2016 FIAT TALENTO tailgate

[x] Cancel search: tailgate

Page 20 of 232

FIAT TALENTO 2016 2.G Owners Manual Keyless ENTRY
This lets you lock/unlock without
needing to use the electronic key, if you
are in the access area 1 fig. 16.
Locking/unlocking the vehicle
There are two ways to lock/unlock the
vehicle:

Page 21 of 232

FIAT TALENTO 2016 2.G Owners Manual Locking with the electronic key:
With the doors shut, press button 4
fig. 20: the vehicle is locked. You can
see it is locked because the emergency
lights flash.
NOTE The maximum distance from the
veh

Page 22 of 232

FIAT TALENTO 2016 2.G Owners Manual IMPORTANT After locking/unlocking the
vehicle with the electronic key buttons,
the "easy access" lock and unlock
mode is disabled. To get back to "easy
access", restart the vehicle.
Centralised door c

Page 24 of 232

FIAT TALENTO 2016 2.G Owners Manual Closing from inside
Pull the door using handle 3 only. fig. 30
When the door opens, an acoustic
warning indicates that the lights are still
on even though the engine starter
device is disengaged.
Forg

Page 26 of 232

FIAT TALENTO 2016 2.G Owners Manual Closing from outside
Bring the right swing door back until
almost closed and end by making it
click in place.
Then do the same with the left swing
door.
Lock the swing doors.
To unlock door A fig. 39,

Page 27 of 232

FIAT TALENTO 2016 2.G Owners Manual Closing
Lower the tailgate by first using the
inside handle 2 fig. 42.
When the door is shoulder height, let
handle 2 go and close the tailgate by
pushing it from the outside.
CENTRALISED DOOR
LOCKING

Page 28 of 232

FIAT TALENTO 2016 2.G Owners Manual MANUAL DOOR
LOCKING/UNLOCKING
4) 5)
Locking from the outside
This can be done with either the remote
control or electronic key: refer to the
"Key with remote control" or "Electronic
key" paragraphs in

Page 30 of 232

FIAT TALENTO 2016 2.G Owners Manual 16)When you stop by the side of the road,
if the tailgate is completely open, the rear
lights might not be visible. Warn other road
users that your vehicle is there by placing
the pre-signal triangle
Page:   1-8 9-16 next >