2016 Alfa Romeo 4C engine overheat

Warning lights on
displayWhat it means What to do
redENGINE COOLANT TEMPERATURE TOO HIGH
The digital warning light switches on when the
key is turned to MAR-ON, but it should switch off
after a few seconds. The warning light turns on
when the engine is overheated.
The display shows the dedicated message.In normal driving conditions: stop the car, switch off the engine
and check that the water level in the reservoir is not below the
MIN mark. In this case, wait for the engine to cool down, then
slowly and carefully open the cap, top up with coolant and
check that the level is between the MIN and MAX marks on
the reservoir itself. Also check visually for any fluid leaks.
Should the warning light turn on again at the next start-up,
contact a dedicated Alfa Romeo Dealership.
If the car is used under demanding conditions (e.g. in
high-performance driving): slow down and, if the warning light
stays on, stop the car. Wait for 2 or 3 minutes with the engine
running and slightly accelerated to further favour the coolant
circulation. Then stop the engine. Check that the coolant level
is correct as described above.
IMPORTANT Over demanding routes, it is advisable to keep
the engine on and slightly accelerated for a few minutes before
switching it off.
Warning lights on
displayWhat it means What to do
redALTERNATOR FAILURE
The digital warning light switches on, only with engine
started, when an alternator fault is detected.Contact a dedicated Alfa Romeo Dealership as soon as
possible.
76
KNOWING THE INSTRUMENT PANEL

Warning lights on
displayWhat it means What to do
redGEARBOX FAILURE
The digital warning light switches on when the key is
turned to MAR-ON, but it should switch off after a few
seconds.
The digital warning light flashes (together with a
message in the display and an acoustic signal) to
indicate that the transmission is faulty.
The digital warning light can light up even in the event of
transmission overheating, after a particularly demanding
use. In this case an engine performance limitation is
carried out.Contact a dedicated Alfa Romeo Dealership as soon as
possible.
If it is necessary to start the engine with a
gearbox/transmission failure, follow the procedure
described in the "Using the gearbox/transmission"
paragraph, "Starting the engine" section in the "Starting
and driving" chapter.
redDOOR OPEN
(for versions/markets, where provided)
The digital warning light on the display switches on
when one or more doors are not properly shut. An
acoustic signal is activated with the doors open and the
car moving.
amberBRAKE PAD WEAR
(for versions/markets, where provided)
The digital warning light on the display switches on
when the front or rear brake pads are worn.
The display shows the dedicated message.Have them replaced as soon as possible.
amberALFA ROMEO CODE SYSTEM FAILURE
(for versions/markets, where provided)
The digital warning light switches on in the display
(together with a message) to indicate Alfa Romeo CODE
system failure.Contact a dedicated Alfa Romeo Dealership as soon as
possible.
77

Warning lights on
displayWhat it means What to do
GENERAL FAILURE
(for versions/markets, where provided)
The symbol lights up in the display in the circumstances
indicated below.
Engine oil pressure sensor failure
The symbol lights up when the engine oil pressure
sensor is faulty. The display shows the dedicated
message.In this case contact a dedicated Alfa Romeo Dealership
to have the fault fixed as soon as possible.
Clutch overheating message
The
symbol, together with a message on the display,
lights up to indicate clutch overheating.
If the driver continues, thesymbol will switch
off and the
warning light will light up (on some
versions together with a message on the display)
to indicate a transmission failure.
If thesymbol lights up along with a message on the
display, reduce gear shifting and/or change usage
conditions, until the normal operating conditions are
restored.
If the
warning light lights up (a message will appear
on the display, on some versions) stop immediately,
operate the handbrake, switch off the engine and wait 5
minutes: after this, normal transmission operating
conditions will be restored.
Should the transmission failure condition persist,
contact the dedicated Alfa Romeo Dealership
FUEL CUT-OFF
The symbol and the corresponding message are shown
on the display in the following cases:
fuel cut-off system intervention: the yellow
symbol lights up;
fuel cut-off system failure: the red symbol
lights up.
For the fuel cut-off system reactivation procedure, refer
to the "Fuel Cut-Off System" section of the "Controls"
paragraph, in the "Knowing your car" chapter. If it is still
not possible to restore the fuel supply, contact a
dedicated Alfa Romeo Dealership.
80
KNOWING THE INSTRUMENT PANEL

5 = fifth gear;
6 = sixth gear;
R = reverse.
The car always starts in neutral. When
1st gear is requested, the system
forces the selection ofAUTOmode.
IMPORTANT If 10 seconds elapse with
the ignition key in theMAR-ON
position and the display does not show
the gear engaged, turn the key to the
STOPposition, wait for the display to
switch off and then repeat the
procedure. If the fault persists, contact
a dedicated Alfa Romeo Dealership.
ACOUSTIC SIGNAL
For safety reasons, an acoustic signal is
emitted when the car is parked with the
transmission in neutral (N) (the signal
can be heard when the ignition key is
turned toSTOP).
With the car stationary, the engine
started and (1st) gear or (R) engaged,
the system activates the acoustic signal
and automatically places the
transmission in neutral (N) when:
the accelerator and/or brake pedal
are not operated for at least 3 minutes;
the brake pedal is pressed for longer
than 10 minutes;
the driver's door is opened and the
accelerator pedal or the brake pedal are
not operated for at least one and a half
seconds;
a fault has been detected in the
transmission.
PARKING THE CAR
When parking and leaving the car,
proceed as follows:
engage a gear (1st gear if facing
uphill or reverse if facing downhill) and
leave the wheels turned;
stop the engine and engage the
handbrake.
Block the wheels with a wedge or a
stone if the car is parked on a steep
slope.
Wait until the indication of the gear
engaged disappears on the display
before releasing the brake pedal.
IMPORTANT:NEVERleave the car with
the transmission in neutral.
GENERAL WARNINGSWith car stationary and gear
engaged, always keep the brake pedal
pressed until you decide to set off, then
release the brake and accelerate
gradually.
During prolonged stops with the
engine running, it is advisable to keep
the transmission in neutral (N).
In order to safeguard the efficiency of
the clutch, do not use the accelerator
to keep the car stationary (e.g. when
stopped on an incline). The clutch could
overheat and be damaged: use the
brake pedal or the handbrake and onlyoperate the accelerator pedal when you
decide to set off.
If, with reverse gear (R) engaged,
you have to engage 1st gear or vice
versa, only do this when the car is
completely stationary and with the
brake pedal pressed.
If it is necessary to proceed downhill
with transmission in neutral (N) for
unexpected reasons, bearing in mind
that this practice is highly inadvisable,
remember that when gear engagement
is requested, the system will
automatically engage the best gear to
permit the correct transmission of drive
torque to the wheels, according to the
speed of the car.
When necessary, it is possible to
engage 1st gear, reverse (R) or neutral (
N) with the engine off, the key at
MAR-ON and the brake pressed. In this
case, change gear leaving at least 5
seconds between one gear change and
the next, in order to safeguard the
operation of the hydraulic system, and
the pump in particular.
For uphill departures, it is advisable
to accelerate gradually but fully
immediately after releasing the
handbrake or the brake pedal; this
allows the engine to temporarily
increase the number of revs and tackle
the steepest gradients with more torque
at the wheels.
100
STARTING AND DRIVING