Sentry Key (Immobilizer)....................15
Sentry Key Replacement .....................16
Service Assistance ........................ .675
Service Contract ......................... .677
Service Manuals ......................... .679
Settings, Personal ........................ .352
Setting The Clock ..................... .360, 369
Shift Lever Override ...................... .606
Shoulder Belts ............................59
Signals, Turn ...............122, 227, 335, 657, 658
Sliding Door .............................43
Snow Chains (Tire Chains) ...................524
Snow Tires ............................. .517
Spare Tire ....................... .519, 520, 583
Spark Plugs ............................ .661
Speed Control (Cruise Control) ................235
Starting ............................... .465
Automatic Transmission ..................465
Cold Weather ......................... .466Engine Fails To Start
.....................466
Remote ...............................30
Starting And Operating .....................465
Starting Procedures ....................... .465
Steering Power ........................... .483, 484
Tilt Column .......................... .233
Wheel, Heated ........................ .234
Wheel, Tilt ........................... .233
Steering Wheel Audio Controls ...............437
Steering Wheel Mounted Sound System Controls . . .437
Storage ............................... .654
Storage Bin ............................. .276
Storage, Vehicle ...................... .459, 654
Storing Your Vehicle ...................... .654
Stow N Go (Fold in Floor) Seats ..............197
Sunglasses Storage ....................... .251
Sun Roof .............................. .264
Supplemental
Restraint System - Air Bag .........78
10
INDEX 699
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.
