2016 DODGE CHALLENGER transmission

STARTING AND OPERATING
CONTENTS
STARTING PROCEDURES ................380
▫ Manual Transmission — If Equipped ........381
▫ Automatic Transmission — If Equipped .....381
▫ Keyless Enter-N-Go ...................382
▫ Normal Starting ...................... .383
▫ Extreme Cold Weather
(Below –22°F Or 30°C) ................386
▫ If Engine Fails To Start .................386
▫ After Starting ....................... .387
 ENGINE BLOCK HEATER — IF EQUIPPED . . .387 
MANUAL TRANSMISSION — IF EQUIPPED . .388
▫ Six-Speed Manual Transmission ...........388
▫ Shifting ............................ .389
▫ Recommended Shift Speeds ..............390
▫ 1–4 Skip Shift ....................... .391
▫ Downshifting ....................... .392
 AUTOMATIC TRANSMISSION ............392
▫ Key Ignition Park Interlock ...............394
▫ Brake/Transmission Shift Interlock System . . .394
5

▫Eight-Speed Automatic Transmission — If
Equipped .......................... .394
 AUTOSTICK ......................... .402
▫ Operation ......................... .402
 SPORT MODE — WITHOUT PERFORMANCE
CONTROL .......................... .404
 DRIVING ON SLIPPERY SURFACES .........405
▫ Acceleration ........................ .405
▫ Traction ........................... .405
 DRIVING THROUGH WATER .............406
▫ Flowing/Rising Water ..................406
▫ Shallow Standing Water .................406
 ELECTRIC POWER STEERING .............408
FUEL SAVER TECHNOLOGY 5.7L/6.4L
ENGINES ONLY — IF EQUIPPED ...........409
 PARKING BRAKE ..................... .409
▫ Manual Transmission — If Equipped ........410
▫ Automatic Transmission — If Equipped ......411
 BRAKE SYSTEM ...................... .413
 ELECTRONIC BRAKE CONTROL SYSTEM . . . .413
▫ Electronic Brake Force Distribution (EBD) . . . .414
▫ Brake System Warning Light ..............414
▫ Anti-Lock Brake System (ABS) ............414
▫ Anti-Lock Brake Warning Light ............416
▫ Brake Assist System (BAS) ...............417
▫ Hill Start Assist (HSA) .................417
376 STARTING AND OPERATING

▫Premium System ..................... .455
▫ General Information ....................459
 FUEL REQUIREMENTS ..................459
▫ 3.6L Engine — If Equipped ...............459
▫ 5.7L Engine (With Automatic Transmission) . . .460
▫ 5.7L Engine (With Manual Transmission) .....460
▫ 6.4L Engine ......................... .461
▫ Reformulated Gasoline .................461
▫ Gasoline/Oxygenate Blends ..............462
▫ E-85 Usage In Non-Flex Fuel Vehicles .......462
▫ MMT In Gasoline .....................463
▫ Materials Added To Fuel ................463
▫ Fuel System Cautions ...................464 ▫
Carbon Monoxide Warnings .............465
 ADDING FUEL ....................... .465
▫ Fuel Filler Cap (Gas Cap) ...............465
▫ Loose Fuel Filler Cap Message ............467
 VEHICLE LOADING ....................468
▫ Vehicle Certification Label ...............468
▫ Gross Vehicle Weight Rating (GVWR) .......468
▫ Gross Axle Weight Rating (GAWR) .........468
▫ Overloading ........................ .469
▫ Loading ........................... .469
 TRAILER TOWING .....................470
▫ Common Towing Definitions .............470
▫ Trailer Hitch Classification ...............474
378 STARTING AND OPERATING

Manual Transmission — If Equipped
Apply the parking brake, place the shift lever in NEU-
TRAL and press the clutch pedal before starting vehicle.
This vehicle is equipped with a clutch interlocking igni-
tion system. It will not start unless the clutch pedal is
pressed to the floor.
Normal Starting With Integrated Key — Manual
Transmission
Normal starting of either a cold or a warm engine does
not require pumping or pressing the accelerator pedal.
Press the clutch pedal fully to the floor, and cycle the
ignition switch to the START position and release when
the engine starts. If the engine fails to start within 15
seconds, place the ignition in the OFF position, wait 10 to
15 seconds, then repeat the “Normal Starting” procedure.
WARNING!
Do not attempt to push or tow your vehicle to get it
started. Unburned fuel could enter the catalytic con-
verter and once the engine has started, ignite and
damage the converter and vehicle. If the vehicle has
a discharged battery, booster cables may be used to
obtain a start from another vehicle. This type of start
can be dangerous if done improperly, so follow the
procedure carefully. Refer to “Jump-Starting” in
“What To Do In Emergencies” for further informa-
tion.
Automatic Transmission — If Equipped
The shift lever must be in the NEUTRAL or PARK
position before you can start the engine. Apply the brakes
before shifting into any driving gear.
5
STARTING AND OPERATING 381

CAUTION!
Damage to the transmission may occur if the follow-
ing precautions are not observed:
•Do not shift from REVERSE, PARK, or NEUTRAL
into any forward gear when the engine is above
idle speed.
• Shift into PARK only after the vehicle has come to
a complete stop.
• Shift into or out of REVERSE only after the vehicle
has come to a complete stop and the engine is at
idle speed.
• Before shifting into any gear, make sure your foot
is firmly on the brake pedal.
Using Fob With Integrated Key (Tip Start)
NOTE: Normal starting of either a cold or a warm
engine is obtained without pumping or pressing the
accelerator pedal. Do not
press the accelerator. Use the Fob with Integrated
Key to briefly place the ignition in the START position
and release it as soon as the starter engages. The starter
motor will continue to run, and it will disengage auto-
matically when the engine is running. If the engine fails
to start, the starter will disengage automatically in 10
seconds. If this occurs, place the ignition in the LOCK/
OFF position, wait 10 to 15 seconds, then repeat the
“Normal Starting” procedure.
Keyless Enter-N-Go
This feature allows the driver to oper-
ate the ignition switch with the push
of a button, as long as the ENGINE
START/STOP button is installed and
the Remote Start/Keyless Enter-N-Go
Key Fob is in the passenger compart-
ment.
382 STARTING AND OPERATING

Normal Starting
Using The ENGINE START/STOP Button —
Automatic Transmission Only
1. The transmission must be in PARK or NEUTRAL.
2. Press and hold the brake pedal while pushing theENGINE START/STOP button once.
3. The system takes over and attempts to start the vehicle. If the vehicle fails to start, the starter will
disengage automatically after 10 seconds.
4. If you wish to stop the cranking of the engine prior to the engine starting, push the button again.
NOTE: Normal starting of either a cold or a warm engine
is obtained without pumping or pressing the accelerator
pedal.
Using The ENGINE START/STOP Button —
Manual Transmission Only
1. Press and hold the clutch pedal while pushing and holding the ENGINE START/STOP button.
2. Release the button when the engine starts. If the vehicle fails to start within 15 seconds, release the
button, wait 10 to 15 seconds, then repeat the “Normal
Starting” procedure.
3. If you wish to stop the cranking of the engine prior to the engine starting, release the button.
NOTE: Normal starting of either a cold or a warm engine
is obtained without pumping or pressing the accelerator
pedal.
5
STARTING AND OPERATING 383

To Turn Off The Engine Using ENGINE
START/STOP Button — Automatic Transmission
Only
1. Place the gear selector in PARK, then push and releasethe ENGINE START/STOP button.
2. The ignition switch will return to the OFF position.
3. If the gear selector is not in PARK, the ENGINE START/STOP button must be held for two seconds or
three short pushes in a row and vehicle speed must be
above 5 mph (8 km/h) before the engine will shut off.
The ignition switch position will remain in the ACC
position until the vehicle is stopped, placed PARK and
the button is pushed twice to the OFF position. If the
gear selector is not in PARK and the ENGINE START/
STOP button is pushed once, the Driver Information
Display (DID) will display a “VEHICLE NOT IN PARK” message and the engine will remain running.
Never leave a vehicle out of the PARK position, or it
could roll.
NOTE: If the ignition switch is left in the ACC or RUN
(engine not running) position and the transmission is in
PARK, the system will automatically time out after 30
minutes of inactivity and the ignition will switch to the
OFF position.
To Turn Off The Engine Using ENGINE
START/STOP Button — Manual Transmission
Only
1. With the vehicle stopped, place the gear selector in NEUTRAL, then push and release the ENGINE
START/STOP button.
2. The ignition switch will return to the OFF position.
3. Place the gear selector in first gear or REVERSE and then apply the parking brake.
384 STARTING AND OPERATING

Extreme Cold Weather (Below –22°F Or 30°C)
To ensure reliable starting at these temperatures, use of
an externally powered electric engine block heater (avail-
able from your authorized dealer) is recommended.
If Engine Fails To Start
WARNING!
•Never pour fuel or other flammable liquids into
the throttle body air inlet opening in an attempt to
start the vehicle. This could result in a flash fire
causing serious personal injury.
•
Do not attempt to push or tow your vehicle to get it
started. Vehicles equipped with an automatic transmis-
sion cannot be started this way. Unburned fuel could
enter the catalytic converter and once the engine has
started, ignite and damage the converter and vehicle.
(Continued)
WARNING! (Continued)
•If the vehicle has a discharged battery, booster
cables may be used to obtain a start from a booster
battery or the battery in another vehicle. This type
of start can be dangerous if done improperly. Refer
to “Jump-Starting” in “What To Do In Emergen-
cies” for further information.
Clearing A Flooded Engine (Using ENGINE
START/STOP Button) — Automatic Transmission
Only
If the engine fails to start after you have followed the
“Normal Starting” or “Extreme Cold Weather proce-
dures, it may be flooded. To clear any excess fuel, press
and hold the brake pedal, press the accelerator pedal all
the way to the floor and hold it, then push and release the
ENGINE START/STOP button once. The starter motor
will engage automatically, run for 10 seconds, and then
386 STARTING AND OPERATING