2016.5 VAUXHALL MERIVA clock

Vehicle care183Sidelight/Daytime running lightSidelight and daytime running lights
are designed as LEDs. In case of
failure, have LEDs replaced by a workshop.
Fog lights
The bulbs are accessible from the
underside of the vehicle.
1. Turn the bulb holder anticlockwise
and remove it from the reflector.
2. Disengage the bulb holder from the plug connector by pressing
the retaining lug.
3. Remove and replace the bulb holder with bulb.
4. Attach the plug connector.
5. Insert the bulb holder into the reflector.
6. Turn the bulb holder clockwise and engage.
Front turn signal lights
1. Rotate the bulb holder anticlockwise and remove it.

184Vehicle care
2. Rotate bulb anticlockwise andremove from bulb holder.
3. Replace bulb.
4. Insert the bulb holder into the reflector and rotate clockwise.
Tail lights
1. Release the cover and remove it.
2. Unscrew the two plastic securing nuts from the inside by hand.
3. Carefully withdraw the lightassembly from retaining pins and
remove. Make sure that the cable duct remains in position.
4. Detach the wiring plug from the bulb carrier.

186Vehicle care2. Press the retaining lug andremove the bulb carrier
downwards.
3. To replace the reverse light bulb (1 ), remove and replace the bulb.
To replace the tail light/rear fog
light bulb ( 2), push the bulb
slightly into the socket, rotate
anticlockwise, remove and
replace the bulb.
4. Insert the bulb carrier into the retainer.
5. Attach the cover.
6. Switch on the ignition, operate and check all lights.
For replacing the tail light bulb and
reverse light bulb on the right side of
the tailgate frame, proceed in the
same way.
Version with Light Emitting Diode
(LED):
Only the reverse light bulb can be
changed.
1. Open the tailgate and remove the
cover with a screwdriver.
2. Rotate the bulb holder anticlockwise to disengage.
Withdraw the bulb holder.
3. To replace the reverse light bulb, push the bulb slightly into the
socket, rotate anticlockwise,
remove and replace the bulb.
4. Insert bulb holder and turn clockwise.
5. Attach the cover.

Vehicle care187Side turn signal lights
To replace bulb, remove lamp
housing:
1. On left vehicle side, slide lamp to the front and remove it out of the
front wing with the rear end.
On right vehicle side, slide lamp to
the rear and remove it out of the front wing with the front end.
2. Turn bulb holder anticlockwise and remove from housing.
3. Pull bulb from bulb holder and replace it.
4. Insert bulb holder and turnclockwise.
5. On left side: insert front end into front wing, slide forward and insert
rear end.
On right side: insert rear end into
front wing, slide rearward and
insert front end.
Number plate light
1. Insert screwdriver in recess of the
cover, press to the side and
release spring.

188Vehicle care
2. Remove lamp downwards, takingcare not to pull on the cable.
3. Remove bulb holder from lamphousing by turning anticlockwise.
4. Pull bulb from bulb holder andreplace it.
5. Insert bulb holder into lamp housing and turn clockwise.
6. Insert lamp into bumper and let engage.
Interior lights
Courtesy light, reading lights Have bulbs replaced by a workshop.
Load compartment light
Have bulbs replaced by a workshop.
Instrument panel illumination
Have bulbs replaced by a workshop.Electrical system
Fuses Data on the replacement fuse must
match the data on the defective fuse.
There are three fuse boxes in the
vehicle:
● in the front left of the engine compartment
● in left-hand drive vehicles, in the interior behind the storage
compartment, or, in right-hand
drive vehicles, behind the
glovebox
● behind a cover on the left side of the load compartment
Before replacing a fuse, turn off the
respective switch and the ignition.
A blown fuse can be recognized by its melted wire. Do not replace the fuse
until the cause of the fault has been
remedied.
Some functions are protected by
several fuses.
Fuses may also be inserted without existence of a function.

Vehicle care211Storing a replaced wheel in the
spare wheel well using an
extension bar
Use the extension bar placed in the
tool box. Vehicle tools 3 194.
● Turn the wing nut anticlockwise and remove temporary spare
wheel.
● Take the extension bar from the tool box and screw it on the bolt.
● Store the damaged wheel and secure it by turning the wing nut
clockwise.
The floor cover can be placed on the
projecting wheel.
Remove the extension bar before
fitting the spare wheel in the well after renewing or repairing the defective
wheel.9 Warning
Storing a jack, a wheel or other
equipment in the load
compartment could cause injury if they are not fixed properly. During a sudden stop or a collision, loose
equipment could strike someone.
Store jack and tools always in the
respective storage compartments
and secure them by fixing.
Place the damaged wheel always
in the load compartment secured
by the strap or in the spare wheel
well secured by the wing nut.
Temporary spare wheel
Caution
The use of the temporary spare
wheel could affect driveability.
Have the defective tyre renewed
or repaired as soon as possible.
Only mount one temporary spare
wheel. The permissible maximum
speed on the label on the temporary
spare wheel is only valid for the
factory-fitted tyre size.
If your vehicle gets a flat tyre in the
rear while towing another vehicle,
mount the temporary spare wheel in
the front and the full tyre in the rear.
Tyre chains 3 201.
Spare wheel with directional tyre If possible, fit directional tyres such
that they roll in the direction of travel.
The rolling direction is indicated by a
symbol (e.g. an arrow) on the
sidewall.
The following applies to tyres fitted
opposing the rolling direction:
● Driveability may be affected. Have the defective tyre renewed
or repaired as soon as possible
and fit it instead of the spare
wheel.
● Drive particularly carefully on wet
and snow-covered road
surfaces.

245Cigarette lighter ........................... 87
Climate control ............................. 15
Climate control, service ..............136
Climate control systems .............128
Clock............................................. 85
Code ........................................... 105
Collision damage repair ..............239
Control indicators.......................... 91
Control of the vehicle .................138
Controls ........................................ 81
Controls in steering wheel ............81
Convex shape .............................. 29
Coolant ....................................... 174
Coolant and antifreeze ...............220
Coolant temperature gauge ..........89
Coupling ball bar ........................167
Cruise control ...................... 99, 153
Cupholders .................................. 60
Curtain airbag system .................. 52
Curve lighting.............................. 122
D Danger, Warnings and Cautions ...4
Dashboard .................................... 10
Daytime running light ..................120
Daytime running lights ...............122
Declaration of conformity ............237
Diesel fuel system bleeding .......178
Diesel particle filter ...............97, 144
Door open .................................... 99Doors............................................ 26
Driver assistance systems ..........153
Driver Information Centre ...........100
Driving characteristics and towing tips .............................. 166
Driving hints ................................ 138
E Electric adjustment ......................29
Electrical system......................... 188
Electric parking brake ...........96, 150
Electric parking brake fault ...........96
Electronic climate control system 131
Electronic driving programmes ..147
Electronic Stability Control.......... 152
Electronic Stability Control and Traction Control system ...........97
Electronic Stability Control off ...... 97
End-of-life vehicle recovery .......171
Engine compartment fuse box ...190
Engine coolant ........................... 174
Engine coolant temperature gauge ....................................... 89
Engine data ............................... 227
Engine exhaust .......................... 144
Engine identification ...................223
Engine oil ................... 173, 220, 224
Engine oil pressure ......................98
Entry lighting .............................. 126
Event data recorders ..................241Exhaust gases ............................ 144
Exit lighting ................................ 126
Exterior care .............................. 215
Exterior light ................................. 98
Exterior lighting ....................12, 119
Exterior mirrors ............................. 29
F Fault ........................................... 147
First aid ......................................... 77
First aid kit ................................... 77
Fixed air vents ........................... 136
Flex-Fix system ............................ 63
Fog light ....................................... 99
Fog lights .................... 123, 124, 183
Folding mirrors ............................. 29
Folding tray .................................. 77
Front airbag system .....................51
Front fog lights ........................... 123
Front seats.................................... 36
Front storage ............................... 62
Front turn signal light ..................179
Front turn signal lights ...............183
Fuel............................................. 159
Fuel consumption - CO 2-
Emissions ............................... 164
Fuel for diesel engines ..............159
Fuel for liquid gas operation .......159
Fuel for petrol engines ...............159
Fuel gauge ................................... 89