2016 FIAT 124 SPIDER boot

[x] Cancel search: boot

Page 40 of 216

FIAT 124 SPIDER 2016 2.G Owners Manual BOOT LID
OPENING
47) 48)
IMPORTANT Before opening the boot
lid, remove any snow and ice
accumulation on it. Otherwise, the boot
lid could close under the weight of the
snow and ice resulting in injury

Page 41 of 216

FIAT 124 SPIDER 2016 2.G Owners Manual partially peel back the cover on the
right side of the vehicle fig. 32;
turn and loosen the cap screws
fig. 33 until the screws start to spin free;
pull out the cap and open the boot
lid fig. 34. Afte

Page 67 of 216

FIAT 124 SPIDER 2016 2.G Owners Manual MESSAGE INDICATED ON
DISPLAY
(versions with Radio 7”)
If a message is displayed in the center
display, take appropriate action (in a
calm manner) according to the
displayed message.
If the following

Page 122 of 216

FIAT 124 SPIDER 2016 2.G Owners Manual REFUELLING THE
VEHICLE
152) 153) 154) 155) 156) 157)
Always stop the engine before
refuelling.
FUEL REQUIREMENTS
Only use premium unleaded fuel
(conforming to EN 228 specification
within E10) with a n

Page 132 of 216

FIAT 124 SPIDER 2016 2.G Owners Manual Interior light
Light bulbCategory
Wattage UNECE(*)
Overhead light 10 —
Boot lid light 5 —
(*) UNECE stands for United Nations Economic Commission for Europe.
130
IN CASE OF EMERGENCY

Page 136 of 216

FIAT 124 SPIDER 2016 2.G Owners Manual Rear direction indicator lights
Proceed as follows:
remove the retainers 1 fig. 112 and
the boot lid end trim;
remove the retainers 2 fig. 113 and
then partially peel back the boot lid side
trim;
disc

Page 145 of 216

FIAT 124 SPIDER 2016 2.G Owners Manual WARNING
164)If the fuse blows again contact a Fiat
Dealership.
165)Never replace a fuse with another
with a higher amp rating; DANGER OF
FIRE.
166)Contact a Fiat Dealership if a safety
system (airbags

Page 148 of 216

FIAT 124 SPIDER 2016 2.G Owners Manual turn the air compressor switch on
and inflate the tire carefully to the
correct inflation pressure;
IMPORTANT When inserting the air
compressor plug into or removing it
from the accessory socket, make
Page:   < prev 1-8 9-16 17-24 next >