2016 DODGE CHARGER bulb

Turn Signal Indicator Lights
Green TelltaleLight What It Means
Turn Signal Indicator Lights
The instrument cluster directional arrow will flash independently for the LEFT or RIGHT
turn signal as selected, as well as the exterior turn signal lamp(s) (front and rear) as selected
when the multifunction lever is moved down (LEFT) or up (RIGHT).
NOTE:
•A continuous chime will sound if the vehicle is driven more than 1 mile (1.6 km) with ei-
ther turn signal on.
•Check for an inoperative outside light bulb if either indicator flashes at a rapid rate.
4
UNDERSTANDING YOUR INSTRUMENT PANEL 291

▫Cooling System ..................... .573
▫ Brake System ....................... .579
▫ Automatic Transmission ................581
▫ All Wheel Drive (AWD) — If Equipped .....583
▫ Rear Axle .......................... .583
▫ Appearance Care And Protection From
Corrosion .......................... .584
 FUSES ............................. .590
▫ Front Power Distribution Center (Fuses) .....591
▫ Rear Power Distribution Center (Fuses) .....597
 VEHICLE STORAGE ....................605
 REPLACEMENT BULBS .................606 
BULB REPLACEMENT ..................608
▫ Front Low/High Beam Headlamp And
Park/Turn Lamp — Models With Halogen
Headlamps ......................... .608
▫ Front Low/High Beam Headlamp And
Park/Turn Lamp — Models With High
Intensity Discharge Headlamps (HID) .......609
▫ Front/Rear Side Marker Lamp ............609
▫ Front Fog Lamp ..................... .609
▫ Backup Lamps ....................... .609
▫ Center High Mounted Stop Lamp (CHMSL) . . .610
▫ License Lamp ....................... .610
550 MAINTAINING YOUR VEHICLE

Normally, the OBD II system will be ready. The OBD II
system maynotbe ready if your vehicle was recently
serviced, recently had a dead battery or a battery replace-
ment. If the OBD II system should be determined not
ready for the I/M test, your vehicle may fail the test.
Your vehicle has a simple ignition actuated test, which
you can use prior to going to the test station. To check if
your vehicle’s OBD II system is ready, you must do the
following:
1. Cycle the ignition switch to the ON position, but do not crank or start the engine.
NOTE: If you crank or start the engine, you will have to
start this test over.
2. As soon as you cycle the ignition switch to the ON position, you will see the “Malfunction Indicator Light
(MIL)” symbol come on as part of a normal bulb
check. 3. Approximately 15 seconds later, one of two things will
happen:
• The MIL will flash for about 10 seconds and then
return to being fully illuminated until you turn OFF
the ignition or start the engine. This means that your
vehicle’s OBD II system is not readyand you should
not proceed to the I/M station.
• The MIL will not flash at all and will remain fully
illuminated until you place the ignition in the off
position or start the engine. This means that your
vehicle’s OBD II system is readyand you can proceed
to the I/M station.
If your OBD II system is not ready,you should see your
authorized dealer or repair facility. If your vehicle was
recently serviced or had a battery failure or replacement,
you may need to do nothing more than drive your
vehicle as you normally would in order for your OBD II
system to update. A recheck with the above test routine
may then indicate that the system is now ready.
556 MAINTAINING YOUR VEHICLE

REPLACEMENT BULBS
All of the interior bulbs are glass wedge base or glass
cartridge types. Aluminum base bulbs are not approved
and should not be used for replacement.
Interior Bulbs
Bulb Number
Rear Courtesy/Reading Lamps W5W
Rear Compartment (Trunk) Lamp 562
Overhead Console Reading Lamp 578
Visor Vanity Lamps A6220
Glove Compartment Lamp – If Equipped 194
Door Courtesy 562
Shift Indicator Lamp JKLE14140
Center High-Mount Stop Lamp (CHMSL) LED (Serviced at Authorized Dealer)
Optional Door Map Pocket/Cup Holder LED (Serviced at Authorized Dealer)
For lighted switches, see your authorized dealer for replacement instructions.
606 MAINTAINING YOUR VEHICLE

Exterior Bulbs
Bulb Number
Low/High Beam Headlamp
(Standard Halogen Bi Function Projector) 9005SL+
Low/High Beam Headlamp – High Intensity
Discharge (Premium HID Bi Function Projector) D3S (Serviced at Authorized Dealer)
Front Park/Turn Lamp LED (Serviced at Authorized Dealer)
Front Fog Lamp – If Equipped LED (Serviced at Authorized Dealer)
Front Side Marker LED (Serviced at Authorized Dealer)
Rear Tail Lamp LED (Serviced at Authorized Dealer)
Rear Stop/Turn Lamp LED (Serviced at Authorized Dealer)
Rear Side Marker LED (Serviced at Authorized Dealer)
Backup Lamp LED (Serviced at Authorized Dealer)
License LED (Serviced at Authorized Dealer)
7
MAINTAINING YOUR VEHICLE 607

BULB REPLACEMENT
NOTE:Lens fogging can occur under certain atmo-
spheric conditions. This will usually clear as atmospheric
conditions change to allow the condensation to change
back into a vapor. Turning the lamps on will usually
accelerate the clearing process.
Front Low/High Beam Headlamp And Park/Turn
Lamp — Models With Halogen Headlamps
1. Open the hood.
NOTE: Removal of the air cleaner filter housing may be
necessary prior to replacing bulbs in the headlamp
assembly on the driver side of the vehicle.
2. Remove the large dust cap from the headlamp hous- ing by turning it counterclockwise, turn the bulb
counterclockwise and remove.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with an oily surface, clean the
bulb with rubbing alcohol.
3. Disconnect the bulb from the socket assembly and install the replacement bulb.
4. Reinstall the bulb and socket assembly into the head- lamp assembly, and then turn it clockwise.
5. Reinstall the dust cap.
608 MAINTAINING YOUR VEHICLE

Front Low/High Beam Headlamp And Park/Turn
Lamp — Models With High Intensity Discharge
Headlamps (HID)
HID Headlamps
The headlamps are a type of high voltage discharge tube.
High voltage can remain in the circuit even with the
headlamp switch off and the key removed.Because of
this, you should not attempt to service a headlamp bulb
yourself. If a headlamp bulb fails, take your vehicle to
an authorized dealer for service.
WARNING!
A transient high voltage occurs at the bulb sockets of
HID headlamps when the headlight switch is turned
ON. It may cause serious electrical shock or electro-
cution if not serviced properly. See your authorized
dealer for service. NOTE:
On vehicles equipped with HID headlamps,
when the headlamps are turned on, there is a blue hue to
the lights. This diminishes and becomes more white after
approximately 10 seconds, as the system charges.
Front/Rear Side Marker Lamp
The Side Markers use LED sources that are not service-
able separately. The Side Markers must be replaced as an
assembly, see your authorized dealer.
Front Fog Lamp
The Front Fog Lamps use LED sources that are not
serviceable separately. The Front Fog Lamp must be
replaced as an assembly, see your authorized dealer.
Backup Lamps
The Backup Lamps use LED sources that are not service-
able separately. The Applique must be replaced as an
assembly, see your authorized dealer.
7
MAINTAINING YOUR VEHICLE 609

Axle Lubrication..................... .613, 616
Battery ............................ .273, 563
Charging System Light ...................273
Keyless Transmitter Replacement (RKE) ........24
Location ............................. .563
Belts, Seat .............................. .101
Body Mechanism Lubrication .................569
B-Pillar Location ......................... .457
Brake Assist System ...................... .440
Brake Control System, Electronic ..............437
Brake Fluid ......................... .613, 616
Brake, Parking .......................... .434
Brakes ................................ .436
Brake System ........................ .436, 579
Fluid Check ....................579, 613, 616
Master Cylinder ....................... .579
Parking ............................. .434
Warning Light ..................... .269, 436Brake/Transmission Interlock
.................417
Break-In Recommendations, New Vehicle .........99
Brightness, Interior Lights ...................163
Bulb Replacement ..................... .606, 608
Bulbs, Light ......................... .103, 606
Camera, Rear ........................... .227
Capacities, Fluid ..........................611
Caps, Filler Oil (Engine) .......................... .561
Radiator (Coolant Pressure) ................576
Carbon Monoxide Warning ...............100, 488
Cargo (Vehicle Loading) ....................495
Car Washes ............................ .584
Certification Label ........................ .495
Chains, Tire ............................ .475
Changing A Flat Tire ...................... .516
Chart, Tire Sizing ........................ .452
Check Engine Light (Malfunction Indicator Light) . .555
638 INDEX