2015 TOYOTA PRIUS C display

2234-5. Using the driving support systems
4
Driving
PRIUS c_U (OM52E68U)■
Screen description
Vehicle width guide lines
The line indicates a guide path when the vehicle is being backed
straight up.
The displayed width is wider than the actual vehicle width.
Vehicle center guide line
This line indicates the estimated vehicle center on the ground.
Distance guide line
The line shows distance behind the vehicle, a point approximately 1.5 ft.
(0.5 m) (red) from the edge of the bumper.
Distance guide line
The line shows distance behind the vehicle, a point approximately 3 ft.
(1 m) (blue) from the edge of the bumper.
Using the rear view monitor system
1
2
3
4

2244-5. Using the driving support systems
PRIUS c_U (OM52E68U)■
Area displayed on screen
The rear view monitor system
displays an image of the view
from the bumper of the rear
area of the vehicle.
To adjust the image on the rear
view monitor system screen.
(
P. 258)
• The area displayed on the
screen may vary according to
vehicle orientation conditions.
• Objects which are close to either
corner of the bumper or under
the bumper cannot be seen on
the screen.
• The camera uses a special lens. The distance of the image that
appears on the screen differs
from the actual distance.
• Items which are located higher than the camera may not be displayed by the monitor.
Rear view monitor system precautions
Corners of bumper

2274-5. Using the driving support systems
4
Driving
PRIUS c_U (OM52E68U)
●When any part of the vehicle sags
When any part of the vehicle
sags due to the number of pas-
sengers or the distribution of
the load, there is a margin of
error between the fixed guide
lines on the screen and the
actual distance/course on the
road.
■When approaching three-dimensional objects
The distance guide lines are displayed according to flat surfaced
objects (such as the road). It is not possible to determine the posi-
tion of three-dimensional objects (such as vehicles) using the dis-
tance guide lines. When approaching a three-dimensional object
that extends outward (such as the flatbed of a truck), be careful of
the following.
● Distance guidelines
Visually check the surroundings
and the area behind the vehi-
cle. On the screen, it appears
that a truck is parked at point
. However, in reality if you
back up to point , you will hit
the truck. On the screen, it
appears that is closest and
is furthest away. However,
in reality, the distance to
and is the same, and is
farther than and .
A margin of error
2
1
1
3
1
32
13

2304-5. Using the driving support systems
PRIUS c_U (OM52E68U)
WARNING
■When using the rear view monitor system
The rear view monitor system is a supplemental device intended to assist
the driver when backing up. When backing up, be sure to visually check all
around the vehicle both directly and using the mirrors before proceeding. If
you do not, you may hit another vehicle, and could possibly cause an acci-
dent.
Pay attention to the following precauti ons when using the rear view monitor
system.
● Never depend on the rear view monitor system entirely when backing up.
The image and the position of the guide lines displayed on the screen may
differ from the actual state.
Use caution, just as you would when backing up any vehicle.
● Be sure to back up slowly, depressing the brake pedal to control vehicle
speed.
● The instructions given are only guidelines.
When and how much to turn the steering wheel will vary according to traf-
fic conditions, road surface conditions, vehicle condition, etc. when park-
ing. It is necessary to be fully aware of this before using the rear view
monitor system.
● When parking, be sure to check that the parking space will accommodate
your vehicle before maneuvering into it.
● Do not use the rear view monitor system in the following cases:
• On icy or slick road surfaces, or in snow
• When using tire chains or the compact spare tire
• When the back door is not closed completely
• On roads that are not flat or straight, such as curves or slopes.
● In low temperatures, the screen may darken or the image may become
faint. The image could distort when the vehicle is moving, or you may
become unable to see the image on the screen. Be sure to visually check
all around the vehicle both directly and using the mirrors before proceed-
ing.
● If the tire sizes are changed, the position of the fixed guide lines displayed
on the screen may change.
● The camera uses a special lens. The distances between objects and
pedestrians that appear in the image displayed on the screen will differ
from the actual distances. ( P. 225)

2334-5. Using the driving support systems
4
Driving
PRIUS c_U (OM52E68U)
The slip indicator light will flash
while the TRAC/VSC/ABS sys-
tems are operating.
If the vehicle gets stuck in mud, dirt or snow, the TRAC system may
reduce power from the hybrid system to the wheels. Pressing to
turn the system off may make it easier for you to rock the vehicle in
order to free it.
To turn the TRAC system off,
quickly press and release .
The “TRAC OFF” will be shown on
the multi-information display.
Press again to turn the system
back on.
■Turning off both TRAC and VSC systems
To turn the TRAC and VSC systems off, press and hold for more than 3
seconds while the vehicle is stopped.
The VSC OFF indicator light will come on and the “TRAC OFF” will be shown
on the multi-information display.
Press again to turn the systems back on.
■ When the message is displayed on th e multi-information display show-
ing that TRAC has been disabled even if has not been pressed
TRAC and hill-start assist control cannot be operated. Contact your Toyota
dealer.
When the TRAC/VSC/ABS systems are operating
Disabling the TRAC system

244
PRIUS c_U (OM52E68U)5-1. Using the audio system
Audio system types ........... 246
5-2. Basic Operations (Multimedia system)
Multimedia system ............ 247
Steering wheel audio switches .......................... 249
USB port/AUX port ............ 250
Basic audio operations...... 252
5-3. Setup (Multimedia system)
Setup menu....................... 254
General settings ................ 255
Audio settings ................... 257
Display settings ................. 258
Voice settings.................... 259
5-4. Using the Multimedia system
Selecting the audio source ............................. 260
List screen operation......... 261
Optimal use of the multimedia system .......... 263
5-5. Using the radio (Multimedia system)
Radio operation................. 264
5-6. Playing an audio CD and MP3/WMA/AAC discs
(Multimedia system)
CD player operation .......... 266

245
5
PRIUS c_U (OM52E68U)5-7. Using an external device
(Multimedia system)
Listening to an iPod .......... 272
Listening to a USB memory device................ 277
Using the AUX port ........... 282
5-8. Connecting Bluetooth
®
(Multimedia system)
Preparations to use wireless
communication ................ 283
Registering a Bluetooth
®
audio player for
the first time .................... 287
Registering a Bluetooth
®
phone for
the first time .................... 288
Registering a Bluetooth
®
device.............................. 289
Connecting a Bluetooth
®
device.............................. 291
Displaying a Bluetooth
®
device details .................. 293
Detailed Bluetooth
®
system settings ............... 294
5-9. Bluetooth
® Audio
(Multimedia system)
Listening to Bluetooth
®
Audio ............................... 295 5-10. Bluetooth
® phone
(Multimedia system)
Using a Bluetooth
®
Phone ............................. 297
Making a call ..................... 300
Receiving a call ................. 303
Speaking on the phone ..... 304
Bluetooth
® phone
message function............ 308
Using the steering wheel switches ................ 313
Bluetooth
® phone
settings ........................... 314
Contact/ Call History Settings ....... 316
What to do if... (Troubleshooting) ............ 326
5-11. Bluetooth
®
(Multimedia system)
Bluetooth
®......................... 330
5-12. Using the voice command system
(Multimedia system)
Voice command system ............................ 335

247
5
Audio system
PRIUS c_U (OM52E68U)
5-2. Basic Operations (Multimedia system)
Multimedia system
: If equipped
Operations such as listening to audio, using the hands-free
phone and changing multimedia system settings are started by
using the following buttons.
Multimedia system operation buttons
“AUDIO” button
Display the “Select Audio Source”
screen or audio top screen.
(P. 260) button
Press this button to access the Bluetooth
® hands-free system.
( P. 297)
“CAR” button
Press this button to access the energy monitor/
consumption screen. ( P. 108)
“SETUP” button
Press this button to customize
the function settings. ( P. 254)