2016 FORD C MAX HYBRID key battery

5
4
SILENT KEY START
When you switch the ignition on, your engine may
not sound like it started because your hybrid-electric
vehicle includes silent key start. This fuel-saving
feature allows your vehicle to be ready to drive
without requiring your gas engine to run. Instead of
listening for a traditional gasoline-powered engine
sound, look for the ‘ready to drive’ indicator light

in your information display. When this light comes on,
your vehicle started successfully and is ready to drive.
SMART POWER-SPLIT ARCHITECTURE
City Driving: In stop and go driving and at low speeds, the electric
motor provides the necessary power. The gas engine kicks in only
to recharge the battery or when you need more power.
Accelerating: Step on the accelerator pedal and get all the
responsiveness of a traditional gasoline engine.
Cruising or Highway Driving: Due to greater power demands
at highway speeds, your vehicle uses the gasoline engine
more frequently than when driving at city traffic speeds.
This is normal.
Braking: For added efficiency, the energy normally created by
friction during braking recycles to the battery.
Stopped: To save energy, the gasoline engine shuts off
and the electric motor stops drawing current.
ECO SELECT
This feature saves vehicle energy by slowing down acceleration
compared to standard cruise control. For example, your vehicle
may temporarily lose speed when going uphill. You can switch this
feature on and off through the Driver Assist section of the Settings
menu in the information display. To activate ECO Select , press the
button and a graphic shows on your information display.
See the Cruise Control chapter in your Owner’s Manual for
more information.
hybrid featuresquick tips
SMARTGAUGE® WITH ECOGUIDE
Delivers specific information about various systems on your vehicle using menus that build on previous data. Use your left-hand, 5-way
steering controls to scroll through your menu choices:
Vehicle Range: Estimates the distance your vehicle can travel on
the fuel remaining in the tank. Changes in your driving pattern may
cause the value to vary.
Engage: Adds gas and electric power-split information.
Empower: Adds an engine on and off threshold to the power
demand gauge from Enlighten. See how much power you request
based on how far you press the accelerator pedal. MyView: Lets you customize your menu options, allowing you
to select key information and combine it into one screen.
EcoGuide: Displays leaf graphics within the right-hand cluster,
showing you when you’re driving efficiently. More leaves equal
better driving habits!
The Brake Coach appears in the display after the vehicle has come to a stop, and coaches you to
maximize the amount of energy that can be returned through the regenerative braking system.

15
14
HANDS-FREE POWER LIFTGATE*
To open your liftgate hands-free while you are at the liftgate:
Move your foot under and away from the rear bumper, using a
single kicking motion. Do not move your foot sideways or the
sensors may not detect the motion. The liftgate then power
opens or closes.
NOTE Your intelligent access transmitter must be within
3 feet (1 meter) behind the liftgate for the “hands-free” open
feature to work. The liftgate does not power open or close under
specific conditions. Refer to the Locks chapter in your Owner’s
Manual for more information.
SET AND CHANGE
THE LIFTGATE OPEN HEIGHT
*
1. Open the liftgate and then press the control
button on the liftgate when it reaches your desired height.
2. Press and hold the control button until you hear a tone,
indicating that the programming is complete. The next time
you open your liftgate, it opens to the newly set height.
3. To change the height again, repeat the above steps.
MANUAL LIFTGATE
To open the liftgate manually from outside of your vehicle, press
the exterior liftgate release button on top of the liftgate pull-cup
handle to unlatch the liftgate, and then pull on the outside handle.
You can also use the transmitter to unlock your liftgate.
Press
twice within three seconds.
Use the molded handle inside the liftgate to help with closing.
POWER LIFTGATE*
You can open the power liftgate from the instrument panel
by pressing or on your transmitter twice within
three seconds.
When the vehicle is running, the liftgate operates only with the
transmission in park (P). One warning tone sounds as the liftgate
begins to power close.
Three short tones indicate a
problem with the open or close
request, caused when:
» The ignition is on and the
transmission is not in park (P).
» The battery voltage is below the
minimum operating voltage.
» The vehicle speed is at or above
3 mph (5 km/h).
convenience
*if equipped
function
INTELLIGENT ACCESS*
NOTE Your intelligent access transmitter
must be within 3 feet (1 meter) of the vehicle for
intelligent access to function properly.
At the front doors: Pull a front exterior door
handle to unlock and open the door. Press
and hold the raised sensor on the door handle
to lock your vehicle. The intelligent access
transmitter also contains a mechanical key
blade to unlock the driver door, if necessary.
To unlock and open the
liftgate: Press the button
on the top of the liftgate
pull-cup handle. See the
Locks chapter in your
Owner’s Manual for
more information.
REMOTE START*
To Remote Start Your Vehicle
1. Press the lock button to lock all the doors.
2. Press the remote start button
twice. The exterior lamps flash twice.
NOTE With an integrated keyhead transmitter, you must switch the ignition on
before driving your vehicle. With an intelligent access transmitter, you must press the
START STOP button on the instrument panel once while applying the brake pedal
before driving your vehicle. For complete information, refer to the Keys and Remote
Controls chapter in your Owner’s Manual.
MYKEY®
MyKey allows you to program certain driving restrictions in order to promote good
driving habits. You can program things like: speed restrictions, limited volume levels
and safety belt reminders. For complete information, refer to the MyKey chapter in
your Owner’s Manual.
110-VOLT AC POWER POINT*
The power point is on the rear of the center console. You can
use it to power your smaller electrical devices that do not
exceed 150 watts. This feature is available to use when you
switch on your ignition and the battery voltage is above 11 volts.
When the indicator light is on, the power point is working and
ready to use.
CARGO STORAGE
Two under-floor storage compartments, located behind the
front seats, allow you to store smaller items discreetly. With
the lids secured, your items stay in place while you drive.
*if equipped