2015 TOYOTA PRIUS C high beam

892. Instrument cluster
2
Instrument cluster
PRIUS c_U (OM52E68U)
The indicators inform the driver of the operating state of the vehicle’s
various systems.
*1: These lights turn on when the engine switch is turned to the “ON” position(vehicles without a smart key system) or the “POWER” switch is turned to
ON mode (vehicles with a smart key system) to indicate that a system
check is being performed. They will turn off after the hybrid system is on, or
after a few seconds. There may be a malfunction in a system if the lights
do not come on, or turn off. Have the vehicle inspected by your Toyota
dealer.
*2: The light flashes to indicate that the system is operating.
Indicators
Turn signal indicator
(P. 199) EV drive mode indicator
(
P. 193)
Headlight high beam
indicator (P. 201)
Shift position indicator
( P. 197)
(U.S.A.)
Headlight indicator
(P. 201) “ECO MODE” indicator
(
P. 197)
(Canada)
Tail light indicator
(P. 201)EV drive indicator lamp
( P. 73)
(if equipped)
Front fog light indicator
(P. 205)
(if equipped)
Cruise control indicator
( P. 218)
(if equipped)
Immobilizer system indi-
cator ( P. 82)
(if equipped)
Cruise control set indica-
tor (P. 218)
*1, 2
Slip indicator ( P. 233)
“READY” indicator
( P. 182, 186)
*1VSC OFF indicator
( P. 233)
SRS airbag
on-off indica-
tor ( P. 5 0 )*1

2024-3. Operating the lights and wipers
PRIUS c_U (OM52E68U)
Type BThe daytime running
lights turn on.
The side marker, park-
ing, tail, license plate,
daytime running lights
and instrument panel
lights turn on.
The headlights and all
lights listed above
(except daytime running
lights) turn on.
With the headlights on, push
the lever away from you to turn
on the high beams.
Pull the lever toward you to the
center position to turn the high
beams off.
Pull the lever toward you and
release it to flash the high
beams once.
You can flash the high beams with the headlights on or off.
1
2
3
Turning on the high beam headlights
1
2

4277-3. Do-it-yourself maintenance
7
Maintenance and care
PRIUS c_U (OM52E68U)■
License plate light
Remove the cover.
Insert a properly sized screw-
driver into the hole of the cover,
and pry off the cover as shown
in the illustration.
To prevent damaging the vehi-
cle, wrap the tip of the screw-
driver with tape.
Remove the light bulb.
When installing, reverse the steps listed.
■Lights other than the above
If any of the lights listed below has burnt out, have it replaced by
your Toyota dealer.
●Headlight low/high beam/daytime running lights
● Front fog lights (if equipped)
● Side turn signal lights
● Stop/tail lights
● High mounted stoplight
■LED light bulbs
The headlight low/high beam/daytime running lights, front fog lights (if
equipped), stop/tail lights and high mounted stoplight consist of a number of
LEDs. If any of the LEDs burn out, take your vehicle to your Toyota dealer to
have the light replaced.
■ Condensation build-up on the inside of the lens
Temporary condensation build-up on the inside of the headlight lens does not
indicate a malfunction. Contact your Toyo ta dealer for more information in the
following situations:
● Large drops of water have built up on the inside of the lens.
● Water has built up inside the headlight.
1
2
3