Page 107 of 540

1072. Instrument cluster
2
Instrument cluster
HILUX_OM_OM0K219E_(EE)■
Elapsed time
■Driving range
■Compass (if equipped)
→
P. 3 5 5
■Display off
A blank screen is displayed. Displays the elapsed time after the engine
switch is turned to the “ON” position.
• When the engine switch is turned on, time is
counted from 0:00. When the time exceeds
19:59, the counter returns to 0:00.
• The function can be reset by pressing the “RESET” button for longer than 1 second when
the elapsed time is displayed.
Displays the estimated maximum distance that
can be driven with the quantity of fuel remain-
ing.
• This distance is computed based on your aver-age fuel consumption. As a result, the actual
distance that can be driven may differ from that
displayed.
• When only a small amount of fuel is added to the tank, the display may not be updated.
When refueling, turn the engine switch to the
“LOCK” position. If the vehicle is refueled with-
out turn the engine switch to the “LOCK” posi-
tion, the display may not updated.
HILUX_OM_OM0K219E_(EE).book Page 107 Wednesday, May 14, 2014 3:06 PM
Page 109 of 540

1092. Instrument cluster
2
Instrument cluster
HILUX_OM_OM0K219E_(EE)
■Outside temperature display
In the following situations, the correct outside temperature may not be dis-
played, or the display may take longer than normal to change:
●When the vehicle is stopped, or moving at low speeds (less than 20 km/h
[12 mph])
● When the outside temperature has changed suddenly (at the entrance/exit
of a garage, tunnel, etc.)
■ When “--” is displayed
The system may be malfunctioning. Take your vehicle to any authorized
Toyota dealer or repairer, or another duly qualified and equipped professional.
■ When disconnecting and reconnecting battery terminals
The following information data and settings will be reset:
●Average fuel consumption
● Average vehicle speed
● Elapsed time
CAUTION
■Cautions during setting up the display
As the engine needs to be operating during setting up the display, ensure
that the vehicle is parked in a place with adequate ventilation. In a closed
area such as a garage, exhaust gases including harmful carbon monoxide
(CO) may collect and enter the vehicle. This may lead to death or a serious
health hazard.
NOTICE
■The information display at low temperatures
Allow the interior of the vehicle to warm up before using the liquid crystal
information display. At extremely low temperatures, the information display
monitor may respond slowly, and display changes may be delayed.
■
During setting up the display
To prevent battery discharge, ensure that the engine is operating while set-
ting up the display features.
HILUX_OM_OM0K219E_(EE).book Page 109 Wednesday, May 14, 2014 3:06 PM
Page 116 of 540

1163-2. Opening, closing and locking the doors
HILUX_OM_OM0K219E_(EE)
The following functions can be set or canceled:
■Before setting and canceling the functionsRemove the key from the engine switch and check that the alarm
system is disarmed.
Within 5 seconds, insert and remove the key twice in quick suc-
cession.
Wait for 5 seconds and within the next 5 seconds, push and hold
the lock and unlock buttons simultaneously for 3 seconds or
more. The turn signal lights will flash once indicating operation
success to this point.
Select the function you wish to set and follow the procedures below.
To cancel the operation, insert the key into the engine switch.
The optional functions (vehicles with alarm system)
FunctionOperation
Answerback function (on vehicles
with two batteries, the security horn
does not sound) The answerback function can be
turned on or off. Locking or unlock-
ing is indicated by flashing the turn
signal lights and sounding of the
security horn, or flashing of the turn
signal lights only. The security horn
sounds if any door is not securely
closed.
Automatic locking and unlocking
function
All the doors will lock automatically
at 25 km/h (16 mph) or higher vehi-
cle speed.
When the engine switch is turned to
the “LOCK” position, all the doors
will be unlocked automatically.
(Even if the vehicle is subject to a
strong impact, all the doors will not
be unlocked automatically.)
1
2
3
HILUX_OM_OM0K219E_(EE).book Page 116 Wednesday, May 14, 2014
3:06 PM
Page 130 of 540
1303-2. Opening, closing and locking the doors
HILUX_OM_OM0K219E_(EE)
◆Door lock switch (if equipped)Locks all the doors
Unlocks all the doors
◆Inside lock buttons
Locks the door
Unlocks the door
The driver’s door can be opened
by pulling the inside handle
even if the lock button is in the
lock position.
Move the inside lock button to the lock position.
Close the door while pulling the door handle.
The door cannot be locked if the key is in the engine switch.
1
2
1
2
Locking the front doors from the outside without a key
1
2
HILUX_OM_OM0K219E_(EE).book Page 130 Wednesday, May 14, 2014 3:06 PM
Page 147 of 540