Page 186 of 270

4.4
–  remove the dipstick and wipe with a clean, lint-free cloth;
–  push the dipstick in as far as it will  go (for vehicles equipped with a cap-
type dipstick C, screw the cap in as 
far as it will go);
–  take out the dipstick again;
–  read the level: it should never fall  below minimum mark  A or exceed 
maximum mark B.
Once the operation has been com-
pleted, ensure that the dipstick is 
pushed in as far as it will go or that 
the “cap-type dipstick” is completely 
screwed in.
ENGINE OIL LEVEL: general information
It is normal for an engine to use oil for 
lubrication and cooling of moving parts 
and it is normal to top up the level be-
tween oil changes.
However, contact your approved 
Dealer if more than 0.5 litres is being 
consumed every 600 miles (1,000 km) 
after the running in period.
Oil change frequency: check the oil 
level from time to time and certainly 
before any long journey to avoid the 
risk of damaging your engine.
C
A
B
A
B
In order to prevent splashback, it is 
recommended that a funnel be used 
when topping up/filling with oil.
Reading the oil levelThe oil level should be read with the ve-
hicle on level ground, after the engine 
has been switched off for some time.
The dipstick must be used to read 
the exact oil level and make sure 
that the maximum level has not been 
exceeded (risk of engine damage).  
Refer to the following pages.
The instrument panel display only 
alerts the driver when the oil level is at 
its minimum.
Before performing any 
action in the engine com-
partment, the ignition must 
be switched off by pressing 
the engine stop button (please see 
the information on “Starting, stop-
ping the engine” in Section 2).
Exceeding the maximum 
engine oil level
Under no circumstances 
must the maximum fill 
level  B be exceeded: risk of damage 
to the engine and catalytic con-
verter.
If the oil level exceeds the maximum 
level,  do not start your vehicle  and 
contact an approved Dealer.
Consult your approved Dealer at 
once if you notice an abnormal or 
repeated drop in any of the fluid 
levels.  
     
        
        Page 187 of 270

4.5
ENGINE OIL LEVEL: topping up, filling (1/3)
Topping up/filling
The vehicle must be parked on level 
ground and the engine should be cold 
(for instance, before the engine is 
started up for the first time in the day).– Unscrew cap 
1;
–  top up the level (as a guide, the ca- pacity between the minimum and 
maximum reading on the dipstick  2 
is between 1.5 and 2 litres, depend-
ing on the engine);
–  wait for approximately 20 minutes to  allow the oil to flow into the engine;
–  check the level using the dipstick  2 
(as described above).
Once the operation has been com-
pleted, ensure that the dipstick is 
pushed in as far as it will go or that 
the “cap-type dipstick” is completely 
screwed in.
Do not exceed the  max level and 
do not forget to refit cap  1 and dip-
stick 2.
12
1
2
1
2
Before performing any 
action in the engine com-
partment, the ignition must 
be switched off by pressing 
the engine stop button (please see 
the information on “Starting, stop-
ping the engine” in Section 2).In order to prevent splashback, it is 
recommended that a funnel be used 
when topping up/filling with oil.    
     
        
        Page 188 of 270
4.6
ENGINE OIL LEVEL: topping up, filling (2/3)
2
2
2
1
2
1
1
1
In order to prevent splashback, it is 
recommended that a funnel be used 
when topping up/filling with oil.
Do not exceed the max level and 
do not forget to refit cap  1 and dip-
stick 2.