119
C1_en_Chap06_securite_ed01-2016
Deactivating the passenger's
front airbag
Only the passenger's front airbag can be deactivated.
F
W
ith the ignition off ,
insert the key in the
p
assenger airbag deactivation switch.
F
T
urn it to the "OFF"
p
osition.
F
R
emove the key keeping the switch in the
n
ew position.When
the ignition is on, this warning
l
amp comes in the seat belt and
p
assenger's front airbag display
s
creen. It stays on while the airbag is
d
eactivated. To
assure the safety of your child,
t
he passenger's front airbag must be
d
eactivated when you install a rear ward
f
acing child seat on the front passenger
sea
t.
Other wise, the child would risk being
s
eriously injured or killed if the airbag
w
ere deployed.
Reactivating the passenger's
front airbag
When you remove a rear ward facing child seat, w
ith the ignition off , turn the switch to the
"ON"
position to reactivate the airbag and so
a
ssure the safety of your front passenger in the
e
vent of an impact.
When
the ignition is switched on, this
w
arning lamp comes on in the seat
b
elt and passenger's front airbag
d
isplay screen. It stays on while the
f
ront airbag is activated.
Operating fault
Illumination of this warning lamp in the instrument panel indicates a fault
w
ith the airbags.
Contact
a
CITROËN dealer or a qualified
w
orkshop
without delay to have the system
c
hecked.
The airbags may no longer be
d
eployed
in the event of a serious impact.
In
this
case, do not install a child seat or seat
a
n
adult
on the front passenger seat.
6
Safety
166
C1_en_Chap08_en-cas-pannes_ed01-2016
1. Brake lamps (P21/5W)
2. S idelamps ( P21/5W)
3.
D
irection indicators (PY21W)
4.
R
eversing lamp (P21W), near side
F
oglamp (P21W), offside
Rear lamps
These bulbs are changed by removing the lamp unit:
F
O
pen the boot.
F
T
ip the plastic cover and remove the screw.
F
M
ove the boot trim firmly aside.
D
eformation of the trim is normal.
F
U
nscrew the nut and remove it (take care
n
ot to drop it in the wing).
F
R
emove the lamp unit by pulling it firmly
o
utwards. F
A t the back of the lamp, remove the failed
b
ulb and change it.
When
refitting, proceed in the reverse order,
t
aking care to position the lamp unit correctly.
In the event of a breakdown
