2016 Citroen GRAND C4 PICASSO RHD headlamp

215
Directional lighting
When the dipped or main beam headlamps are o
n,   this   system   allows   the   light   beams   to   better  
f

ollow   the   road.
Associated
  with   xenon   headlamps,   this   system  
i

mproves   the   quality   of   lighting   when   cornering.
with directional lighting
without directional lightingOperating fault
This system is inactive:
-  w hen   stationary   or   at   low   speeds,
-
 w

hen
 r
everse
 is enga
ged. If
  a   fault   occurs,   these   warning   lamps  
c

ome   on   in   the   instrument   panel,  
a

ccompanied   by   an   audible   signal  
a

nd   a   message.
Contact   a   CITROËN   dealer   or   a   qualified  
w

orkshop.
The   directional   lighting   can   be   activated   or  
d

eactivated   in   the   touch   screen   tablet.
In the Driving
 

menu,   select   the   "Settings "
tab, then " Lighting"
  and   select   "Directional
headlamps ".
5
Lighting and visibility

263
Exiting economy mode
These functions are reactivated automatically next   time   the   vehicle   is   driven.
In
  order   to   restore   the   use   of   these   functions  
i

mmediately,   start   the   engine   and   let   it   run:
-
 
f
or   less   than   ten   minutes,   to   use   the  
e

quipment   for   approximately   five   minutes,
-
 
f
or   more   than   ten   minutes,   to   use   the  
e

quipment   for   up   to   approximately  
t

hirty minutes.
Let
  the   engine   run   for   the   duration   specified   to  
e

nsure   that   the   battery   charge   is   sufficient.
Do
  not   repeatedly   and   continuously   restart   the  
e

ngine   in   order   to   charge   the   battery.
A
  flat   battery   prevents   the   engine   from   starting.
For
  more   information   on   the   12 V batter y, refer
to
  the   corresponding   section.
Load reduction mode
System which manages the use of certain functions   according   to   the   level   of   charge  
r

emaining   in   the   battery.
When
  the   vehicle   is   being   driven,   the   load  
r

eduction   function   temporarily   deactivates  
c

ertain   functions,   such   as   the   air   conditioning,  
t

he   heated   rear   screen...
The
  deactivated   functions   are   reactivated  
a

utomatically   as   soon   as   conditions   permit.
Energy economy mode
Switching to economy
mode
A message appears in the instrument panel s
creen   indicating   that   the   vehicle   has   switched  
t

o   economy   mode   and   the   active   functions   are  
p

ut   on   standby.
If
  a   telephone   call   is   being   made   at   this   time,   it  
w

ill   be   maintained   for   around   10   minutes   with  
t

he   Bluetooth   hands-free   system   of   your   audio  
s

ystem.
System
  which   manages   the   duration   of   use   of   certain   functions   to   conserve   a   sufficient   level   of  
c

harge   in   the   battery.
After   the   engine   has   stopped,   you   can   still   use   functions   such   as   the   audio   and   telematics  
s

ystem, windscreen   wipers,   dipped   beam   headlamps, courtesy   lamps,   etc.   for   a   maximum  
c

ombined   duration   of   about   forty   minutes.
7
Practical information

270
1. Screenwash  and   headlamp   wash   reservoir.
2. C oolant r eservoir.
3.
 B

rake   fluid   reservoir.
4.
 B

attery   /   Fuses.
5.
 F

usebox.
6.
 A

ir   filter.
7.
 E

ngine   oil   dipstick.
8.
 E

ngine   oil   filler   cap.
9.
 R

emote   earth   point.
Petrol engines
Practical information

271
1. Screenwash  and   headlamp   wash   reservoir.
2. C oolant r eservoir.
3.
 B

rake   fluid   reservoir.
4.
 B

attery   /   Fuses.
5.
 F

usebox.
6.
 A

ir   filter.
7.
 E

ngine   oil   dipstick.
8.
 E

ngine   oil   filler   cap.
9.
 P

riming
 pu
mp*.
10.
 R

emote   earth   point.
Diesel engines
* According to engine.
7
Practical information

274
Coolant level
The coolant level should be close to   the   "MA X"   mark   but   should   never  
e

xceed   it.
In
 
addition,   as   the   cooling   system   is   pressurised,
 w

ait
 
at
 
least   one   hour   after   switching   off   the
 e

ngine
 
before   carrying   out   any   work.
To
 
avoid
 
any   risk   of   scalding,   unscrew   the   cap  
b

y
 
two
 
turns   to   allow   the   pressure   to   drop.  
W

hen
 
the
  pressure   has   dropped,   remove   the  
c

ap
 
and
 
top-up   the   level.
Fluid specification
The coolant must conform to the manufacturer's r ecommendations.
The cooling fan may star t after switching
off the engine: take care with ar ticles and
clothing that might be caught by the fan
blades. When   the   engine   is   warm,   the   temperature   of  
t

he   coolant   is   regulated   by   the   fan.To p p i n g - u p
The reservoir must be topped-up without delay b
y   a   CITROËN   dealer   or   a   qualified   workshop.
Diesel fuel additive level
(Diesel with particle filter)
The additive reservoir low level is indicated   by   fixed   illumination   of   this  
w

arning   lamp,   accompanied   by   an  
a

udible   signal   and   a   message   that  
t

he   particle   filter   additive   level   is  
t

oo low.
The
 
warning   lamp   comes   on   when   the   ignition  
i

s
 
switched   on,   or   every   time   the   stalk   is  
o

perated,
  until   the   reservoir   is   refilled.
Next
 
time
  you   stop,   refill   the   screenwash   /  
h

eadlamp
  wash   reservoir.
Screenwash/headlamp
wash level low
In the case of vehicles fitted with h
eadlamp   washers,   when   the   fluid r

eservoir   low   level   is   reached   this
 w

arning   lamp   comes   on   in   the
 i

nstrument   panel,   accompanied   by   an
 a

udible   signal   and   a   message. Avoid
  prolonged   contact   of   used   oil   or  
f

luids   with   the   skin.
Most
  of   these   fluids   are   harmful   to  
h

ealth   or   indeed   very   corrosive.
Do
  not   discard   used   oil   or   fluids   into  
s

ewers   or   onto   the   ground.
Take
  used   oil   to   a   CITROËN   dealer   or  
a

  qualified   workshop   (France)   or   to   an  
a

uthorised   waste   disposal   site.
Used products
Practical information

299
Changing a bulb
For H7 type bulbs with lugs... take care to observe their correct installation
so
  as   to   ensure   the   best   lighting  
p

erformance.
Risk of electrocution
Xenon bulbs (D5S-25W) must be replaced   by   a   CITROËN   dealer   or   a  
q

ualified
 w
orkshop.
Front lamps
Model with xenon headlamps
1. Directional   dipped   beam   headlamps  
(D5S-25W).
2.
 M

ain   beam   headlamps   (H7-55W).
3.
 D

aytime   running   lamps   /   sidelamps
 (

6   light   emitting   diodes   -   LEDs).
4.
 D

irection
 i
ndicators
 (

6   light   emittng   diodes   -   LEDs).
5.
 F

ront   foglamps   (H11-55W).
Model with halogen headlamps
1. Dipped  beam   headlamps   (H7-55W).
2. M ain   beam   headlamps   (H7-55W).
3.
 D

aytime
 r
unning
 lam
ps/sidelamps
 (

4   light   emitting   diodes   -   LEDs).
4.
 D

irection   indicators   (PW Y24W).
5.
 F

oglamps
 (
H11-55W). In
  some   weather   conditions   (e.g.   low  
t

emperature   or   humidity),   the   presence  
o

f   misting   on   the   internal   sur face   of   the  
g

lass   of   the   headlamps   and   rear   lamps  
i

s   normal;   it   disappears   after   the   lamps  
h

ave   been   on   for   a   few   minutes.
Light- emitting diodes - LEDs
For replacement, contact a CITROËN dealer or q
ualified w orkshop.
8
In the event of a breakdown

300
Directional dipped beam
headlamps (xenon model)Main beam headlamps (xenon model)
F Remove  the   protective   plastic   cover   by  p
ulling   the   tab.
F
 
P
ush   the   connector.
F
 
R
emove   the   bulb   and   change   it.
For
  reassembly,   carry   out   these   operations   in  
r

everse
 o
rder.
D5S
 
xenon
 
bulbs
 
must
 
be
 
changed
 
b

y
 
a
 
CITROËN
 
dealer
 
or
 
a
 
qualified
 
w

orkshop,
 
as
 
there
 
is
 
a
 
risk
 
of
 
el

ectrocution.
In the event of failure of one
of
 
the
 
D5S
 
bulbs,
 
it
 
is
 
recommended
 
t

hat
 
the
 
bulb
 
on
 
the
 
other
 
side
 
be
 
c

hanged
 
at
 
the
 
same
 
time.
The
 
headlamps
 
have
 
polycarbonate
 
l

enses
 
with
 
a
 
protective
 
coating:
F

d

o not clean them using a dr y
or abrasive cloth, nor with a
detergent or solvent product,
F
 
u

se
 
a
 
sponge
 
and
 
soapy
 
water
 
or
 
a
 
p

H
 
neutral
 
product,
F
 
w

hen
 
using
 
a
 
high
 
pressure
 
washer
 
o

n
 
persistent
 
marks,
 
do
 
not
 
keep
 
t

he
 
lance
 
directed
 
towards
 
the
 
l

amps
 
or
 
their
 
edges
 
for
 
too
 
long,
 
s

o
 
as
 
not
 
to
 
damage
 
their
 
protective
 
c

oating
 a

nd
 sea

ls.
Changing
 
a
 
bulb
 
should
 
only
 
be
 
done
 
a

fter
 
the
 
headlamp
 
has
 
been
 
switched
 
o

ff
 
for
 
several
 
minutes
 
(risk
 
of
 
serious
 
b

urns).
F
 
D

o
 
not
 
touch
 
the
 
bulb
 
directly
 
with
 
y

our
 
fingers,
 
use
 
a
 
lint-free
 
cloth.
It
 
is
 
imperative
 
to
 
use
 
only
 
anti-
ultraviolet
 
(UV)
 
type
 
bulbs
 
to
 
avoid
 
d

amaging
 t

he
 h

eadlamp.
Always
 
replace
 
a
 
failed
 
bulb
 
with
 
a
 
n

ew
 
bulb
 
with
 
the
 
same
 
type
 
and
 
s

pecification.
In the event of a breakdown

301
Dipped beam headlamps
(halogen model)
F Remove  the   protective   plastic   cover   by  p
ulling   the   tab.
F
 
P
ush   the   connector.
F
 
R
emove   the   bulb   and   change   it.
For
  reassembly,   carry   out   these   operations   in  
r

everse
 o
rder.
Main beam headlamps
(halogen model)
F Turn the protective plastic cover to remove   it.
F
 
D
isconnect   the   connector.
F
 
R
elease   the   clips.
F
 
R
emove   the   bulb   and   change   it.
For
  reassembly,   carry   out   these   operations   in  
r

everse
 o
rder.
8
In the event of a breakdown