2015 YAMAHA MAJESTY S 125 warning light

PERIODIC MAINTENANCE AND ADJUSTMENT
6-27
1
2
3
4
56
7
8
9
EAUT4220
Replacing the fusesMain fuse
The main fuse is located behind panel
A. (See page 6-8.)
If the main fuse is blown, replace it as
follows.1. Turn the key to “OFF”.
2. Remove the blown fuse, and then install a new fuse of the specified
amperage. WARNING! Do not
use a fuse of a higher amperage
rating than recommended to
avoid causing extensive dam-
age to the electrical system and
possibly a fire.
[EWA15132]
3. Turn the key to “ON” to check if the vehicle operates normally. If the
main fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
4. After removing and installing the
main fuse, turn the main switch
from “ON” to “OFF” three times in
three-second intervals to initialize
the idle speed control system.
Fuse box
The fuse box, which contains the fuses
for the ignition, turn signal, and lighting
systems, as well as the back-up fuse
for the multi-function meter unit, is lo-
cated underneath the windshield be-
hind the front cowling. Have a Yamaha
dealer check and replace these fuses if
necessary.
1. Main fuse
1
Specified fuses: Main fuse: 20.0 A
Specified fuses:Lighting fuse: 15.0 A
Signaling system fuse:
7.5 A× 2
Ignition fuse: 7.5 A
Backup fuse: 7.5 A



PERIODIC MAINTENANCE AND ADJUSTMENT
6-30
2
3
4
567
8
9
EAUT4110
Replacing a license plate light
bulb1. Remove the license plate light bulbsocket (together with the bulb) by
turning it counterclockwise, and
then pulling it out.
2. Remove the burnt-out bulb by pull- ing it out.
3. Insert a new bulb into the socket.
4. Install the socket (together with the bulb) by pushing it in, and then turn
it clockwise until it stops.
EAU54501
Auxiliary lightThis model is equipped with LED-type
auxiliary lights.
If an auxiliary light does not come on,
have a Yamaha dealer check it.
EAU25882
TroubleshootingAlthough Yamaha scooters receive a
thorough inspection before shipment
from the factory, trouble may occur dur-
ing operation. Any problem in the fuel,
compression, or ignition systems, for
example, can cause poor starting and
loss of power.
The following troubleshooting charts
represent quick and easy procedures
for checking these vital systems your-
self. However, should your scooter re-
quire any repair, take it to a Yamaha
dealer, whose skilled technicians have
the necessary tools, experience, and
know-how to service the scooter prop-
erly.
Use only genuine Yamaha replace-
ment parts. Imitation parts may look like
Yamaha parts, but they are often inferi-
or, have a shorter service life and can
lead to expensive repair bills.
WARNING
EWA15142
When checking the fuel system, do
not smoke, and make sure there are
no open flames or sparks in the ar-
ea, including pilot lights from water
1. License plate light bulb socket
1



SCOOTER CARE AND STORAGE
7-3
2
3
4
5
678
9
After cleaning
1. Dry the scooter with a chamois or an absorbing cloth.
2. Use a chrome polish to shine chrome, aluminum and stain-
less-steel parts, including the ex-
haust system. (Even the thermally
induced discoloring of stain-
less-steel exhaust systems can be
removed through polishing.)
3. To prevent corrosion, it is recom- mended to apply a corrosion pro-
tection spray on all metal,
including chrome- and nickel-plat-
ed, surfaces.
4. Use spray oil as a universal clean- er to remove any remaining dirt.
5. Touch up minor paint damage caused by stones, etc.
6. Wax all painted surfaces.
7. Let the scooter dry completely be- fore storing or covering it.
WARNING
EWA10943
Contaminants on the brakes or tires
can cause loss of control.
Make sure that there is no oil or
wax on the brakes or tires. If
necessary, clean the brake discs and brake linings with a
regular brake disc cleaner or ac-
etone, and wash the tires with
warm water and a mild deter-
gent.

Before operating the scooter
test its braking performanceand cornering behavior.
NOTICE
ECA10801

Apply spray oil and wax spar-
ingly and make sure to wipe off
any excess.

Never apply oil or wax to any
rubber and plastic parts, but
treat them with a suitable care
product.

Avoid using abrasive polishing
compounds as they will wearaway the paint.
TIP
Consult a Yamaha dealer for ad-
vice on what products to use.

Washing, rainy weather or humid
climates can cause the headlight
lens to fog. Turning the headlight
on for a short period of time will
help remove the moisture from the
lens.



SPECIFICATIONS
8-3
2
3
4
5
6
789
Meter lighting:LED
High beam indicator light:
LED
Turn signal indicator light: LED
Coolant temperature warning light: LED
Engine trouble warning light:
LEDFuses:Main fuse:20.0 A
Signaling system fuse:
7.5 A× 2
Ignition fuse: 7.5 A
Backup fuse: 7.5 A



INDEXAAcceleration and deceleration....................5-2
Air filter and V-belt case air filter
elements ................................................6-15
Auxiliary light ............................................6-30BBattery......................................................6-25
Brake fluid, changing ...............................6-22
Brake fluid level, checking .......................6-21
Brake lever, front........................................3-7
Brake lever, rear ........................................3-7
Brake levers, lubricating...........................6-23
Braking .......................................................5-3CCables, checking and lubricating .............6-22
Care ...........................................................7-1
Catalytic converter ...................................3-10
Centerstand and sidestand, checking and
lubricating ..............................................6-23
Coolant.....................................................6-13
Coolant temperature warning light .............3-3DDimmer switch ...........................................3-7EEngine break-in ..........................................5-3
Engine idling speed, checking .................6-16
Engine oil .................................................6-10
Engine serial number .................................9-1
Engine trouble warning light.......................3-3FFinal transmission oil ...............................6-12
Front and rear brak e lever free play,
checking ................................................6-20
Front and rear brake pads, checking .......6-20 Front fork, checking ................................. 6-24
Front turn signal light ............................... 6-28
Fuel............................................................ 3-8
Fuel consumption, tips
for reducing........... 5-3
Fuel gauge................................................. 3-4
Fuel tank breather hose and overflow hose ........................................................ 3-9
Fuel tank cap ............................................. 3-8
Fuses, replacing ...................................... 6-27
HHandlebar switches ................................... 3-6
Headlight bulb, replacing ......................... 6-28
Helmet holder .......................................... 3-11
High beam indicator light ........................... 3-2
Horn switch ................................................ 3-7IIdentification numbers ............................... 9-1
Ignition circuit cut-off system ................... 3-15
Indicator lights and warning lights ............. 3-2KKeyhole cover ............................................ 3-2LLicense plate light bulb, replacing ........... 6-30
Luggage hook .......................................... 3-14MMain switch/steering lock........................... 3-1
Maintenance and lubrication, periodic ....... 6-5
Maintenance, emission control system...... 6-4
Matte color, caution ................................... 7-1
Model label ................................................ 9-1
Multi-function display ................................. 3-4PPanels, removing and installing ................. 6-8
Parking ...................................................... 5-4 Part locations ............................................ 2-1
Passenger footrest .................................. 3-11
Pass switch ............................................... 3-7
SSafe-riding points ...................................... 1-5
Safety information ..................................... 1-1
Seat ......................................................... 3-10
Shock absorber assembly ....................... 3-13
Sidestand ................................................ 3-14
Spark plug, checking ................................. 6-9
Specifications ............................................ 8-1
Starting off ................................................. 5-2
Starting the engine .................................... 5-1
Start switch................................................ 3-7
Steering, checking................................... 6-25
Storage...................................................... 7-4
Storage compartments ............................ 3-12TTachometer ............................................... 3-3
Tail/brake light ......................................... 6-28
Throttle grip and cable, checking and
lubricating ............................................. 6-22
Throttle grip free play, checking .............. 6-17
Tires ........................................................ 6-17
Tool kit....................................................... 6-2
Troubleshooting ...................................... 6-30
Troubleshooting charts............................ 6-32
Turn signal indicator lights ........................ 3-2
Turn signal light bulb (rear), replacing..... 6-29
Turn signal switch ..................................... 3-7VValve clearance....................................... 6-17
Vehicle identification number .................... 9-1