2015 VOLVO XC90 wheel bolts

9
NAVIGATION*
Sensus Navigation
428
Buttons and information on the map 428
Common navigation system features 429
Getting started with Sensus Navigation 432
Quick guidance to a destination 432
Navigation displays and controls 433
Entering a destination 435
Setting a destination by tapping the map 435
Setting a destination by entering the text of your choice 436
Setting a destination using Recent/Favorites/Library 438
Using a point of interest (POI) as adestination 440
Setting a destination by entering anaddress 441
Saving a destination with Send to Car 441
Viewing the itinerary and alternate routes 442
Guidance points in the itinerary 444
POIs along the route 445
Traffic problems along the route 445
Information cards on the map 446
Choosing a detour 447
Traffic information 448
Navigation in the instrument panel 448
Sensus Navigation settings 449

Map settings450
Route settings 452
Traffic information settings 454
Guidance settings 455
System settings 456
Map updates with MapCare 456
Remote map updates 457
Map updates from a computer with a USB flash drive 458
Navigation license agreements 460
Copyright 462
Sensus Navigation troubleshooting 462
WHEELS AND TIRES
Tires466
Tire sidewall designations 467
Wheel (rim) designations 469
Tire terminology 469
Tire direction of rotation 470
Tread wear indicator 471
Loading specifications 471
Uniform Tire Quality Grading 472
Snow tires and chains 473
Checking tire inflation pressure 473
Changing tires 475
Tools in the cargo compartment 475
Jack 476
Spare tire 476
Wheel bolts 477
Removing a wheel 478
Installing a wheel 479
Tire Pressure Monitoring System (TPMS) 480
Checking inflation pressure 482
Reinflating tires equipped with the Tire Pressure Monitoring System (TPMS) 483
Calibrating the Tire PressureMonitoring System (TPMS) 484
Tire Pressure Monitoring Systemtype approval 484

WHEELS AND TIRES
* Option/accessory, for more information, see Introduction.475
NOTE
•If you overfill the tire, release air by push- ing on the metal stem in the center of thevalve. Then recheck the pressure withyour tire gauge.
• Some spare tires require higher inflationpressure than the other tires. Consult thetire inflation pressure table or the inflationpressure placard.
Changing tires
When changing wheels to another dimension, always follow Volvo's instructions.
When changing to tires of another
dimension
If you mount tires with a dimension other thanthe factory-installed tires, contact an authorizedVolvo retailer to update the vehicle's software.This may also be necessary when changing fromsummer to winter tires, or vice versa.
Related information
• Snow tires and chains (p. 473)
• Spare tire (p. 476)
• Installing a wheel (p. 479)
• Removing a wheel (p. 478)
Tools in the cargo compartment
Tools for e.g., changing wheels, etc. are located under the cargo compartment floor.
The foam block under the cargo compartment floor contains the towing eyelet, the tool for removing plastic wheel bolt covers, the jack * and
the lug wrench *. There is also a storage space for
the tool used to remove locking wheel bolts.

WHEELS AND TIRES
* Option/accessory, for more information, see Introduction.477
WARNING
Current legislation prohibits the use of the "Temporary Spare" tire other than as a tem-porary replacement for a punctured tire. Itmust be replaced as soon as possible by astandard tire. Road holding and handling maybe affected with the "Temporary Spare" inuse. Do not exceed 50 mph (80 km/h).
CAUTION
The vehicle must not be driven with wheels of different dimensions or with a spare tire otherthan the one that came with the vehicle. Theuse of different size wheels can seriouslydamage your car's transmission.
CAUTION
The vehicle must never be driven with more than one temporary spare wheel.
The spare tire is located under the floor of the cargo compartment. A retaining bolt holds thespare tire and foam block containing tools inplace.
Accessing the spare tire1. Lift the rear edge of the cargo compartment
floor.
2. Unscrew the retaining bolt.
3. Lift out the foam block holding the tools. 4. Lift out the spare tire.
Related information
•
Changing tires (p. 475)
• Removing a wheel (p. 478)
• Wheel bolts (p. 477)
• Checking tire inflation pressure (p. 473)
Wheel bolts
The wheel bolts hold the wheel in place.
CAUTION
Wheel bolts should be tightened to 103 ft. lbs. (140 Nm). Over-tightening could damagethe threads.
Only use wheels/rims that have been tested and approved by Volvo and are included in Volvo'sproduct range. Use a torque wrench to checkthat the wheel bolts are tightened correctly.
Locking wheel bolts *A tool for removing locking wheel bolts can befound in the foam block under the cargo com-partment floor.
Related information
•Changing tires (p. 475)
• Installing a wheel (p. 479)

WHEELS AND TIRES
479
5.
Lug wrench and towing eyelet
Screw the towing eyelet into the lug wrench as shown in the illustration.
CAUTION
The towing eyelet must be screwed into the lug wrench as far as possible.
6. With the vehicle still on the ground, use the
lug wrench/towing eyelet to loosen the wheel bolts ½ – 1 turn by exerting downward(counterclockwise) pressure. 7. When hoisting the vehicle, it is essential that
the jack (or garage lift arms) are positionedcorrectly on the underside of the vehicle.There are two jack attachment points oneach side of the vehicle and there is a groovein the plastic cover at each attachment point.Position the jack under the attachment pointto be used on a level, firm, non-slippery sur-face and crank it up until it is correctlyaligned and seated in the attachment point.The pin on the jack's head must be posi-tioned in the hole in the attachment point.
8. Raise the vehicle until the wheel to bechanged is lifted off the ground. Remove the wheel bolts.
Related information
• Wheel bolts (p. 477)
• Installing a wheel (p. 479)
• Jack (p. 476)
Installing a wheel
It is important to install wheels properly.
1. Clean the contact surfaces on the wheel and hub.
2. Lift the wheel and place it on the hub.
3. Install the wheel bolts and tighten hand-tight. Using the lug wrench, tighten crosswise until all bolts are snug.
4. Lower the vehicle to the ground and alter- nately tighten the bolts crosswise to103 ft. lbs. (140 Nm).
5. Press the plastic covers onto the wheel bolts.

WHEELS AND TIRES
480
CAUTION
•After inflating the tires, always reinstall the valve cap to help avoid damage to thevalve from dirt, gravel, etc.
• Use plastic valve caps only. Metal capscould corrode and become difficult toremove.
Related information
• Wheel bolts (p. 477)
• Jack (p. 476)
Tire Pressure Monitoring System (TPMS) TPMS provides a warning if inflation pressure in one or more tires is too low. It also uses a sym-bol (called a telltale) that will flash for60 seconds and then glow steadily if there is asystem malfunction.
TPMS uses sensors mounted in the tire valves to check inflation pressure levels. When the vehicleis moving at a speed of approximately 20 mph(30 km/h) or faster, these sensors transmit infla-tion pressure data to a receiver located in thevehicle. If inflation pressure is too low, an indica-tor symbol will illuminate in the instrument paneland a text message will be displayed.
SymbolExplanation
The symbol illuminates to indicate low tire inflation pressure. If a malfunction occurs in the sys- tem, the tire pressure warning sym-bol will flash for approximately1 minute and then remain illumi-nated.
Each tire, including the spare (if provided), should be checked monthly when cold and inflated tothe inflation pressure recommended by the vehi-cle manufacturer on the vehicle placard or tireinflation pressure label. (If your vehicle has tires of a different size than the size indicated on thevehicle placard or tire inflation pressure label, youshould determine the proper tire inflation pres-sure for those tires.) As an added safety feature, your vehicle has been equipped with a tire pressure monitoringsystem (TPMS) that illuminates a low tire pres-sure telltale when one or more of your tires issignificantly under-inflated. Accordingly, when thelow tire pressure telltale illuminates, you shouldstop and check your tires as soon as possible,and inflate them to the proper pressure. Driving on a significantly under-inflated tire cau- ses the tire to overheat and can lead to tire fail-ure. Under-inflation also reduces fuel efficiencyand tire tread life, and may affect the vehicle'shandling and stopping ability. Please note thatthe TPMS is not a substitute for proper tire main-tenance, and it is the driver's responsibility tomaintain correct tire pressure, even if under-infla-tion has not reached the level to trigger illumina-tion of the TPMS low tire pressure telltale. Your vehicle has also been equipped with a TPMS malfunction indicator to indicate when thesystem is not operating properly. The TPMS mal-function indicator is combined with the low tirepressure telltale. When the system detects a malfunction, the tell- tale will flash for approximately one minute andthen remain continuously illuminated. Thissequence will continue upon subsequent vehicle

563
deactivating/reactivating 288
starting/activating 284
Spin control 308
Stability system 308 sport mode 309
Start/Stop (engine function) 364, 365Start and lock system type designations 220
Starting and driving 330
Starting the engine 356Starting the vehicle after a crash (crash mode) 81, 82
Start inhibitor (immobilizer) 221
Steel grid in cargo area 211
Steering wheel 157 adjusting 159
heated 189
horn 157
keypad 157
Steering wheel paddles 157
Stone chips, touching up 530, 531
Storage compartments 200
Studded tires 473Sunroof laminated panoramic roof 101, 102
Sun shade 104, 106
Sun visor 203
Suspension 372
System updates 490
T
Tailgate locking/unlocking 233 operating with the foot movement sen-
sor 228
power operated 235
wiper/washer 157
Tailgate wipers 523
Technician certification 54Temperature perceived 176
Temperature sensor ambient 116
Temporary spare tire 476Tethering wi-fi sharing 406
Three-way catalytic converter 349
Tire inflation pressure 545
Tire Pressure Monitoring System 480, 483 calibrating 484
type approval 484
Tire Pressure Monitoring System (TPMS) 484
Tires 466changing 475
changing from summer to winter 470
glossary of terms 469
improving economy 466
inflation pressure 473
inflation pressure table 545installing (mounting) a wheel on the
vehicle 479
rotation 467
snow 473
spare 476
specifications 467
storing 467
studded 473
tire pressure monitoring system 480, 483
tools in the cargo compartment 475
tread wear indicator 471
uniform tire quality grading 472
wheel bolts 477
Top tether anchors (child restraint systems) 74
Touching up paint 530, 531
Towing a trailer 351, 354 trailer hitch 353
Towing eyelet 343
Towing the vehicle 344
Traction control 308