2016 DODGE DART window

[x] Cancel search: window

Page 192 of 671

DODGE DART 2016 PF / 1.G Owners Manual Things You Should Know About Your Uconnect
Phone
Voice Command
For the best performance:
•Adjust the rearview mirror to provide at least ½ inch
(1 cm) gap between the overhead console (if equipped)

Page 193 of 671

DODGE DART 2016 PF / 1.G Owners Manual NOTE:It is recommended that you do not store names in
your favorites phonebook while the vehicle is in motion.
Phonebook (Mobile and Favorites) name recognition rate
is optimized when the entries are

Page 209 of 671

DODGE DART 2016 PF / 1.G Owners Manual Voice Training
For users experiencing difficulty with the system recog-
nizing their voice commands or numbers the Uconnect
Voice “Voice Training” feature may be used.
1. Push the Voice Command
bu

Page 284 of 671

DODGE DART 2016 PF / 1.G Owners Manual Sunshade Operation
The sunshade can be opened manually. However, the
sunshade will open automatically as the sunroof opens.
NOTE:The sunshade cannot be closed if the sunroof is
open.
Wind Buffeting
Wi

Page 296 of 671

DODGE DART 2016 PF / 1.G Owners Manual REAR WINDOW FEATURES
Rear Window Defroster
The rear window defroster button is located on
the climate control. Push this button to turn on the
rear window defroster and the heated outside mirrors (if

Page 369 of 671

DODGE DART 2016 PF / 1.G Owners Manual Engine Off Options
After pressing the “Engine Off Options” button on the
touchscreen the following settings will be available.
•Engine Off Power Delay
When this feature is selected, the power wi

Page 397 of 671

DODGE DART 2016 PF / 1.G Owners Manual 1. Blower Control
Rotate this control to regulate the amount of air forced
through the ventilation system in any mode. The blower
speed increases as you move the control to the right from
the “O”

Page 399 of 671

DODGE DART 2016 PF / 1.G Owners Manual •ECONOMY MODE
If economy mode is desired, push the A/C button to
turn OFF the indicator light and the A/C compressor.
Then, move the temperature control to the desired
temperature and select only Pa