passenger’s front airbag  has been turned off.
This occurs when the front passenger’s weight 
sensors detect 65 lbs (29 kg) or less, the 
weight of an infant or small child, on the seat.
Infants and small children should always ri de properly restrained in a back seat.
2Child Safety  P. 54
Objects placed on the seat can also  cause the indicator to come on.
If the front passenger seat is empty, the passenger’s front airbag will not deploy and 
the indicator will not come on.
■Passenger Airbag Off Indicator1 Passenger Airbag Off Indicator
If the indicator comes on wi th no front passenger and 
no objects on the passenger’s  seat, or with an adult 
riding there, something may be interfering with the 
weight sensors, such as:
•An object hanging on the seat  or in the seat-back 
pocket.
•A child seat or other obj ect pressing against the 
rear of the seat-back.
•A rear passenger pushing or  pulling on the back of 
the front passe nger’s seat.
•The front seat or seat-back is forced back against 
an object on the seat or floor behind it.
•An object placed under th e front passenger’s seat.
If none of these conditions exist, have your vehicle 
checked by a dealer as soon as possible.
The passenger airbag off  indicator may come on and 
goes off repeatedly if the to tal weight on the seat is 
near the airbag cutoff threshold.
U.S. Canada
16 US ACCORD 2D (KA KC KL)-31T3L6300.book  52 ページ  2015年7月23日 木曜日 午後4時11分 
         
        
        
     
        
        Page 54 of 609

53
uuAirbags uAirbag Care
Safe Driving
Airbag Care
You do not need to, and should not, perform any maintenance on or replace any 
airbag system components yourself. However, you should have your vehicle 
inspected by a dealer in the following situations:
■When the airbags have deployed
If an airbag has inflated, the control unit  and other related parts must be replaced. 
Similarly, once an automatic seat belt te nsioner has been activated, it must be 
replaced.
■When the vehicle has been in a moderate-to-severe collision
Even if the airbags did not infl ate, have your dealer inspect the following: the driver’s 
seat position sensor, weight sensors in the passenger’s seat, front seat belt 
tensioners, and each seat belt that was worn during the crash.
■Do not remove or modi fy a front seat without consulting a dealer
This would likely disable the driver's seat position sensor or the weight sensors in the 
passenger's seat. If it is necessary to remo ve or modify a front seat to accommodate 
a person with disabilities, co ntact a Honda dealer, or for U.S. vehicles, American 
Honda Automobile Customer Service at 800-999-1009 and for Canadian vehicles, 
Honda Canada Customer Relations at 888-9-HONDA-9.
1 Airbag Care
We recommend against the use of salvaged airbag 
system components, including the airbag, tensioners, 
sensors, and control unit.
16 US ACCORD 2D (KA KC KL)-31T3L6300.book  53 ページ  2015年7月23日 木曜日 午後4時11分 
         
        
        
     
        
        Page 75 of 609

74
uuIndicators u
Instrument Panel
*1:Models with the smart entry system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
Transmission 
Indicator*
●Blinks if the transmission system has 
a problem.●Blinks while driving - Avoid sudden 
starts and acceleration and have your 
vehicle checked by a dealer 
immediately.
Seat Belt 
Reminder 
Indicator
●Comes on and the beeper sounds if 
you are not wearing a seat belt when 
you turn the igniti on switch to ON 
(w*1.●If the front passenger is not wearing 
a seat belt, the indicator comes on a 
few seconds later.
●Blinks while driving if either you or 
the front passenger has not fastened 
a seat belt. The beeper sounds and 
the indicator blinks at regular 
intervals.
●The beeper stops and the indicator goes 
off when you and the front passenger 
fasten their seat belts.
●Stays on after you or the front 
passenger has fastened the seat 
belt - A detection error may have 
occurred in the sensor. Have your 
vehicle checked by a dealer.
2Seat Belt Reminder  P. 35
Models with 
information 
display
Models with 
multi-
information 
display
* Not available on all models
16 US ACCORD 2D (KA KC KL)-31T3L6300.book  74 ページ  2015年7月23日 木曜日 午後4時11分 
         
        
        
     
        
        Page 78 of 609

77
uuIndicators u
Continued
Instrument Panel
*1:Models with the smart entry system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
Door and Trunk 
Open Indicator
●Comes on for a few seconds if you 
turn the ignition switch to ON 
(w*1, 
then goes off.
●Comes on if either door or the trunk 
is not completely closed.
●The beeper sounds and the indicator 
comes on if either door or the trunk 
is opened while driving.
●Goes off when both doors and the 
trunk are closed.
Parking Sensor 
System Indicator*
●Comes on for a few seconds when 
you turn the igniti on switch to ON 
(w*1, then goes off.●Comes on if there is a problem with 
the parking sensor system.
●Check if the area around the sensor(s) is 
covered with mud, ice,  snow, etc. If the 
indicator stays on even after you clean 
the area, have the system checked by a 
dealer.
—
Electric Power 
Steering (EPS) 
System Indicator
●Comes on when you turn the 
ignition switch to ON 
(w*1, and goes 
off when the engine starts.
●Comes on if there is a problem with 
the EPS system.
●Stays on constantly or does not 
come on at all  - Have your vehicle 
checked by a dealer.
2 If the Electric Power Steering (EPS) 
System Indicator Comes On  P. 574
Models with 
information 
display
Models with 
multi-
information 
display
* Not available on all models
16 US ACCORD 2D (KA KC KL)-31T3L6300.book  77 ページ  2015年7月23日 木曜日 午後4時11分 
         
        
        
     
        
        Page 85 of 609

84
uuIndicators u
Instrument Panel
*1:Models with the smart entry system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
Road Departure 
Mitigation (RDM) 
Indicator
*
●Comes on for a few seconds when 
you turn the ignition switch to ON 
(w*1, then goes off.●Comes on if there is a problem with 
the RDM system.
●Stays on constantly - Have your vehicle 
checked by a dealer.
●Comes on when the RDM system 
shuts itself off.●Stays on  - The temperature inside the 
camera is too high.
Use the climate contro l system to cool 
down the camera.
The system activates when the temperature 
inside the camera cools down.
2 Front Sensor Camera* P. 445
●Stays on  - The area around the camera is 
blocked by dirt, mud, etc. Stop your vehicle 
in a safe place, and wipe it off with a soft 
cloth.
●Have your vehicle checked by a dealer if the 
indicator and message come back on after 
you cleaned the area around the camera.
2 Front Sensor Camera* P. 445
* Not available on all models
16 US ACCORD 2D (KA KC KL)-31T3L6300.book  84 ページ  2015年7月23日 木曜日 午後4時11分 
         
        
        
     
        
        Page 86 of 609

85
uuIndicators u
Continued
Instrument Panel
*1:Models with the smart entry system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
Adaptive Cruise 
Control (ACC) 
Indicator 
(Amber)
*
●Comes on for a few seconds when 
you turn the ignition switch to ON 
(w*1, then goes off.●Comes on if there  is a problem with 
ACC.
●Comes on while driving  - Have your 
vehicle checked by a dealer.
●Comes on if anything covers the 
radar sensor cover and prevents the 
sensor from detecting a vehicle in 
front.
●May come on when driving in bad 
weather (rain, snow, fog, etc.)
●ACC has been automatically 
canceled.
●When the radar sensor gets dirty, stop your 
vehicle in a safe place, and wipe off dirt 
using a soft cloth.
●Have your vehicle checked by a dear if the 
indicator does not go off even after you 
clean the sensor cover.
Adaptive Cruise 
Control ( ACC) 
Indicator 
(White)
*
●Comes on when you press the 
MAIN  button.2Adaptive Cruise Control (ACC)* P. 447—
●Comes on if the temperature inside 
the camera is too high.
●ACC has been automatically 
canceled.
●Use the climate control system to cool 
down the camera.
●Goes off  - The camera has been cooled 
down. Pressing the  MAIN button can 
resume the system.
2 Front Sensor Camera* P. 445
2 Adaptive Cruise Control (ACC)* P. 447
* Not available on all models
16 US ACCORD 2D (KA KC KL)-31T3L6300.book  85 ページ  2015年7月23日 木曜日 午後4時11分 
         
        
        
     
        
        Page 88 of 609

87
uuIndicators u
Instrument Panel
*1:Models with the smart entry system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
Collision 
Mitigation 
Braking System
TM 
(CMBSTM) 
Indicator*
●Comes on for a few seconds when 
you turn the ignition switch to ON 
(w*1, then goes off.●Comes on when you deactivate 
the CMBSTM. A multi-information 
display message appears for five 
seconds.
●Comes on if there is a problem 
with the CMBSTM.
●Stays on constantly without the 
CMBSTM off  - Have your vehicle checked by 
a dealer.
2 Collision Mitigation Braking SystemTM 
(CMBSTM)* P. 483
●Comes on when the CMBSTM 
system shuts itself off.●Stays on  - The area around the camera is 
blocked by dirt, mud, etc. Stop your vehicle 
in a safe place, and wipe it off with a soft 
cloth.
2 Front Sensor Camera* P. 445
●When the radar sensor  gets dirty, stop your 
vehicle in a safe place, and wipe off dirt 
using a soft cloth.
●Have your vehicle checked by a dealer if the 
message does not disappear even after you 
clean the sensor cover.
2 Collision Mitigation Braking SystemTM 
(CMBSTM)* P. 483
●Stays on  - The temperature inside the 
camera is too high. Use the climate control 
system to cool do wn the camera. The 
system activates when the temperature 
inside the camera cools down.
2 Front Sensor Camera* P. 445
* Not available on all models
16 US ACCORD 2D (KA KC KL)-31T3L6300.book  87 ページ  2015年7月23日 木曜日 午後4時11分