2015 TOYOTA YARIS HATCHBACK clock

3637-3. Do-it-yourself maintenance
7
Maintenance and care
YARIS_F_WE_52G04E
■Adding engine oil
If the oil level is below or near the low level mark, add engine oil of
the same type as that already in the engine.
Make sure to check the oil type and prepare the items needed
before adding oil.
Remove the oil filler cap by turning it counterclockwise.
Add engine oil slowly, checking the dipstick.
Install the oil filler cap by turning it clockwise.
1KR-FE engine1NR-FE engine
1ND-TV engine
Engine oil selection P. 500
Oil quantity
(Low  Full)
1KR-FE engine and 1ND-TV engine with a DPF
system
1.3 L (1.4 qt., 1.1 lmp.qt.)
1NR-FE engine and 1ND-TV engine without a
DPF system
1.5 L (1.6 qt., 1.3 lmp.qt.)
Items Clean funnel
1
2
3

3727-3. Do-it-yourself maintenance
YARIS_F_WE_52G04E
You may drain the fuel filter yourself. However, as the operation is dif-
ficult, we recommend having it drained by any authorized Toyota
dealer or repairer, or another duly qualified and equipped profes-
sional. Even if you decide to drain it yourself, contact any authorized
Toyota dealer or repairer, or another duly qualified and equipped pro-
fessional.
The water in the fuel filter needs to be drained if the fuel filter warning
light comes on. (P. 434)
Turn the engine switch to the “LOCK” position (vehicles without a
smart entry & start system) or off (vehicles with a smart entry & start
system).
Place a small tray under the drain plug to catch the water and any
fuel that comes out.
Turn the drain plug counter-
clockwise about 2 to 2 1/2
turns.
Operate the priming pump until
fuel begins to run out.
After draining, tighten the drain plug by hand.
Fuel filter (diesel engine)
1
2
3
4
5

4077-3. Do-it-yourself maintenance
7
Maintenance and care
YARIS_F_WE_52G04E
Projector type
Turn the bulb base counter-
clockwise.
Pull the bulb out while press-
ing the lock release of the
connector.
Replace the light bulb, and
install the bulb base.
Align the 3 tabs on the light bulb
with the mounting and insert.
Turn and secure the bulb
base.
Shake the bulb base gently to
check that it is not loose, turn
the headlights on once and visu-
ally confirm that no light is leak-
ing through the mounting.
1
2
3
14

4097-3. Do-it-yourself maintenance
7
Maintenance and care
YARIS_F_WE_52G04E
Turn the bulb base counter-
clockwise.
Set the new light bulb.
Align the 3 tabs on the light bulb
with the mounting, and insert.
Turn and secure the bulb.
Install the connector.
Shake the bulb base gently to
check that it is not loose, turn
the front fog light, on once and
visually confirm that no light is
leaking through the mounting.
5
6
7
8

4107-3. Do-it-yourself maintenance
YARIS_F_WE_52G04E
Reinstall the fender liner.
Attach the end of the fender liner
to the inside of the front bumper.
Install the screw.
■Front position lights/daytime running lights (bulb type)
Turn the bulb base counterclockwise.
9
10
1
Type AType B

4117-3. Do-it-yourself maintenance
7
Maintenance and care
YARIS_F_WE_52G04E
Remove the light bulb.
When installing, reverse the steps listed.
■Front turn signal lights
Turn the bulb base counterclockwise.
Remove the light bulb
When installing, reverse the steps listed.
2
Type AType B
3
1
Type AType B
2
Type AType B
3

4137-3. Do-it-yourself maintenance
7
Maintenance and care
YARIS_F_WE_52G04E
After installing the new bulb,
secure the bulb base to the
mirror body.
Align the tabs, and secure
the mirror by pushing in each
diagonally-opposite pair of
tabs in order.
Make sure to insert the tabs in
order as shown in the illustra-
tion, and push them in until a
click is heard.
If you do not hear the click, do
not force the tabs in. Instead,
remove the mirror and check
that the tabs are aligned.
■Stop/tail lights (bulb type), and rear turn signal lights
Open the back door and
remove the cover.
To prevent damaging the vehi-
cle, wrap the screwdriver with a
tape.
Turn the bulb base counter-
clockwise.
Stop/tail light
Rear turn signal light
5
6
1
2
1
2

4167-3. Do-it-yourself maintenance
YARIS_F_WE_52G04E
Make sure that the cover is
secured by pressing on the
entire cover.
■Back-up light/rear fog light
Remove the clip and partly
remove the cover.
Pull the center section of the clip
and the remove and pull out the
lock.
Turn the bulb base counter-
clockwise.
Remove the light bulb.
5
1
2
3