2016.5 VAUXHALL ASTRA J battery

Vehicle care235The anti-theft alarm siren must be
deactivated as follows: Switch the ignition on then off, disconnect the
vehicle's battery within 15 seconds.
Vehicle battery discharge protection
3 154.
Replacing the vehicle battery Notice
Any deviation from the instructions
given in this section may lead to
temporary deactivation of the stop-
start system.
When the vehicle battery is being
replaced, please ensure that there
are no open ventilation holes in the
vicinity of the positive terminal. If a
ventilation hole is open in this area, it
must be closed off with a dummy cap, and the ventilation in the vicinity of the
negative terminal must be opened.
Only use vehicle batteries that allow
the fuse box to be mounted above the vehicle battery.
In vehicles with an AGM (Absorptive
Glass Mat) battery, make sure to
have the battery replaced with
another AGM battery.
An AGM battery can be identified by
the label on the battery. We
recommend the use of an original
Vauxhall vehicle battery.
Notice
Using an AGM vehicle battery
different from the original Vauxhall
vehicle battery may result in a lower
performance of the stop-start
system.
We recommend that you have the
vehicle battery replaced by a
workshop.
Stop-start system 3 168.
Charging the vehicle battery9 Warning
On vehicles with stop-start
system, ensure that the charging potential does not exceed
14.6 volts when using a battery
charger. Otherwise the vehicle
battery might be damaged.
Jump starting 3 281.
Warning label

236Vehicle careMeaning of symbols:● No sparks, naked flames or smoking.
● Always shield eyes. Explosive gases can cause blindness or
injury.
● Keep the vehicle battery out of reach of children.
● The vehicle battery contains sulphuric acid which could cause
blindness or serious burn
injuries.
● See the Owner's Manual for further information.
● Explosive gas may be present in the vicinity of the vehicle battery.
Diesel fuel system bleeding
If the tank has been run dry, the diesel
fuel system must be bled. Switch on
the ignition three times for
15 seconds at a time. Then crank the
engine for a maximum of
40 seconds. Repeat this process after
no less than five seconds. If the
engine fails to start, seek the
assistance of a workshop.Wiper blade replacement
Lift the wiper arm until it stays in the
raised position, press button to
disengage the wiper blade and
remove.
Attach the wiper blade slightly angled
to the wiper arm and push until it
engages.
Lower wiper arm carefully.
Wiper blade on the rear window
Lift wiper arm. Disengage wiper blade as shown in illustration and remove.
Attach the wiper blade slightly angled
to the wiper arm and push until it
engages.
Lower wiper arm carefully.

Vehicle care257No.Circuit1Engine control module2Lambda sensor3Fuel injection/Ignition system4Fuel injection/Ignition system5–6Mirror heating/Anti-theft alarm
system7Fan control/Engine control
module/Transmission control
module8Lambda sensor/Engine cooling9Rear window sensor10Vehicle battery sensor11Trunk release12Adaptive forward lighting/Auto‐
matic light control13ABS14Rear window wiper15Engine control moduleNo.Circuit16Starter17Transmission control module18Heated rear window19Front power windows20Rear power windows21Rear electrical centre22Left high beam (Halogen)23Headlamp washer system24Right low beam (Xenon)25Left low beam (Xenon)26Front fog lights27Diesel fuel heating28Start stop system29Electric parking brake30ABS31Adaptive cruise control32Airbag

272Vehicle care4.Screw the compressor air hose to
the connection on the sealant
bottle.
5. Fit the sealant bottle into the retainer on the compressor.
Set the compressor near the tyre
in such a way that the sealant
bottle is upright.
6. Unscrew valve cap from defective
tyre.
7. Screw the filler hose to the tyre valve.
8. The switch on the compressor must be set to J.
9. Connect the compressor plug to
the power outlet or cigarette
lighter socket.
To avoid discharging the battery,
we recommend running the
engine.
10. Set the rocker switch on the compressor to I. The tyre is filled
with sealant.
11. The compressor pressure gauge briefly indicates up to 6 bar whilstthe sealant bottle is emptying
(approx. 30 seconds). Then the
pressure starts to drop.
12. All of the sealant is pumped into the tyre. Then the tyre is inflated.
13. The prescribed tyre pressure should be obtained within ten
minutes. Tyre pressure 3 308.
When the correct pressure is
obtained, switch off the
compressor.
If the prescribed tyre pressure is
not obtained within ten minutes,
remove the tyre repair kit. Move
the vehicle one tyre rotation.
Reattach the tyre repair kit and
continue the filling procedure for
ten minutes. If the prescribed tyre
pressure is still not obtained, the
tyre is too badly damaged. Seek
the assistance of a workshop.

Vehicle care281they are not fixed properly. During
a sudden stop or a collision, loose equipment could strike someone.
Store jack and tools always in the
respective storage compartments
and secure them by fixing.
Damaged wheel placed in the load compartment must always be
secured by the strap.
Temporary spare wheel
Caution
The use of a spare wheel that is smaller than the other wheels or in combination with winter tyres
could affect driveability. Have the defective tyre replaced as soon as
possible.
Only mount one temporary spare
wheel. Do not drive faster than
50 mph. Take curves slowly. Do not
use for a long period of time.
If your vehicle gets a flat tyre on the
rear while towing another vehicle,
mount the temporary spare wheel in
the front and the full tyre in the rear.
Tyre chains 3 270.
Spare wheel with directional tyre
Fit directional tyres such that they roll in the direction of travel. The rolling
direction is indicated by a symbol
(e.g. an arrow) on the sidewall.
The following applies to tyres fitted
opposing the rolling direction:
● Driveability may be affected. Have the defective tyre renewed
or repaired as soon as possible
and fit it instead of the spare
wheel.
● Drive particularly carefully on wet
and snow-covered road
surfaces.Jump starting
Do not start with quick charger.
A vehicle with a discharged vehicle
battery can be started using jump
leads and the vehicle battery of
another vehicle.9 Warning
Be extremely careful when starting
with jump leads. Any deviation
from the following instructions can
lead to injuries or damage caused
by battery explosion or damage to the electrical systems of both
vehicles.
9 Warning
Avoid contact of the battery with
eyes, skin, fabrics and painted
surfaces. The fluid contains
sulphuric acid which can cause
injuries and damage in the event
of direct contact.
● Never expose the vehicle battery
to naked flames or sparks.

282Vehicle care● A discharged vehicle battery canalready freeze at a temperature
of 0 °C. Defrost the frozen vehicle
battery before connecting jump
leads.
● Wear eye protection and protective clothing when
handling a vehicle battery.
● Use a booster vehicle battery with the same voltage ( 12 Volts).
Its capacity (Ah) must not be
much less than that of the
discharged vehicle battery.
● Use jump leads with insulated terminals and a cross section of
at least 16 mm 2
(25 mm 2
for
diesel engines).
● Do not disconnect the discharged
vehicle battery from the vehicle.
● Switch off all unnecessary electrical consumers.
● Do not lean over the vehicle battery during jump starting.
● Do not allow the terminals of one
lead to touch those of the other
lead.● The vehicles must not come into contact with each other during
the jump starting process.
● Apply the parking brake, transmission in neutral,
automatic transmission in P.
● Open the positive terminal protection caps of both vehicle
batteries.
Lead connection order:
1. Connect the red lead to the positive terminal of the booster
vehicle battery.
2. Connect the other end of the red lead to the positive terminal of the
discharged vehicle battery.
3. Connect the black lead to the negative terminal of the booster
vehicle battery.
4. Connect the other end of the black
lead to a vehicle grounding point,
such as the engine block or an
engine mounting bolt. Connect as far away from the discharged
vehicle battery as possible,
however at least 60 cm.
Route the leads so that they cannot
catch on rotating parts in the engine
compartment.
To start the engine: 1. Start the engine of the vehicle providing the jump.
2. After five minutes, start the other engine. Start attempts should be
made for no longer than
15 seconds at an interval of one
minute.
3. Allow both engines to idle for approx. three minutes with the
leads connected.

336IndexAAccessories and vehicle modifications .......................... 229
Active Emergency Braking .........199
Active head restraints ..................38
Adaptive cruise control .......119, 188
Adaptive forward lighting ..119,
146, 240
Adjustable air vents ...................163
Airbag and belt tensioners .........114
Airbag deactivation ..............54, 114
Airbag system .............................. 52
Air conditioning regular operation ................................ 164
Air conditioning system .............. 156
Air intake .................................... 163
Air vents...................................... 163
Antilock brake system ................ 177
Antilock brake system (ABS) .....116
Anti-theft alarm system ................28
Anti-theft locking system .............. 27
Appearance care ........................285
Armrest ........................................ 48
Armrest storage ........................... 63
Ashtrays ..................................... 107
Automatic anti-dazzle ..................32
Automatic light control ...............143
Automatic locking ........................24
Automatic transmission .............173Autostop..................................... 168
Auxiliary heater ........................... 162
B
Battery discharge protection ......154
Battery voltage ........................... 129 Belts.............................................. 49
Bicycle rack .................................. 65
Bonnet ....................................... 230
Brake and clutch fluid .................290
Brake and clutch system ...........115
Brake assist ............................... 180
Brake fluid .................................. 234
Brakes ............................... 177, 234
Breakdown.................................. 283
Bulb replacement ....................... 237
C Capacities .................................. 307
Cargo management system ........91
Car Pass ...................................... 21
Catalytic converter .....................172
Central locking system ................23
Centre console lighting ..............153
Centre console storage ...............64
Changing tyre and wheel size ...269
Charging system ........................ 115
Child locks ................................... 25
Child restraint installation locations ................................... 57
Child restraints.............................. 56

340Towing equipment .....................224
Towing the vehicle .....................283
Traction Control system ............. 180
Traction Control system off ........ 117
Traffic sign assistant ...................211
Trailer coupling ........................... 223
Trailer stability assist .................227
Trailer towing ............................. 223
Transmission ............................... 17
Transmission display .................173
Tread depth ............................... 269
Trip computer ............................ 130
Trip odometer ............................ 108
Turn and lane-change signals ...149
Turn signal ................................. 114
Tyre chains ................................ 270
Tyre designations ......................264
Tyre pressure ............................ 264
Tyre pressure monitoring system ............................. 118, 266
Tyre pressures ........................... 308
Tyre repair kit ............................. 270
U Ultrasonic parking assist ...117, 201
Underseat storage .......................63
Upholstery .................................. 287
Uplevel-Combi-Display ...............120
Upshift ........................................ 116
Using this manual ..........................3V
Vehicle battery ........................... 234
Vehicle checks............................ 230
Vehicle data ................................ 294
Vehicle data recording and privacy ..................................... 333
Vehicle detected ahead ..............120
Vehicle dimensions .................... 306
Vehicle Identification Number ....292
Vehicle jack ................................ 262
Vehicle messages .....................126
Vehicle personalisation .............132
Vehicle security ............................ 27
Vehicle specific data ......................3
Vehicle storage ........................... 229
Vehicle tools ............................... 262
Vehicle unlocking ........................... 6
Vehicle weight ........................... 303
Ventilation ................................... 155
W
Warning chimes .........................129
Warning lights ............................. 108
Warning triangle .......................... 94
Washer and wiper systems .........16
Washer fluid ............................... 233
Wheel changing .........................273
Wheel covers ............................. 270
Wheels and tyres .......................264
Windows ....................................... 32Windscreen................................... 32
Windscreen wiper/washer .........102
Winter tyres ............................... 264
Wiper blade replacement ..........236