2016 Citroen DS5 HYBRID start stop button
[x] Cancel search: start stop buttonPage 123 of 376
121
DS5_en_Chap04_conduite_ed02-2015
Operating fault
In the event of a fault in STOP mode, the
vehicle may stall.
All of the instrument panel warning lamps
come on.
It is then necessary to switch off the ignition
and start the engine again using the "S TA R T/
STOP " button.
In the event of a fault with the system, the
button in the "E
cO OF
F" switch flashes for a
few moments, then remains on.
Have it checked by a CITROËN dealer or a
qualified workshop. The Stop & Start system requires a
12
V b
attery of specific technology and
specification.
All work on this type of battery must be
carried out only by a CITROËN dealer
or a qualified workshop.
For more information on the 12 V
battery, refer to the corresponding
section.
driving
Page 129 of 376
127
DS5_en_Chap04_conduite_ed02-2015
F With the engine running, press button 1. The
activated/deactivated status when the engine was
switched off is retained when the engine is switched
on again.
The blade retracts automatically 3 seconds after switching
off the engine except in STOP mode of Stop & Start.
Activation / dea ctivation
F With the engine running, adjust the
b
rightness of the information using
button
3 :
- to
wards the rear to increase the
brightness,
-
to
wards the front to decrease the
brightness.
Brightness adjustment
We recommend that adjustments are
only made using these buttons when
the vehicle is stationary.
When stationary or while driving, no
objects should be placed around the
transparent blade (or on its cover) to
avoid blocking deployment of the blade
and preventing its correct operation.
In certain extreme weather conditions
(rain and/or snow, bright sunshine, ...)
the head-up display may not be legible
or may suffer temporary inter ference.
Some sunglasses may hamper reading
of the information.
To clean the transparent blade, use a
clean, soft cloth (such as a spectacles
cloth or microfibre cloth). Do not use
a dry or abrasive cloth or detergent or
solvent products as these could scratch
the blade or damage the anti-reflection
coating.
Height adjustment
F With the engine running, adjust the display
t o the required height using button 2 :
-
to
wards the rear to move the display up,
-
to
wards the front to move the display
down.
driving
Page 241 of 376
239
DS5_en_Chap09_verifications_ed02-2015
Fuel tankcapacity of the tank: approximately 60 litres.A dditions of fuel must be of at least 5 litres to
be registered by the fuel gauge.
Opening the filler cap may result in an inrush of
air. This vacuum is entirely normal and results
from the sealing of the fuel system.
F
Ta
ke care to select the pump that delivers
the correct fuel type for your vehicle's
engine (reminder on a label on the inside of
the filler flap).
F
Op
en the filler cap by turning it a 1/4 turn to
the left.
F
Re
move the filler cap and hang it on its
carrier (on the filler flap).
Opening
If you have put in the wrong fuel for
your vehicle, you must have have
the tank drained and refilled with
the correct fuel before you star t the
engine.
With Stop & Start, never refuel with the
system in STOP mode; you must switch
off the ignition with the START/STOP
button.
Refuelling
F Introduce the nozzle and push it in fully
(
pushing open the non-return valve A on
petrol vehicles).
F
Fi
ll the tank (don't continue past the third
cut-off of the nozzle, as this may cause
malfunctions).
F
Re
fit the filler cap turning it a 1/4 turn to the
right.
F
Pu
sh the filler flap to close it.
Your vehicle is fitted with a catalytic converter
which reduces harmful emissions in the
exhaust gas.
The filler neck is narrower and allows only
petrol nozzles to be used.
For a petrol engine, the use of unleaded fuel
is compulsory.
F
Pr
ess the switch
This switch remains active for a few minutes
after switching off the ignition. If necessary,
switch the ignition on again to reactivate it.
checks
Page 261 of 376
259
DS5_en_Chap09_verifications_ed02-2015
Never store bottles of AdBlue® in your
vehicle. Before topping-up, ensure that the vehicle is
parked on a flat and level sur face.
In wintry conditions, ensure that the
temperature of the vehicle is above -11°C.
Otherwise the AdBlue
® may be frozen and
so cannot be poured into its tank. Park your
vehicle in a warmer area for a few hours to
allow the top-up to be carried out.
Procedure
F Press the START/STOP button to switch
o ff the engine. F
Ra
ise the boot floor for access to the
AdBlue
® tank. Use an object, such as a
bag, to keep the left part up.
Recommendations on storage
AdBlue® freezes at about -11°C and
deteriorates above 25°C. It is recommended
that bottles be stored in a cool area and
protected from direct sunlight.
Under these conditions, the additive can be
kept for at least a year.
If the additive has frozen, it can be used once it
has completely thawed out.
checks
Page 341 of 376
15Hybrid4 system
Starting the Hybrid4 system
Activation of the Hybrid4 system
On activation of the Hybrid4 system, the
instrument panel lights up, the power indicator
needle is placed at position " 0
". The steering
column automatically unlocks (perceptible
noise and movement of the steering column).
Depending on certain parameters, such as the
state of charge of the high voltage battery or
the ambient temperature, the Hybrid4 system
itself determines whether it is necessary to
start the HDi Diesel engine.
The mode selector is at the AUTO
position.
In wintry conditions with the
engine cold, the Diesel pre-
heating warning lamp can stay
on for a few seconds; wait until
it goes off before releasing the
brake pedal.
Starting - switching off the Hybrid4 system
Never leave children alone inside the
vehicle when the Hybrid4 system is
active.
)
Place the gear selector at position N
.
)
Insert the electronic key in the reader.
or
)
With Keyless Entry and Starting, simply
having the electronic key inside the vehicle
is sufficient.
)
Press the brake pedal firmly.
)
Make a single short press (about one
second) on the " START/STOP
" button.
)
Maintain pressure on the brake pedal until
the READY
lamp comes on, signalling
activation of the Hybrid4 system, confirmed
by an audible signal.
If the Hybrid4 system does not activate:
)
If N
is flashing in the instrument
panel, move the gear selector to
position A
then to position N
.
)
If the " Foot on the brake
" is
displayed, press the brake pedal
firmly.
The READY
lamp may come on after
a few seconds if there is a demand
for activation of the Hybrid4 system
after energy economy mode has been
entered.
Page 343 of 376
17Hybrid4 system
Switching off the Hybrid4 system
)
Immobilise the vehicle.
)
Place the gear selector in position N
.
)
Make a short press (about one second) on
the " START/STOP
" button.
The Hybrid4 stops:
- the READY
lamp goes off,
- the steering column locks,
- the electric parking brake is applied
automatically, unless its automatic mode is
deactivated.
)
Check that the parking brake warning
lamps are on.
)
Remove the electronic key from the reader.
Before doing anything under the
bonnet, the Hybrid4 must be switched
off ( READY
lamp off) and the electric
parking brake must be applied.
Check that the READY
lamp is off
before leaving the vehicle.
Never leave the electronic key in the
vehicle in your absence.
For reasons of safety and theft protection,
do not leave your electronic key in the
vehicle, even when you are close to it.
It is recommended that you keep it on
your person.
Switching the ignition on
With the electronic key in the reader or the
Keyless Entry and Starting key inside the
vehicle, pressing the " START/STOP
" button,
with no action on the brake pedal
, allows the
ignition to be switched on.
)
Press the " START/STOP
"
button, the instrument panel
comes on but the Hybrid4 system
does not start up.
With the ignition on, the system goes
into energy economy mode when
necessary to maintain the state of
charge of the battery.
)
Press this button again to switch off the
ignition and so allow the vehicle to be
locked.
Page 344 of 376
Back-up starting / emergency switching off
Back-up starting with the
Keyless Entry and Starting
system
When the electronic key is in the recognition
zone and after pressing the " START/STOP
"
button, the Hybrid4 system does not start up:
)
Insert the electronic key in the reader.
)
Place the gear selector at position N
.
)
Press the brake pedal firmly.
)
Press the " START/STOP
" button.
The Hybrid4 starts up; the READY
lamp is on.
Electronic key not recognised
with Keyless Entry and Starting
If the electronic key is no longer in the
recognition zone when driving or when you
(later) request switching off of the Hybrid4
system, a message appears in the instrument
panel.
)
Press and hold the " START/STOP
" button
for about 3 seconds if you want to force the
Hybrid4 system to switch off. In the event of an emergency only, the engine
can be switched of without any conditions.
)
To do this, press and hold the " START/
STOP
" button for about 3 seconds.
In this case the steering column locks as soon
as the vehicle stops.
The electronic key must always remain
inside the vehicle when in use.
Emergency switching off
Note that restarting will not be possible
without the presence of the electronic
key in the recognition zone.
Page 348 of 376
"ECO OFF" function
This function prevents the HDi Diesel engine being
switched off and ensures that a comfortable temperature
can be maintained in the passenger compartment.
This therefore allows the air conditioning or heating to be
kept running.
Depending on version, the control is either in
the switch panel alongside the steering wheel,
or in the " Driving
" menu of the touch screen.
On pressing the ECO OFF
switch, the
HDi Diesel engine restarts immediately and
then operates continuously.
The indicator lamp in the control comes on.
Pressing this control again deactivates the
function.
The indicator lamp in the control goes off.
The Hybrid4 system returns to normal
operation.
*
Except in ZEV mode, which gives preference
to electric running over maintaining a
comfortable temperature.
The function is deactivated on
switching off the ignition.
During phases of electric running and
when the internal combustion engine is
stopped, the Hybrid4 system manages
restarting automatically to maintain
the temperature in the passenger
compartment * .
However, variations in temperature
may still be felt in very high ambient
temperatures.
In this case, activate the ECO OFF
function.
With the switch on the dashboard
)
Press this switch.
Deactivation is confirmed by the illumination of
the indicator lamp in the control switch and the
display of a message.
Pressing the switch again reactivates the
system.
The indicator lamp in the switch goes off,
accompanied by the display of a message.
With the touch screen button
Pressing the button again reactivates the
system.
The indicator lamp for the button goes off,
accompanied by the display of a message.
)
Select the "Driving"
menu.
Deactivation is confirmed by the illumination of
the indicator lamp for the button and the display
of a message.
)
In the page, press this button.