Page 20 of 232

JauneNoir Noir texte
20
ENG_UD27217_3
Si ges avant (X45 - H45 - Renault) ENG_NU_1057-1_H45_Ph3_Renault_1
FRONT SEATS (2/2)
To fold down the passenger seat
Depending on the vehicle, the passen-
ger seatback may be folded down onto
the seat base to create a table.
Lift handle 6 and lower the seatback.
6
Heated seats(depending on vehicle)
With the engine running, press
switch 8, pressing on the top of the
switch (to select the warmest setting) or
the bottom of the switch (to select the
average setting).
The indicator light on the button lights
up.
The system, which has a thermostat,
decides whether or not the heating is
needed, according to the position se-
lected.
If the heated front passenger seat is ac-
tivated, the indicator light
ð lights
up on the instrument panel.
78
Since front passenger airbag operation and the position of a front pas-
senger seatback table are incompatible, ensure that the airbag is deac-
tivated. (Refer to the information on “Front passenger air bag activation/
deactivation” in Section 1).
There is a risk of very serious injury if the air bags deploy.
When driving, rear passengers must not place their feet on the seatback of the
front seats under any circumstances. Risk of injury.
To adjust the lumbar support on the
driver’s seat:
Move lever 7.
Page 149 of 232

JauneNoir Noir texte
149
ENG_UD8576_2
Banquette arri re (X45 - H45 - Renault) ENG_NU_1057-1_H45_Ph3_Renault_3
REAR BENCH SEAT FUNCTIONS (1/2)
When adjusting the seat, always ensure that the seat belt can return to
its original position.
When refitting the seatback, make sure it is correctly locked in place.
2
3
4
5
1
To fold down the rear seats
from inside the passenger
compartment
– lower the headrest;
– move the front seat as far forward as
necessary;
– feed the seat belt into the clip 5;
– pull lever 3: the seat base is raised;
– pull handle 4 and fold down the seat-
back.
Check that no-one, includ-
ing animals, is in the vicin-
ity of the rear bench seat
before pulling handle 1.
Risk of injury.
To fold down the rear
seats from the luggage
compartment
(depending on vehicle)
– lower the headrests;
– move the front seat as far forward as
necessary;
– feed the seat belt into the clip 5;
– use the controls 1.
To return the seat to its
original position
– lift the seatback and return it to its
original position;
– fold down the seat base 2;
– ensure that the seat is correctly
locked in position.
When the seat belt is not being used,
attach it to hook 5.
Page 154 of 232

JauneNoir Noir texte
154
ENG_UD23502_5 Transport d’objets dans le coffre, remorquage (attelage) (X45 - H45 - Renault) ENG_NU_1057-1_H45_Ph3_Renault_3
32323
TRANSPORTING OBJECTS IN THE LUGGAGE COMPARTMENT/TOWING (towing equipment)
B
C
Always place the objects to be trans- ported so that their largest side rests against the back of the rear bench seat, for normal loads (example A), or against the back of the front seats when the rear bench seatbacks are folded down (example B).
A
Always position the heavi- est items directly on the floor. Use the lashing points on the floor of the luggage compartment, if these are fitted to the vehicle. The luggage should be loaded in such a way that no items will be thrown forward and strike the occupants if the driver has to brake suddenly. Fasten the rear seat belts, even if the seats are not occupied.C : 1138 mm
Permissible nose weight, maximum permissible towing weight, braked and unbraked: refer to the information on “Weights” in Section 6.
32322