2015 TOYOTA CAMRY display

4888-2. Steps to take in an emergency
CAMRY_U (OM33A86U)
Ensure that the shift lever is in P and firmly depress the brake
pedal.
Touch the Toyota emblem side
of the electronic key to the
engine switch.
When the electronic key is
detected, a buzzer sounds and the
engine switch will turn to IGNITION
ON mode.
When the smart key system is
deactivated in customization set-
ting, the engine switch will turn to
ACCESSORY mode.
Firmly depress the brake pedal and check that is displayed
on the multi-information display.
Press the engine switch.
In the event that the engine still c annot be started, contact your Toyota
dealer.
■ Stopping the engine
Shift the shift lever to P and press the engine switch as you normally do when
stopping the engine.
■ Replacing the key battery
As the above procedure is a temporary measure, it is recommended that the
electronic key battery be replaced immediately when the battery is depleted.
(P. 420)
■ Changing engine switch modes
Release the brake pedal and press the engine switch in step above.
The engine does not start and modes will be changed each time the switch is
pressed. ( P. 158)
■ When the electronic key does not work properly
●Make sure that the smart key system has not been deactivated in the cus-
tomization setting. If it is off, turn the function on.
(Customizable features P. 525)
● Check if battery-saving mode is set. If it is set, cancel the function.
(P. 116)
Starting the engine
1
2
3
4
3

4938-2. Steps to take in an emergency
8
When trouble arises
CAMRY_U (OM33A86U)
●Vehicles without a multi-informatio n display: The rightmost segment
of the engine coolant temperature display ( P. 77) is flashing or a
loss of engine power is experienc ed. (For example, the vehicle
speed does not increase.)
● Vehicles with a multi-information display: The needle of the engine
coolant temperature gauge ( P. 77) enters the red zone or a loss
of engine power is experienced. (For example, the vehicle speed
does not increase.)
● Vehicles with a multi-information display: “Engine Coolant Temp is
High” is shown on the multi-information display.
● Steam comes out from under the hood.
Stop the vehicle in a safe place and turn off the air conditioning sys-
tem, and then stop the engine.
If you see steam:
Carefully lift the hood after the steam subsides.
If you do not see steam:
Carefully lift the hood.
After the engine has cooled
down sufficient ly, inspect the
hoses and radiator core (radia-
tor) for any leaks.
Radiator
Cooling fans
If a large amount of coolant
leaks, immediately contact your
Toyota dealer.
If your vehicle overheats
The following may indicate that your vehicle is overheating.
Correction procedures
1
2
3
1
2

4978-2. Steps to take in an emergency
8
When trouble arises
CAMRY_U (OM33A86U)
■When it is difficult to free the vehicle
Press to turn off TRAC.
*1: Vehicles without multi-information dis-
play
*2: Vehicles with multi-information display
WARNING
■ When attempting to free a stuck vehicle
If you choose to push the vehicle back and forth to free it, make sure the
surrounding area is clear to avoid striking other vehicles, objects or people.
The vehicle may also lunge forward or lunge back suddenly as it becomes
free. Use extreme caution.
■ When shifting the shift lever
Be careful not to shift the shift lever with the accelerator pedal depressed.
This may lead to unexpected rapid acceleration of the vehicle that may
cause an accident resulting in death or serious injury.
NOTICE
■To avoid damaging the transm ission and other components
● Avoid spinning the front wheels and depressing the accelerator pedal
more than necessary.
● If the vehicle remains stuck even after these procedures are performed,
the vehicle may require towing to be freed.
*1
*2

5269-2. Customization
CAMRY_U (OM33A86U)
Some function settings are changed simultaneously with other func-
tions being customized. Contact your Toyota dealer for further details.
Definition of symbols: O = Available, —=Not available
■
Gauges, meters and mult i-information display (P. 77, 83)
Vehicles without a multi-information display
Settings that can be changed on the Entune Audio system
screen
Settings that can be changed by display change button
Settings that can be changed by your Toyota dealer
Vehicles with a mult i-information display
Settings that can be changed on the Entune Audio system
screen
Settings that can be changed by the meter control switches
Settings that can be changed by your Toyota dealer
Customizable features
1
2
3
Function*1Default settingCustomized set- ting
Eco Driving Indicator
LightOn
(Self-lighting)Off—OO
123
1
2
3
Function*1Default settingCustomized set- ting
Language*2EnglishFrenchOO—Spanish
Units*2miles (MPG US)
km (km/L)
OO—km (L/100 km)
miles (MPG
CAN)
°F°C—O—
Eco Driving Indicator
LightOffOn
(Self-lighting)—O—
123

5279-2. Customization
9
Vehicle specifications
CAMRY_U (OM33A86U)
*1: For details about each function: P. 8 6
*2: The default setting varies according to country.
*3: Speed limit display may not be available for some regions.
*4: U.S.A. only
Drive information 1
Digital speedom-eter
6 of the following items: P. 8 5
—O—Distance to empty
Drive information 2
Average fuel
economy (after
reset)
—O—
Current fuel economy
Drive information 3
Trip distance (after reset)
—O—
Trip elapsed time
Pop-up displayOnOff—O—
Accent colorLight blue
Blue
OO—Orange
Yellow
Speed limit display*3
On with the
speed limit cau- tion indicator
(yellow) enabled
On with the
speed limit cau-
tion indicator (yellow) not enabled
—OO
Off
Maintenance system ini-
tialization
*4OffOn—O—
Function*1Default settingCustomized set- ting123

534
CAMRY_U (OM33A86U)
9-3. Items to initialize
Items to initialize
The following items must be initialized for normal system opera-
tion after such cases as maintenance being performed on the
vehicle:
ItemWhen to initializeReference
Maintenance required
reminder light (vehicles
without a multi-information
display) or message indicat-
ing maintenance is required
(vehicles with a multi-infor-
mation display)
(U.S.A. only)
After the maintenance is per-
formedP. 381
Tire pressure warning sys-
temWhen changing the tire infla-
tion pressure by changing trav-
eling speed or load weight, etc.
P. 405

552What to do if... (Troubleshooting)
CAMRY_U (OM33A86U)
●Vehicles without a smart key system:
It is locked to prevent theft of the vehicle if the key is pulled from the engine
switch. (P. 156)
Vehicles with a smart key system:
It is locked automatically to prevent theft of the vehicle. ( P. 159)
●Is the window lock switch pressed?
The power window except for the one at the driver’s seat cannot be oper-
ated if the window lock switch is pressed. (P. 133)
●The auto power off function will be operated if the vehicle is left in ACCES-
SORY or IGNITION ON mode (the engine is not running) for a period of
time. ( P. 159)
●The seat belt reminder light is flashing
Are the driver and the front passenger wearing the seat belts? ( P. 448)
●The brake system warning light is on
Is the parking brake released? (P. 167)
Depending on the situation, other types of warning buzzer may also sound.
( P. 446, 456)
●Is the electronic key left inside the vehicle or the moon roof open?
Check the message on the multi-information display. ( P. 456)
The steering wheel cannot be turned after the engine is
stopped
The windows do not open or close by operating the power
window switches
The engine switch is turned off automatically
(vehicles with a smart key system)
A warning buzzer sounds during driving
A warning buzzer sounds when leaving the vehicle
(vehicles with a smart key system)

553What to do if... (Troubleshooting)
CAMRY_U (OM33A86U)

●Did anyone inside the vehicle open a door during setting the alarm?
The sensor detects it and the alarm sounds. (P. 69)
●Vehicles without a smart key system:
To stop the alarm, turn the engine switch to the “ON” position or start the
engine.
Vehicles with a smart key system:
To stop the alarm, turn the engine switch to IGNITION ON mode or start
the engine.
●When a warning light turns on, refer to P. 446.
●When a warning light turns on or a warning message or indicator is dis-
played, refer to P. 446, 456.
●Stop the vehicle in a safe place and replace the flat tire with the spare
tire. (P. 472)
●Try the procedure for when the vehicle becomes stuck in mud, dirt, or
snow. ( P. 496)
An alarm is activated and the horn sounds
(vehicles with an alarm)
A warning light turns on
(vehicles without a multi-information display)
A warning light turns on or a warning message or indicator
is displayed (vehicles with a multi-information display)
When a problem has occurred
If you have a flat tire
The vehicle becomes stuck