FiltersAir Cleaner .......................... .387
Air Conditioning ...................... .390
Engine Fuel .......................... .435
Engine Oil ........................... .387
Engine Oil Disposal .....................387
Flashers Turn Signal ........................ .85, 184
Flooded Engine Starting ....................267
Fluid, Brake ............................ .437
Fluid Capacities ......................... .434
Fluid Leaks ..............................85
Fluid Level Checks Automatic Transmission ..................410
Fluids, Lubricants And Genuine Parts ...........435
Fog Lights ..............................113
Fold And Tumble Rear Seat ..................101
Freeing A Stuck Vehicle .....................370
Fuel .................................. .338Adding
............................. .342
Additives ............................ .340
Capacity ............................ .434
Clean Air ............................ .339
Ethanol ............................. .339
Gasoline ............................. .338
Light ............................... .177
Materials Added ....................... .340
Methanol ............................ .339
Octane Rating ......................... .338
Requirements ......................... .338
Tank Capacity ......................... .434
Fueling ............................... .342
Fuses ................................. .418
Garage Door Opener (HomeLink) ..............133
Gasoline, Clean Air ....................... .339
Gasoline (Fuel) ....................... .338, 434
Gasoline, Reformulated .....................339
10
INDEX 463
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.
