2015 TOYOTA URBAN CRUISER ignition

1
2
3
4
5
6
3
URBAN CRUISER_OM_OM52F47E_(EE)
2-1. Driving procedures Driving the vehicle .............. 168
Engine (ignition) switch (vehicles without smart
entry & start system)......... 181
Engine (ignition) switch (vehicles with smart
entry & start system)......... 185
Manual transmission ........... 189
Turn signal lever ................. 193
Parking brake...................... 194
Horn .................................... 195
2-2. Instrument cluster Gauges and meters ............ 196
Indicators and warning lights ................................. 198
Multi-information display ..... 202
2-3. Operating the lights and wipers
Headlight switch.................. 207
Fog light switch ................... 211
Windshield wipers and washer ....................... 213
Rear window wiper and washer ....................... 215 2-4. Using other driving systems
Stop & Start system ........... 217
Driving assist systems........ 223
Four-wheel drive lock (4WD models) .................. 229
Diesel Particulate Filter system (diesel engine
only) ................................. 230
2-5. Driving information Cargo and luggage............. 232
Winter driving tips............... 235
Trailer towing...................... 239
2When driving

16
URBAN CRUISER_OM_OM52F47E_(EE)
B
Pictorial indexInstrument panel
(left-hand drive vehicles)
Telephone switch∗
Talk switch
∗
P. 307
P. 307
Engine (ignition) switch (vehicles with smart entry & start system)
P. 185
Engine (ignition) switch (vehicles
without smart entry & start system)
P. 181
Audio remote control
switches
∗ P. 297

24
URBAN CRUISER_OM_OM52F47E_(EE)
B
Pictorial indexInstrument panel
(right-hand drive vehicles)
Telephone switch∗
Talk switch
∗
P. 307
P. 307
Engine (ignition) switch (vehicles
without smart entry & start system)
P. 181
Engine (ignition) switch (vehicles
with smart entry & start system)
P. 185
Audio remote control
switches
∗ P. 297

67
1-2. Opening, closing and locking the doors
1
Before driving
URBAN CRUISER_OM_OM52F47E_(EE)
Locking the front doors from the outside without a key
Move the inside lock button to the lock position.
Close the door while pulling the door handle.
Vehicles without smart entry & start system
The door cannot be locked if the key is in the engine switch.
Vehicles with smart entry & start system
The door cannot be locked if the “ENGINE START STOP” switch is in
the ACCESSORY or IGNITION ON mode, or the electronic key is left
inside the vehicle.
Depending on the position of the electronic key, the key may not be
detected correctly and the door may be locked.
■ Inside lock button
Locks the door
Unlocks the door
The driver’s door can be
opened by pulling the inside
handle even if the lock button
is in the lock position.
STEP1
STEP2

99
1-3. Adjustable components (seats, mirrors, steering wheel)
1
Before driving
URBAN CRUISER_OM_OM52F47E_(EE)
Folding back the mirrors
Manual type Push the mirror back in the direc-
tion of the vehicle’s rear.
Power type Press the switch.
Pressing again will extend the
mirror.
■The outside rear view mirrors can be operated when
Vehicles without smart entry & start system
The engine switch is in the “ACC” or “ON” position.
Vehicles with smart entry & start system
The “ENGINE START STOP” switch is in the ACCESSORY or IGNITION
ON mode.
■ When the mirrors are fogged up
Turn on the outside rear view mirror defoggers to defog the mirrors.
(→ P. 270)

102
1-4. Opening and closing the windows
URBAN CRUISER_OM_OM52F47E_(EE)
■ The power windows can be operated when
Vehicles without smart entry & start system
The engine switch is in the “ON” position.
Vehicles with smart entry & start system
The “ENGINE START STOP” switch is in the IGNITION ON mode.
■ Retained accessory power (driver’s window only)
Vehicles without smart entry & start system
The power window can be operated for approximately 45 seconds even after
the engine switch is turned to the “ACC” or “LOCK” position. They cannot,
however, be operated once either front door is opened.
Vehicles with smart entry & start system
The power window can be operated for approximately 45 seconds even after
the “ENGINE START STOP” switch is turned to the ACCESSORY mode or
turned OFF. They cannot, however, be operated once either front door is
opened.
■ Jam protection function (driver’s window only)
If an object becomes caught between the window and the window frame,
window travel is stopped and the window is opened slightly.

103
1-4. Opening and closing the windows
1
Before driving
URBAN CRUISER_OM_OM52F47E_(EE)
■
When the power window does not close normally
If the jam protection function is operating abnormally and a window cannot
be closed, perform the following operat ions using the power window switch
on the driver’s door.
● After stopping the vehicle, the window can be closed by holding the
power window switch in the one-touch closing position while the
“ENGINE START STOP” switch is turned to IGNITION ON mode (vehi-
cles with smart entry & start system) or the engine switch is turned to the
“ON” position (vehicles without smart entry & start system).
● If the window still cannot be closed even by carrying out the operation
explained above, initialize the function by performing the following proce-
dure.
Hold the power window switch in the one-touch closing position.
Continue holding the switch for a further 6 seconds after the win-
dow has closed.
Hold the power window switch in the one-touch opening position.
Continue holding the switch for a further 2 seconds after the win-
dow has opened completely.
Hold the power window switch in the one-touch closing position
once again. Continue holding the switch for a further 2 seconds
after the window has closed.
If you release the switch while the window is moving, start again from the
beginning. If the window continues to close but then re-open slightly even
after performing the above procedure correctly, have the vehicle inspected
by any authorized Toyota dealer or repairer, or another duly qualified and
equipped professional.
STEP1
STEP2
STEP3

108
1-5. Refueling
URBAN CRUISER_OM_OM52F47E_(EE)
CAUTION
■ When refueling the vehicle
Observe the following precautions while refueling the vehicle.
Failure to do so may result in death or serious injury.
●After exiting the vehicle and before opening the fuel door, touch an
unpainted metal surface to discharge any static electricity. It is important to
discharge static electricity before refueling because sparks resulting from
static electricity can cause fuel vapors to ignite while refueling.
● Always hold the grips on the fuel tank cap and turn it slowly to remove it.
A whooshing sound may be heard when the fuel tank cap is loosened.
Wait until the sound cannot be heard before fully removing the cap.
In hot weather, pressurized fuel may spray out of the filler neck and cause
injury.
● Do not allow anyone that has not discharged static electricity from their
bodies to come close to an open fuel tank.
● Do not inhale vaporized fuel.
Fuel contains substances that are harmful if inhaled.
● Do not smoke while refueling the vehicle.
Doing so may cause the fuel to ignite and cause a fire.
● Do not return to the vehicle or touch any person or object that is statically
charged.
This may cause static electricity to build up, resulting in a possible ignition
hazard.