Auxiliary Electrical Outlet (Power Outlet)........108
Battery ............................ .129, 274
Charging System Light ...................129
Keyless Transmitter Replacement (RKE) ........20
Belts, Seat ...............................69
Body Mechanism Lubrication .................276
B-Pillar Location ......................... .212
Brake Fluid ............................ .327
Brake, Parking .......................... .195
Brakes ................................ .292
Brake System ........................ .197, 292
Anti-Lock (ABS) ....................... .199
Master Cylinder ....................... .292
Parking ............................. .195
Warning Light ........................ .123
Break-In Recommendations, New Vehicle .........67
Bulb Replacement ..................... .310, 312Bulbs, Light
.......................... .70, 310
Capacities, Antifreeze (Engine Coolant) ..........325
Capacities, Fluid ......................... .325
Caps, Filler Oil (Engine) .......................... .272
Carbon Monoxide Warning ................68, 240
Car Washes ............................ .299
Cellular Phone .......................... .165
Chains, Tire ............................ .229
Chart, Tire Sizing ........................ .207
Check Engine Light (Malfunction Indicator Light) . .267
Checking Your Vehicle For Safety ...............67
Checks, Safety ............................67
Child Restraint ........................ .56, 62
Clean Air Gasoline ....................... .237
Cleaning Wheels .............................. .300
Windshield Wiper Blades ..................277
10
INDEX 355
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.
