2015 TATA SAFARI air bleeding

109
FUEL FIL FUEL FILFUEL FIL FUEL FIL
FUEL FIL
TER & FUEL SY TER & FUEL SYTER & FUEL SY TER & FUEL SY
TER & FUEL SY
STEM STEMSTEM STEM
STEM
6. Refit the drain plug using a new sealing washer. Tighten
drain plug to 5 mkg. torque.
7. Fill, recommended quantity of fresh engine oil in the crank
case and secure the oil filler cap in its place.
8. Start the engine and run for a few minutes. The engine oil
pressure indicator lamp should go ‘off ’ after starting the
engine.
9. Check for engine oil leakages.
10. Stop the engine and recheck engine oil level after a few
minutes. If necessary add oil to bring the level to the upper
mark on the dipstick.
NOTICE NOTICENOTICE NOTICE
NOTICE
Use of reclaimed oil is not recommended
Priming Pump Priming PumpPriming Pump Priming Pump
Priming Pump
Priming pump is used for priming the fuel manually after
overhauling of the engine or after refitment of fuel lines. Pump
the fuel by means of priming pump until all air in the fuel line is
removed. Before cranking the engine ensure that there is no air
in the fuel system.
NOTICE NOTICENOTICE NOTICE
NOTICE
Please do not loosen/remove high pressure pipes and injectors
for air bleeding in the fuel.
M A I N T E N A N C E
F FF F
F
uel & F uel & Fuel & F uel & F
uel & F
ilt iltilt ilt
ilt
er D er Der D er D
er D
r rr r
r
aining ainingaining aining
aining
Loosen drain plugs by 1-2 turn and drain out water and other
sediments from fuel filter bowls depending on operating
conditions to ensure that no water is allowed to enter the fuel
system.
S SS S
S
edimen edimenedimen edimen
edimen
t tt t
t
er er er er
er
W WW W
W
a aa a
a
t tt t
t
er D er Der D er D
er D
r rr r
r
aining ainingaining aining
aining
Water sedimenter is located near fuel tank at rear left hand side
of the vehicle.
Loosen drain plug by 1-2 turns and drain out water and other
sediments from sedimenter when water level indicator lamp
glows in instrument cluster to ensure that no water is
allowed to enter the fuel system.
Sedimenter
ProCarManuals.com

116
POWER STEERING POWER STEERINGPOWER STEERING POWER STEERING
POWER STEERING
Procedure for Oil Filling and Bleeding of Power Procedure for Oil Filling and Bleeding of PowerProcedure for Oil Filling and Bleeding of Power Procedure for Oil Filling and Bleeding of Power
Procedure for Oil Filling and Bleeding of Power
Steering SteeringSteering Steering
Steering (Ensure that Power Steering fluid reservoir is totally
clean before starting the work)
1 . Fill the reservoir nearly full. Crank the engine for 10
seconds without allowing it to start (if possible). If engine
does start, shut the engine immediately. Check & refill
the reservoir repeat atleast three times, each time
checking & refilling the reservoir.
2 . Check for leakage in the system and if noticed take
corrective action.
3 . Start the engine and steer the vehicle from full left to full
right turns 3-4 times.
4 . Add fluid if necessary to maintain the level upto filter top.
NOTICE NOTICENOTICE NOTICE
NOTICE
Do not force the wheel against lock position either
extreme left or right. The power steering pump may get
damaged. Hold it lightly.
5 . When the engine is at steady speed, check for bubble
or foaming in the oil. If present it indicates that air is
getting sucked into the systems. Check the suction
line/fittings and correct if necessary.
6 . Once the system is bled properly and free from foaming
there should not be any appreciable change in oil level
in the reservoir, when the engine is started or stopped
repeatedly.
7 . Now the system is ready for driving.
Final oil level should be at ‘H’ mark on dip stick.
NOTICE NOTICENOTICE NOTICE
NOTICE
* Do not allow fluid level to drop significantly or run out
of the reservoir during the above operation. This may
induce air to the system.
* Do not start the engine without oil in the power steering
system. This will result in serious damage to the
pump. In case of emergency disconnect the pump belt
and then start the engine.
* Always use recommended oil from closed containers.
Any dirty oil poured in the system will result in damage
to pump and gear box.
M A I N T E N A N C E
ProCarManuals.com

141
PRELIMINAR PRELIMINARPRELIMINAR PRELIMINAR
PRELIMINAR
Y Y Y Y
Y
TR TRTR TR
TR
OUBLE SHOO OUBLE SHOOOUBLE SHOO OUBLE SHOO
OUBLE SHOO
TING TINGTING TING
TING
SR. NO. SR. NO.SR. NO. SR. NO.
SR. NO.
PROBLEM OBSERVED PROBLEM OBSERVEDPROBLEM OBSERVED PROBLEM OBSERVED
PROBLEM OBSERVED
PROBABLE CAUSE PROBABLE CAUSEPROBABLE CAUSE PROBABLE CAUSE
PROBABLE CAUSE
A AA A
A
CTION CTION CTION CTION
CTION
T TT T
T
O BE O BE O BE O BE
O BE
T TT T
T
AKEN AKENAKEN AKEN
AKEN
STEERING SYSTEM STEERING SYSTEMSTEERING SYSTEM STEERING SYSTEM
STEERING SYSTEM
1. Hard steeringLess fluid in the power steering • Get the fluid topped up to
tankcorrect level
Air in the system • Get the air removed by bleeding
the system
Loose pump belt • Get the belt correctly adjusted
ELECTRICAL ELECTRICALELECTRICAL ELECTRICAL
ELECTRICAL
1. No lights on the dash board after Battery terminal got disconnected• Get the battery properly
turning on the ignition key Battery completely dead connected
• Get the battery charged
• Get the alternator & charging
circuit checked
• Check for parking lamp fuse
2. Non functioning electricalBlown fuse in the circuit • Replace the fuse if blown
accessories such as powerLoose connectors • Get the connection properly
windows, head lamps, fueltightened
tank flap, wiper and washer etc. Circuit relay loose • Tighten the relay correctly
in the mounting
Defective components • Get the defective component
replaced from Authorised
Workshop
PRELIMINARY TROUBLE SHOOTING
ProCarManuals.com