Page 63 of 296
61
Berlingo-2-VP_en_Chap04_Ergonomie_ed01-2016
2 Fast wipe (heavy rain).
1
Normal
wipe (moderate rain).
l
Intermittent
wipe.
0
Of
f.
â
Single wipe
(press
downwards).
In the Intermittent
position, the wiping
speed is in proportion to the vehicle
speed.
WIPERS
Manual wipingWhenever the ignition has been
switched off for more than one minute,
with
the windscreen wiper stalk in
position
2, 1 or I, the stalk must be
reactivated.
-
Move
the stalk to any position.
-
Return
it to the desired position.
d
o not cover the rain sensor,
located in the centre of the
windscreen,
behind the mirror.Activation
Press
the control downwards.
a ctivation of the function is
accompanied by a message in the
screen.
Deactivation
Place
the windscreen wipers stalk in
position
I, 1 or 2.d
eactivation of the function is
accompanied by a message in the
screen.
In
the event of malfunction of the
automatic
windscreen wipers, the
windscreen wipers will operate in
intermittent
mode.
Contact a CITR
o Ë n dealer or a
qualified
workshop to have the system
checked. In the
AUTO position, the windscreen
wipers operate automatically and
adapt their speed to the intensity of the
rainfall.
When not in
AUTO mode, for the
other
positions, refer to the manual
windscreen
wipers section.
The automatic rain sensitive
windscreen
wipers function must
be
reactivated by pressing the stalk
downwards, if the ignition has been
switched
off for more than one minute.
When using an automatic car
wash, switch of
f the ignition to
avoid
triggering the automatic
wiping.
In winter
, it is advisable to wait for the
windscreen
to completely clear of ice
before
operating the automatic wipers.
Automatic wipers
Steering mounted controls
EaSE oF USE and CoMFoRT
4
Page 115 of 296
11 3
Berlingo-2-VP_en_Chap04_Ergonomie_ed01-2016
ELECTRIC WINDOWS
Lower the window fully, then raise it, it
will rise in steps of a few centimetres
each
time the control is pressed.
Repeat the operation until the window
is
fully closed.
Continue to press the control for at
least one second after the window
closed
position has been reached.
The safety anti-pinch does not operate
during
these operations.
Safety anti-pinch
When the window rises and meets an obstacle, it stops and partially lowers.
Manual mode
This mode is available depending on equipment; it is
identified
by this symbol on the
control
in question.
Good practice
If the electric windows meet an obstacle during operation, you must
reverse
the movement of the window.
T
o
do
this,
press
the
control
concerned.
When the driver operates the
passenger electric window controls,
they
must ensure that no one is
preventing correct closing of the
windows.
The
driver must ensure that the
passengers use the electric windows
correctly
.
Be aware of children when operating
the
windows.
Following
several consecutive closing/
opening operations of the electric
window
control, a protection system
is triggered which only allows closing
of
the window.
After
closing, wait
approximately
40 minutes. Once this
time
has elapsed, the control becomes
operational
again.
1.
d
river's side
2.
Passenger's side
Reinitialisation
Following reconnection of the battery,
or in the event of a malfunction, the
safety
anti-pinch function must be
reinitialised. The electrical functions of the electric
windows
are deactivated:
-
approximately
45 seconds after the
ignition is switched of
f,
-
after one of the front doors is
opened,
if the ignition is off.
There
are
two
operating
modes:
Press or pull the control, without
passing
the
point
of
resistance.
The window stops when you release
the
control.
One-touch mode
Press or pull the control, beyond the
point
of resistance.
The window opens or closes fully when
the
control is released.
Pressing or pulling the control again
stops
the movement of the window.
EaSE oF USE and CoMFoRT
4
Mirrors and windows
Page 189 of 296
187
Berlingo-2-VP_en_Chap08_aide-rapide_ed01-2016
Dashboard fuses
Tilt the cover to gain access to the
fuses.Fuses
F Amperes Aa
llocation
1 15 Rear wiper
2 -
n
ot used
3 5
a
irbag
4 10 Air
conditioning, diagnostic socket, mirror control,
headlamp
beam
5 30 Electric windows
6 30 Locks
7 5Rear
courtesy lamp, front map reading lamp, roof
console
8 20 Audio
equipment, screen, tyre under-inflation
detection,
alarm and siren
9 30Front
and rear 12V socket
10 15 Central
column
11 15 Low current ignition switch
12 15 Rain and sunshine sensor, airbag
13 5 Instrument
panel
14 15 Parking
sensors, digital air conditioning controls,
hands-free
phone kit
15 30 Locks
16 -
n
ot used
17 40Rear
screen/mirrors demist/defrost
QUICk HELP
8
Changing a fuse
Page 203 of 296
Audio and Telematics
201
Berlingo-2-VP_en_Chap10a_SMEGplus_ed01-2016
7-inch touch screen tablet
GPS satellite navigation - Multimedia audio - Bluetooth® telephone
Contents
First steps
2 02
Steering
mounted
controls
2
04
Menus
205
na
vigation
206
na
vigation - Guidance
2
14
Tr a f fi c
2
18
Radio Media
2
20
Radio
226
d
a
B (di
gital
a
u
dio Broadcasting) radio
2
28
Media
230
Settings
234
Connected services
2
42
Internet browser
2
43
MirrorLink
TM 246
C
arPlay® 250
T
elephone
254
Frequently
asked questions
2
62
The
system
is
protected
in
such
a
way
that
it
will
only
operate
in
y
our
vehicle. As
a
safety
measure,
the
driver should only carry out operations
w
hich
require
prolonged
attention while the vehicle is stationary.
The
display
of
an
energy
economy mode message signals that
e
lectrical
systems
operating
are going into standby.
Refer
to
the
energy
economy mode section.
TECHNOLOGY on BOARD
10
