2016 FORD MUSTANG tow

Closing the Convertible Top
1. Bring the vehicle to a complete stop and remove the
tonneau caps.
2. Press and hold the convertible top control as the top unfolds
and moves forward toward the windshield header.
3. When the top lines up evenly with the windshield header,
release the convertible top control.
4. Pull down on the latch handle and rotate it counterclockwise
to secure the convertible top.
5. After securing the convertible top fully, push the latch
handle up into the stowed position to lock the latch, and
then use the power window controls to close the windows.
Note: If the top has been open for an extended period of time
or if the temperature is low, the top material may shrink
slightly. If this happens, extra force on the latch handle may
be needed to secure the top.
For complete information, refer to the Convertible Top
chapter of your Owner’s Manual.
Tips When Using Your Convertible Top
» Do not store articles behind the rear seat. Articles stored
in the convertible top stowage compartment may break
the rear glass window when you open the top.
» The windows lower automatically when opening or
closing the top.
» Do not lower the top when the top material is wet. Remove
any leaves or debris on the outer surface of the top.
» The convertible top does not operate unless the vehicle is
stationary or traveling under 3 mph (4.8 km/h).
Note: You must switch your ignition on to open or close the
convertible top. We recommend that you leave the engine
running to prevent draining the battery.
CONVERTIBLE TOP* (CONTINUED)
Opening the Convertible Top
1. Bring the vehicle to a complete stop.
2. Move the latch handle, located above the interior mirror, down
toward the windshield and rotate the handle clockwise to release the
convertible top.
3. Press and hold the convertible top control, located on the overhead
console, until the windows are down completely and the top stores fully.
Using the Tonneau Caps
Your convertible top also includes two tonneau caps, one for each side of\
the
vehicle. You can stow these caps inside the luggage compartment.
After opening your convertible top, place the tonneau caps between the t\
op
and your vehicle trim molding by doing the following:
1. Insert the leading edge under the trim.
2. When the leading edge is under the trim slot, angle the side edge down
so the edges slide under the surrounding molding. Secure the side edge
into place between the trim edges.
3. Repeat Steps 1 and 2 on the opposite side of the vehicle to install the \
second tonneau cap.
Note: Remove the tonneau caps before attempting to close the convertible
top or a chime sounds and a warning message appears in the instrument
panel. If this happens, remove and stow the caps, and then press the
convertible top control again.
CONVERTIBLE TOP*
*if equipped13
12
*if equipped

Autowipers*
The feature uses a rain sensor that is in the area around
the interior mirror. The rain sensor monitors the amount of
moisture on the windshield and automatically turns on the
wipers. The sensor also adjusts the wiper speed by the amount
of moisture that the sensor detects on the windshield.
You can switch this feature on and off in the information display.
Note: Make sure you switch off the windshield wipers before
entering a car wash.
Autolamps
The headlamps turn on and off automatically in low light
situations or during inclement weather. The headlamps
remain on for a period of time after you switch the
ignition off.
Use the information display controls to adjust the period of
time that the headlamps remain on.
Remote Start*
Use the remote start to start the engine from outside of
your vehicle.
1. Press the lock button
to lock all the doors.
2. Press the remote start button
twice within three
seconds. The exterior lamps flash twice.
Heated Exterior Mirror*
When you switch the heated rear window on, the heated
exterior mirrors will automatically turn on.
Note: Do not remove ice from the mirrors with a scraper or
adjust the mirror glass when it is frozen in place.
Intelligent Access Luggage
Compartment Release
With your keyless remote within 3 feet (1 meter) of your
vehicle, press the exterior release button hidden above the
license plate.
CONVENIENCE
Selectable Driving*
and Steering Modes
Through a suite of sophisticated
electronic vehicle systems, you can
optimize steering, handling and
powertrain response. To change the
mode settings, use the mode switch on
the instrument panel. The first press of
the mode button or switch illuminates
the selected mode. Subsequent presses
change the selected mode. See the
Driving Aids chapter of your Owner’s
Manual for complete details.
Driving modes*
» Normal – Delivers a balanced
combination of comfort and
handling. This mode provides an
engaging drive experience and a
direct connection to the road without
sacrificing any of the composure
demanded from your vehicle.
» Sport+ – Provides a sportier
steering feel and throttle response.
Sport+ mode is ideal for use during
more spirited driving.
» Track – Provides a performance
driving experience. The engine
responds directly to your inputs
and takes on a more powerful tone.
Use track mode when you desire
pure performance.
» Snow/Wet – Provides a confident
handling driving experience during
poor weather without sacrificing
any of the composure demanded
from your vehicle.
Steering modes
» Normal – Default factory setting.
» Sport – Slightly higher effort
required for steering with more road
force felt through the steering wheel.
» Comfort – Slightly less effort
required for steering with less
road force felt through the
steering wheel.
After selecting the desired setting,
you may feel a soft feedback bump
in the steering wheel when the
changeover occurs.
Note: If your vehicle includes the
selectable drive modes feature, the
steering feel changes when you select a
new drive mode. You can override this
automatic selection by pressing the
steering button.
FUNCTION
*if equipped *if equipped14
15