2016 DODGE CHALLENGER SRT battery replacement

▫Programming Additional Transmitters .......25
▫ Transmitter Battery Replacement ...........25
▫ General Information ....................26
 REMOTE STARTING SYSTEM — IF EQUIPPED .27
▫ How To Use Remote Start ................27
▫ Remote Start Abort Message ...............28
▫ To Enter Remote Start Mode ...............28
▫ To Exit Remote Start Mode Without Driving The
Vehicle ..............................29
▫ To Exit Remote Start Mode And Drive The
Vehicle ..............................29
▫ Cancel Remote Start ....................30
▫ General Information ....................30
 DOOR LOCKS .........................31 ▫
Manual Door Locks .....................31
▫ Power Door Locks .....................32
 KEYLESS ENTER-N-GO ..................34
▫ General Information ....................38
 WINDOWS ...........................39
▫ Power Windows .......................39
▫ AUTO-Down Feature — If Equipped ........40
 TRUNK LOCK AND RELEASE .............41
 TRUNK SAFETY WARNING ................42
▫ Trunk Emergency Release ................42
 OCCUPANT RESTRAINT SYSTEMS ..........43
▫ Important Safety Precautions ..............43
▫ Seat Belt Systems ......................45
10 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

•You may need to be less than 35 ft (11 m) from the
vehicle when using the RKE transmitter to turn off the
Panic Alarm due to the radio frequency noises emitted
by the system.
Programming Additional Transmitters
Programming Key Fobs or RKE transmitters may be
performed at an authorized dealer.
Transmitter Battery Replacement
The recommended replacement battery is one CR2032
battery.
NOTE:
• Perchlorate Material — special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate
• Do not touch the battery terminals that are on the back
housing or the printed circuit board. 1. Remove the emergency key by sliding the mechanical
latch on the back of the RKE transmitter sideways
with your thumb and then pull the key out with your
other hand.
2. Separating RKE halves requires screw removal, if equipped, and gently prying the two halves of the
Emergency Key Removal
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 25

(F) Sealant Bottle And Hose Replacement:
1. Uncoil the Sealant Hose (6) (clear in color).
2. Locate the round Sealant Bottle release button in therecessed area under the sealant bottle.
3. Push the Sealant Bottle release button. The Sealant Bottle (1) will pop up. Remove the bottle and dispose
of it accordingly.
4. Clean any remaining sealant from the Tire Service Kit housing.
5. Position the new Sealant Bottle (1) in the housing so that the Sealant Hose (6) aligns with the hose slot in
the front of the housing. Push the bottle into the
housing. An audible click will be heard indicating the
bottle is locked into place. 6. Verify that the cap is installed on the fitting at the end
of the Sealant Hose (6) and return the hose to its
storage area (located on the bottom of the air pump).
7. Return the Tire Service Kit to its storage location in the vehicle.
JUMP-STARTING PROCEDURES
If your vehicle has a discharged battery it can be jump-
started using a set of jumper cables and a battery in
another vehicle or by using a portable battery booster
pack. Jump-starting can be dangerous if done improperly
so please follow the procedures in this section carefully.
NOTE: When using a portable battery booster pack
follow the manufacturer ’s operating instructions and
precautions.
492 WHAT TO DO IN EMERGENCIES

MAINTAINING YOUR VEHICLE
CONTENTS
ENGINE COMPARTMENT — 6.2L
SUPERCHARGED ..................... .508
 ENGINE COMPARTMENT — 6.4L (392 HEMI) .509
 ONBOARD DIAGNOSTIC SYSTEM — OBD II . .510
▫ Onboard Diagnostic System (OBD II)
Cybersecurity ....................... .510
▫ Loose Fuel Filler Cap ..................511
 EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS ......................... .512
 REPLACEMENT PARTS ..................513
 DEALER SERVICE ..................... .513
MAINTENANCE PROCEDURES ...........514
▫ Engine Oil ......................... .515
▫ Engine Oil Filter ..................... .518
▫ Engine Air Cleaner Filter ................519
▫ Maintenance-Free Battery ...............520
▫ Air Conditioner Maintenance .............521
▫ Body Lubrication .....................525
▫ Windshield Wiper Blades ...............525
▫ Adding Washer Fluid ..................526
▫ Exhaust System ..................... .526
7

the ignition or start the engine. This means that your
vehicle’s OBD II system isnot readyand you should
not proceed to the I/M station.
• The MIL will not flash at all and will remain fully
illuminated until you place the ignition in the off
position or start the engine. This means that your
vehicle’s OBD II system is readyand you can proceed
to the I/M station.
If your OBD II system is not ready,you should see your
authorized dealer or repair facility. If your vehicle was
recently serviced or had a battery failure or replacement,
you may need to do nothing more than drive your
vehicle as you normally would in order for your OBD II
system to update. A recheck with the above test routine
may then indicate that the system is now ready.
Regardless of whether your vehicle’s OBD II system is
ready or not, if the MIL is illuminated during normal
vehicle operation you should have your vehicle serviced before going to the I/M station. The I/M station can fail
your vehicle because the MIL is on with the engine
running.
REPLACEMENT PARTS
Use of genuine MOPAR parts for normal/scheduled
maintenance and repairs is highly recommended to en-
sure the designed performance. Damage or failures
caused by the use of non-MOPAR parts for maintenance
and repairs will not be covered by the New Vehicle
Limited Warranty.
DEALER SERVICE
Your authorized dealer has the qualified service person-
nel, special tools, and equipment to perform all service
operations in an expert manner. Service Manuals are
available which include detailed service information for
your vehicle. Refer to these Service Manuals before
attempting any procedure yourself.
7
MAINTAINING YOUR VEHICLE 513

Alarm (Security Alarm)..................19, 235
Alarm System (Security Alarm) ................19
Alterations/Modifications, Vehicle ...............7
Antifreeze (Engine Coolant) ...........530, 565, 566
Disposal ............................. .533
Anti-Lock Brake System (ABS) ................422
Anti-Lock Warning Light ....................250
Appearance Care ........................ .540
Arming System (Security Alarm) ...............19
Assist, Hill Start ......................... .425
Auto Down Power Windows ..................40
Automatic Door Locks ......................33
Automatic Headlights ..................... .139
Automatic High Beams .....................140
Automatic Temperature Control (ATC) .......338, 345
Automatic Transmission ..............390, 538, 540
Adding Fluid ...................540, 567, 569
Autostick ............................ .397
Fluid And Filter Changes ..................540 Fluid Change
......................... .540
Fluid Level Check ...................... .539
Fluid Type ........................ .567, 569
Special Additives ...................... .539
Automatic Transmission Limp Home Mode .......396
Autostick .............................. .397
Auto Unlock, Doors ........................33
Axle Fluid .......................... .567, 569
Axle Lubrication ..................... .567, 569
Battery ............................ .237, 520
Charging System Light ...................237
Keyless Transmitter Replacement (RKE) ........25
Location ............................. .520
Belts, Seat ...............................96
Body Mechanism Lubrication .................525
B-Pillar Location ......................... .442
Brake Assist System ...................... .424
Brake Control System, Electronic ..............421
10
INDEX 593