Page 267 of 288
Downloaded from www.Manualslib.com manuals search engine
( 0 ( 5 * ( 1 & < 6 ( 5 9 , & (
0 6 (
NOTE:
For more details, please contact an
D X W K R U L V H G 0 D U X W L 6 X ] X N L Z R U N V K R S. & K D Q J L Q J : K H H O VTo change a wheel, use the following pro-
cedure:
1) Remove the jack, tools and spare
wheel from the vehicle.
2) Loosen, but do not remove the wheel
nuts.
3) Jack up the vehicle (follow the jacking
instructions in this section).
4) Remove the wheel nuts and wheel.
65J4033
5) Before installing the new wheel, clean
any mud or dirt off from the surface of
the wheel (1), hub (2), thread part (3)
and surface of the wheel nuts (4) with a
clean cloth. Clean the hub carefully; it
may be hot from driving.
6) Install the new wheel and replace the
wheel nuts with their cone shaped end
facing the wheel. Tighten each nut
snugly by hand until the wheel is
securely seated on the hub.
7 L J K W H Q L Q J W R U T X H I R U Z K H H O Q X W
1 P N J P O E I W
7) Lower the jack and fully tighten the nuts
in a crisscross fashion with a wrench as
shown in the illustration.
NOTICE
1 H Y H U D S S O \ D J D U D J H M D F N W R W K H
H [ K D X V W S L S H V L G H X Q G H U V S R L O H U L I
H T X L S S H G H Q J L Q H X Q G H U F R Y H U R U U H D U
W R U V L R Q E H D P
: $ 5 1 , 1 *
Page 269 of 288
Downloaded from www.Manualslib.com manuals search engine
( 0 ( 5 * ( 1 & < 6 ( 5 9 , & (
0 6 (
4) If the booster battery you are using is fit-
ted to another vehicle, start the engine of
the vehicle with the booster battery. Run
the engine at moderate speed.5) Start the engine of the vehicle with the
flat battery.
6) Remove the jump leads in the exact
reverse order in which you connected
them.
7 R Z L Q JIf you need to have your vehicle towed,
contact a professional service. Your dealer
can provide you with detailed towing
instructions.
: K H H O ' U L Y H : ' 0 D Q X D O 7 U D Q
V D [ O HManual transaxle vehicles may be towed
using either of the following methods.
1) From the front, with the front wheels
lifted and the rear wheels on the ground.
Before towing, make sure that the park-
ing brake is released.
2) From the rear, with the rear wheels lifted
and the front wheels on the ground, pro-
vided the steering and drivetrain are in
operational condition. Before towing,
make sure that transaxle is in neutral,
the steering wheel is unlocked (vehicle
without keyless push start system - the
ignition key should be in the “ACC” posi-
tion) (vehicle with keyless push start sys-
tem - the ignition mode is ACC), and the
steering wheel is secured with a clamp-
ing device designed for towing service.
& $ 8 7 , 2 1
& R Q Q H F W W K H M X P S O H D G W R W K H H Q J L Q H
P R X Q W E U D F N H W V H F X U H O \ , I W K H M X P S
O H D G G L V F R Q Q H F W V I U R P W K H H Q J L Q H
P R X Q W E U D F N H W E H F D X V H R I Y L E U D W L R Q D W
W K H V W D U W R I W K H H Q J L Q H W K H M X P S O H D G
F R X O G E H F D X J K W L Q W K H G U L Y H E H O W V
NOTICE
2 E V H U Y H W K H I R O O R Z L Q J L Q V W U X F W L R Q V
Z K H Q W R Z L Q J \ R X U Y H K L F O H
Page 276 of 288
Downloaded from www.Manualslib.com manuals search engine $ 3 3 ( $ 5 $ 1 & ( & $ 5 (
0 6 (
NOTE:
• In order to keep leather upholstery look-
ing good, it should be cleaned at least
twice a year.
• If leather upholstery becomes wet,
immediately wipe it dry with tissue paper
or a soft cloth. Water may cause leather
to harden and shrink if it is not wiped off.
• When parking on sunny days, select a
shady place or use a sunshade. If
leather upholstery is exposed to direct
sunlight for a long time, it may discolor
and shrink.
• As is common with natural materials,
leather is inherently irregular in grain and
cowhide has spots in its natural state.
These do not affect the performance of
the leather in any way.
6 H D W E H O W V
Clean seat belts with a mild soap and
water. Do not use bleach or dye on the
belts. They may weaken the fabric in the
belts.
9 L Q \ O I O R R U P D W V
Ordinary dirt can be removed from vinyl
with water or mild soap. Use a brush to
help loosen dirt. After the dirt is loosened,
rinse the mat thoroughly with water and
dry it in the shade.
& D U S H W V
Remove dirt and soil as much as possible
with a vacuum cleaner. Using a mild soap
solution, rub stained areas with a clean
damp cloth. To remove soap, rub the areasagain with a cloth dampened with water.
Repeat this until the stain is removed, or
use a commercial carpet cleaner for
tougher stains. If you use a carpet cleaner,
carefully follow the manufacturer’s instruc-
tions and precautions.
, Q V W U X P H Q W S D Q H O D Q G F R Q V R O H
Remove loose dirt with a vacuum cleaner.
Gently wipe dirt off with a tightly squeezed
damp clean cloth. Repeat this until the dirt
is removed.
& O H D Q L Q J W K H ( [ W H U L R U & D U L Q J I R U $ O X P L Q X P : K H H O V
NOTE:• Do not use an acidic or alkaline detergent
to wash aluminum wheels. These types of
detergent will cause permanent spots,
discoloration and cracks on finished sur-
faces.
• Do not use a bristle brush and soap con-
taining an abrasive material. These will
damage finished surfaces.
NOTICE
' R Q R W X V H F K H P L F D O S U R G X F W V W K D W
F R Q W D L Q V L O L F R Q W R Z L S H H O H F W U L F D O
F R P S R Q H Q W V V X F K D V W K H D L U F R Q G L
W L R Q L Q J V \ V W H P D X G L R Q D Y L J D W L R Q
V \ V W H P R U R W K H U V Z L W F K H V 7 K H V H Z L O O
F D X V H G D P D J H W R W K H F R P S R Q H Q W V
NOTICE
, W L V L P S R U W D Q W W K D W \ R X U Y H K L F O H E H
N H S W F O H D Q D Q G I U H H I U R P G L U W ) D L O X U H
W R N H H S \ R X U Y H K L F O H F O H D Q P D \ U H V X O W
L Q I D G L Q J R I W K H S D L Q W R U F R U U R V L R Q W R
Y D U L R X V S D U W V R I W K H Y H K L F O H E R G \
Page 277 of 288
Downloaded from www.Manualslib.com manuals search engine
$ 3 3 ( $ 5 $ 1 & ( & $ 5 (
0 6 (
: D V K L Q J
60B212S
When washing the vehicle, park it where
direct sunlight does not fall on it and follow
the instructions below:
1) Flush the underside of body and wheel
housings with pressurized water to
remove mud and debris. Use plenty of
water.
2) Rinse the body to loosen the dirt.
Remove dirt and mud from the body
exterior with running water. You may
use a soft sponge or brush. Do not use
hard materials which can scratch the
paint or plastic. Remember that the
headlight covers or lenses are made of
plastic in many cases.3) Wash the entire exterior with a mild
detergent or car wash soap using a
sponge or soft cloth. The sponge or
cloth should be frequently soaked in the
soap solution.
4) Once the dirt has been completely
removed, rinse off the detergent with
running water.
5) After rinsing, wipe off the vehicle body
with a wet chamois or cloth and allow it
to dry in the shade.
: $ 5 1 , 1 *
Page 283 of 288
Downloaded from www.Manualslib.com manuals search engine 11-1
SPECIFICATIONS
64MS0-74E
SPECIFICATIONS
NOTE:
Specifications are subject to change without notice.
M/T: Manual transaxle
ITEM: Dimensions UNIT: mm
Overall length4300
Overall width1765
Overall height without Roof rails 1585
with Roof rails 1590
Wheelbase2600
Track Front 1535
Rear 1505
ITEM: Mass (weight) UNIT: kg
Curb mass (weight) D13A 1180 – 1205
D16AA 1250 – 1275
Gross vehicle mass (weight) rating D13A 1670
D16AA 1740
Permissible maximum Axle Weight
FrontD13A 860
D16AA 940
Rear 840
Page 286 of 288
Downloaded from www.Manualslib.com manuals search engine 6 3 ( & , ) , & $ 7 , 2 1 6
0 6 (
*1 When tire replacement is necessary and if the specified load index and speed rated tire is not available, then use a tire of higher load
index and speed rating.
*2: The spare wheel provided with alloy wheel variant is steel wheel rim, hence follow 4 tire rotation only.
(Refer: Section
“Inspection and maintenance”)
, 7 ( 0 : K H H O V D Q G 7 L U H V
Tire size, front and rear
205/60R16 92H
*1*2
Tire size, spare
205/60R16 92H
*2 (Steel wheel)
Rim size 205/60R16 tire: 16X6J
Tire pressures For the specified tire pressure, see the Tire Information Label located
on the driver’s door lock pillar.
, 7 ( 0 5 H F R P P H Q G H G ) X H O / X E U L F D Q W V D Q G & D S D F L W L H V D S S U R [
Fuel 48 L
Engine oil D13A 3.2 L (replacement with oil filter)
D16AA 5.25 L (replacement with oil filter)
Engine coolant D13A 6.0 L (including reservoir tank)
D16AA 5.5 L (including reservoir tank)
Manual transaxle oil 5M/T 2.6 L
6M/T 2.1 L
Brake fluid / Clutch fluid Refill to the proper oil level according to the instructions in the “INSPEC-
TION AND MAINTENANCE” section.
