2015 YAMAHA WOLVERINE tailgate

4-21
4
For additional loading information, see page
6-7.
Removing and installing the tailgate
To remove the tailgateUnhook the latches, and then pull up the tail-
gate.
To install the tailgatePlace the tailgate in the original position, and
then hook the latches.
1. Cargo hook
1. Cargo hookMaximum load limit: 136.0 kg (300 lb)
1
1
1. Tailgate
2. Latch2
2
1
U2MB7AE0.book Page 21 Thursday, January 29, 2015 3:42 PM

4-22
4
The tailgate can also be installed at the front
of the cargo bed. Install the tailgate and hook
the latches as shown.EBU33611Adjusting the front shock absorber as-
sembliesThese shock absorber assemblies are
equipped with a spring preload adjusting nut,
a rebound damping force adjusting screw, a
compression damping force adjusting bolt(for fast compression damping), and a com-
pression damping force adjusting screw (for
slow compression damping).
WARNING
EWB02492
Suspension components become hot
during operation. Never touch the com-
pression damping force adjusting bolt
and screw, the rebound damping force
adjusting screw or the oil reservoir with
your bare hand or skin until suspension
components have cooled.
 Always adjust the shock absorber as-
semblies on the left and right side to the
same setting. Uneven adjustment can
cause poor handling and loss of stability,
which could lead to an accident. NOTICEECB00091Never turn an adjusting mechanism be-
yond the minimum and maximum settings.
1. Tailgate
2. Latch2
2
1
U2MB7AE0.book Page 22 Thursday, January 29, 2015 3:42 PM

9-1
9
EBU32720
CLEANING AND STORAGE
EBU33680CleaningFrequent, thorough cleaning of your vehicle
will not only enhance its appearance but will
improve its general performance and extend
the useful life of many components.1. Before cleaning the vehicle: a. Block off the end of the exhaust pipeto prevent water entry. A plastic bag
and strong rubber band may be used.
b. Make sure the spark plug and all filler caps are properly installed.
2. If the engine case is excessively greasy, apply degreaser with a paint brush. Do
not apply degreaser to the wheel axles.
3. Rinse the dirt and degreaser off with a garden hose. Use only enough pressure
to do the job. WARNING! Test the
brakes after washing. Apply the
brakes several times at slow speeds to
let friction dry out the linings. Wet brakes may have reduced stopping
ability, increasing the chance of an ac-
cident.
[EWB03470]

NOTICE: Excessive wa-
ter pressure may cause water seepage
and deterioration of wheel bearings,
brakes, transmission seals and electri-
cal devices. Many expensive repair
bills have resulted from improper high-
pressure detergent applications such
as those available in coin-operated car
washers.
[ECB00712]
TIPThe tailgate can be removed to make it easier
to clean the cargo bed. To separate the tail-
gate from the cargo bed, unhook the latches,
and then pull up the tailgate. (See page 4-20
for tailgate removal and installation proce-
dures.)
U2MB7AE0.book Page 1 Thursday, January 29, 2015 3:42 PM