2016 BUICK ENVISION window

2
Power
Liftgate Control
Power Mirror/
Window
Controls
Instrument Panel
Driver
Information
Center Controls/ Audio Steering
Wheel Controls Engine
Start/Stop Button
Cruise Control/Forward
Collision Alert/Heated Steering Wheel/Voice Recognition Buttons Tilt/
Telescoping Steering
Wheel Lever
Head-Up
Display
Controls
F
Symbols
Check Engine
Engine Oil Pressure
Lane Keep Assist
Airbag Readiness
Cruise Control Set
Service Electric Parking Brake

Traction Control/
StabiliTrak Active

Charging System
Security
Engine Coolant
Temperature

Brake System
Warning
BRAKE Electric Parking
Brake
Power
Door Lock Buttons Turn Signal
Lever/
IntelliBeam Button
F
Driver
Information Center Hazard
Warning Flashers Button
Windshield
Wipers Lever
Memory
Seat Buttons Exterior/
Interior Lamp
Controls

4
Remote Keyless Entry Transmitter
Keyless Access System
F Optional equipment
Unlock
Press to unlock the
driver’s door. Press
again to unlock all
doors.
Power Liftgate
Press twice to open or
close the liftgate. Press
once to stop power liftgate operation.
Lock
Press to lock all doors.
Vehicle Locator/Panic Alarm
Press and release to locate your vehicle.
The exterior lamps will flash and the horn
will sound.
Press and hold to activate the alarm. Press
it again to cancel the alarm.
Note: To change the remote lock, unlock, and
remote start settings, go to Remote Lock, Unlock,
Start in the Vehicle Settings menu.
Remote Vehicle Start
Press and release the
Lock button and
then immediately press and hold the

button until the turn signal lamps flash to
start the engine from outside the vehicle.
After entering the vehicle, turn on the
ignition.
• During a remote start, the engine will
run for 10 minutes. Repeat these steps
to run the engine for an additional 10
minutes. A remote start can be extend
-ed once.
• Press and hold the
button until
the parking lamps turn off to cancel a
remote start.
Remote Start and Heated Seats: Select
the remote start heated seat option in the
Vehicle Settings to have the heated seats
turn on during a remote start. The heated
seat button indicators do not illuminate
and the temperature of the unoccupied
seat may be reduced during a remote start.
See Keys, Doors and Windows in your Owner Manual.
The Keyless Access System enables operation of the doors, igni-tion and liftgate without removing the Remote Keyless Entry
transmitter from your pocket or purse. The transmitter must be within 3 feet of the door being unlocked or the liftgate.
Keyless Unlocking
With the transmitter within range:
Press the lock button on the driver’s door handle to unlock
the driver’s door; press it again within 5 seconds to unlock all doors.
Press the lock button on a passenger door handle to unlock all doors.
Press the touchpad on the liftgate handle to open the liftgate.
Keyless Locking
With the ignition off, the transmitter removed from the vehicle, and all doors closed:
Press the lock button on any door handle to lock all doors immediately.
If Passive Locking is turned on, all doors will lock automatically after a short delay.
Note: To change the Keyless Locking and Unlocking settings, go to Remote Lock, Unlock, Start in the
Vehicle Settings menu.
See Keys, Doors and Windows in your Owner Manual.

5
Pushbutton Start
Auto Engine Stop/Start
Start
With the vehicle in Park or Neutral, press
the brake pedal and then press the
ENGINE START/STOP button to start the
engine. The green indicator on the button
will illuminate.
Note: The transmitter must be in the vehicle to turn
on the ignition. If the transmitter battery is weak,
place the transmitter in the front cupholder to
enable the engine to start. Replace the transmitter
battery as soon as possible.
Stop/Off
Shift to Park and press the ENGINE START/STOP button to turn off the engine.
Power will be available for 10 minutes to operate the audio system until the driver’s door
is opened and to operate the windows and sunroof
F until any door is opened.
Accessory Mode
With the engine off and the brake pedal NOT depressed, press the ENGINE START/
STOP button to place the ignition system in the accessory mode. The amber indicator
on the button will illuminate.
See Driving and Operating in your Owner Manual.
A fuel-saving stop/start system has been integrated with the 2.0L engine. While driv-ing, when the brake pedal is applied and the vehicle is at a complete stop, the automatic
engine stop/start system may turn off the engine, depending on operating conditions.
When the engine is off, the tachometer gauge will read AUTO STOP. Upon releasing the
brake pedal or applying the accelerator pedal, the engine will restart. After parking the
vehicle and turning off the engine, the tachometer gauge will read OFF.
The engine may remain running or restart if:
• A minimum vehicle speed is not reached.
• The engine or transmission is not at the required operating temperature.
• The outside temperature is not in the required operating range.
• The shift lever is in any gear other than Drive (D).
• The battery charge is low.
• The current settings for the climate control or defog system have not been reached.
• The Auto Stop time is greater than 2 minutes.
See Driving and Operating in your Owner Manual.

7
Rear Seat Adjustment
To slide the seat forward or rearward, lift
the bar (A) under the seat cushion and
slide the seat.
Reclining the Seatback
To recline the seat cushion, pull the lever
(B) on the side of the seatback and move
the seatback to the desired position.
Release the lever.
Folding the Seatback
1. Press the button on the side of the head
restraint. It will fold automatically.
2. Pull the lever (B) on the side of the seat
cushion and fold the seatback forward or
pull the release lever located on the side of
the cargo area.
To raise the seatback, pull the lever on the
side of the seat cushion and push the
seatback rearward until it locks in the
upright position. Adjust the seatback.
See Seats and Restraints in your Owner Manual.
F Optional equipment
Rear Seats
Power Liftgate
Open/Close the Power Liftgate
Press the Power Liftgate button on the RKE transmitter twice.
Press the Power Liftgate knob on the driver’s door.
Press the touchpad on the liftgate handle to open the liftgate.
Press the button next to the liftgate pull to close the liftgate.
Programming the Liftgate Height
1. Turn the Power Liftgate knob to the 3/4 mode position.
2. Open the liftgate.
3. Adjust the liftgate manually to the desired height.
4. To save the setting, press and hold the button next to the liftgate pull for 3 seconds.
The turn signals will flash when the setting is saved.
Hands-Free Operation
To open or close the liftgate hands-free, kick your foot under the left side of the rear
bumper. The RKE transmitter must be within 3 feet of the liftgate.
See Keys, Doors and Windows in your Owner Manual.
A
B

13
OnStar® with 4G LTE and Wi-Fi®
Vehicle Personalization
Windshield Wipers
With OnStar 4G LTE and Wi-Fi, up to seven devices (smartphones, tablets and laptops)
can be connected to high-speed Internet through the vehicle’s built-in Wi-Fi hotspot.
To retrieve the SSID and password for the hotspot, press the OnStar Voice Command
button on the overhead console or rearview mirror, wait for the prompt, and then say
“Wi-Fi settings.” The information will be displayed on the screen.
For assistance, press the blue OnStar button or call 1-888-4-ONSTAR (1-888-466-7827).
Note: See onstar.com for a detailed instruction guide, vehicle availability, details, and system
limitations.
See Infotainment System in your Owner Manual.
Some vehicle features can be customized using the Settings menus and the touch screen
buttons. The Settings menus may include Time and Date, Language, Radio, Vehicle,
Bluetooth, Display, Rear Camera, Return to Factory Settings and others.
1. Press the MENU knob or touch Settings on the Home page.
2. Select the desired menu item.
3. Select the desired feature and setting.
4. Press
BACK to exit each menu.See Instruments and Controls in your Owner Manual.
Raise or lower the lever to activate the wipers.HI Fast Wipes
LO Slow Wipes
INT Intermittent (Rainsense)
Rotate the band to adjust the delay
between wipes. The wipers activate more
often as the band is rotated upward.
OFF
1x Single Wipe
Washer Fluid
Pull the lever toward you to spray washer
fluid on the windshield.

REAR OFF–INT–ON
Rear Washer Fluid
Push the lever away from you to spray
washer fluid on the rear window.
See Instruments and Controls in your Owner Manual.
Rear Wiper and Washer
Turn the end of the lever to activate the
rear wiper.

14F Optional equipment
Automatic Climate Controls
Driver’s
Temperature ControlREAR Rear Window Defog/Heated Outside Mirrors Control Defrost Mode Passenger’s
Temperature Control
Driver’s
Heated/
Cooled Seat Control
F
Passenger’s Heated/
Cooled Seat Control
F
Recirculation Mode Power
On/Off AC
Air
Conditioning Control SYNC Link passenger’s
temperature
setting to driver’s temperature setting
AUTO Automatic
Operation
Automatic Operation
Press AUTO.
Set the temperature.
The system automatically controls the fan speed, air delivery, air conditioning and recir
-culation to reach the set temperature. Allow time for the system to reach the desired
temperature. If the fan speed or air delivery mode is manually adjusted, automatic
operation is canceled.
Rear Climate Controls
The rear climate control settings can be adjusted using the rear climate control buttons
on the rear of the center console or the touch screen. The front climate controls must be
on to use the rear controls.
See Climate Controls in your Owner Manual.
Fan Speed
Controls
Air Delivery Modes Defog Vent Floor