2016 FIAT 500C charging

Battery Charge Warning Light
Red TelltaleLight What It Means
Battery Charge Warning Light
This light illuminates when the battery is not charging properly. If it stays on while the en-
gine is running, there may be a malfunction with the charging system. Contact your autho-
rized dealer as soon as possible. This indicates a possible problem with the electrical system
or a related component.
If jump starting is required, refer to “Jump Starting Procedures” in “What To Do In Emer-
gencies.”
4
UNDERSTANDING YOUR INSTRUMENT PANEL 153

3. Remove the protective cover over the positive(+)
battery post. To remove the cover, push the locking tab
and pull upward on the cover.
4. If using another vehicle to jump-start the battery, park the vehicle within the jumper cables reach, set the
parking brake and make sure the ignition is OFF.
WARNING!
Do not allow vehicles to touch each other as this
could establish a ground connection and personal
injury could result.
Jump-Starting Procedure
WARNING!
Failure to follow this jump-starting procedure could
result in personal injury or property damage due to
battery explosion.
CAUTION!
Failure to follow these procedures could result in
damage to the charging system of the booster vehicle
or the discharged vehicle.
Connecting The Jumper Cables
1. Connect the positive (+)end of the jumper cable to the
positive (+)post of the discharged vehicle.
2. Connect the opposite end of the positive (+)jumper
cable to the positive (+)post of the booster battery.
3. Connect the negative end (-)of the jumper cable to the
negative (-)post of the booster battery.
4. Connect the opposite end of the negative (-)jumper
cable to a good engine ground (exposed metal part of
the discharged vehicle’s engine) away from the battery
and the fuel injection system.
336 WHAT TO DO IN EMERGENCIES

WARNING!
Do not connect the jumper cable to the negative (-)
post of the discharged battery. The resulting electri-
cal spark could cause the battery to explode and
could result in personal injury. Only use the specific
ground point, do not use any other exposed metal
parts.
5.
Start the engine in the vehicle that has the booster
battery, let the engine idle a few minutes, and then start
the engine in the vehicle with the discharged battery.
6. Once the engine is started, remove the jumper cables in the reverse sequence:
Disconnecting The Jumper Cables
1. Disconnect the negative (-)jumper cable from the
engine ground (-)of the vehicle with the discharged
battery. 2. Disconnect the negative end
(-)of the jumper cable
from the negative (-)post of the booster battery.
3. Disconnect the opposite end of the positive (+)jumper
cable from the positive (+)post of the booster battery.
4. Disconnect the positive (+)end of the jumper cable
from the positive (+)post of the discharged vehicle.
If frequent jump-starting is required to start your vehicle,
you should have the battery and charging system in-
spected at your authorized dealer.
CAUTION!
Accessories plugged into the vehicle power outlets
draw power from the vehicle’s battery, even when
not in use (i.e., cellular devices, etc.). Eventually, if
plugged in long enough without engine operation,
(Continued)
6
WHAT TO DO IN EMERGENCIES 337

Audio Systems (Radio).....................191
Automatic Dimming Mirror ...................89
Automatic Oil Change Indicator ...............406
Automatic Temperature Control (ATC) ..........212
Automatic Transaxle ........................11
Automatic Transmission ..............231, 378, 380
Adding Fluid ...................... .379, 380
Fluid And Filter Changes ..................380
Fluid Change ......................... .380
Fluid Level Check ...................... .379
Fluid Type ........................... .403
Gear Ranges .......................... .235
Special Additives ...................... .379
Autostick .............................. .240
Battery ............................ .153, 358
Charging System Light ...................153
Jump Starting ......................... .334
Keyless Transmitter Replacement (RKE) ........19Belts, Seat
...............................78
Body Mechanism Lubrication .................364
B-Pillar Location ......................... .266
Brake Assist System ...................... .252
Brake Fluid ......................... .401, 403
Brake, Parking .......................... .246
Brakes ................................ .376
Brake System ........................ .250, 376
Anti-Lock (ABS) ....................... .250
Master Cylinder ....................... .376
Parking ............................. .246
Warning Light ........................ .151
Brake/Transmission Interlock .................233
Bulb Replacement ..................... .396, 397
Bulbs, Light .......................... .80, 396
Capacities, Antifreeze (Engine Coolant) ..........400
Capacities, Fluid ......................... .400
10
INDEX 425