Page 109 of 414
WARNING!
ALL the head restraints MUST be reinstalled in the
vehicle to properly protect the occupants. Follow the
re-installation instructions above prior to operating
the vehicle or occupying a seat.
TO OPEN AND CLOSE THE HOOD
To open the hood, two latches must be released.
1. Pull the release lever located below the instrumentpanel and in front of the driver’s door.
Center Head Restraint
1 — Release Button
2 — Adjustment Button
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 107
Page 110 of 414
2. Move to the outside of the vehicle, reach into theopening beneath the center of the hood and push up
the safety latch lever to release it, before raising the
hood. 3. Raise the hood and place the hood prop rod in hood
slot to secure the hood in the open position.
Hood Release LeverHood Safety Latch Lever Location
108 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 341 of 414

the application of any lubricant, the parts concerned
should be wiped clean to remove dust and grit; after
lubricating excess oil and grease should be removed.
Particular attention should also be given to hood latching
components to ensure proper function. When performing
other underhood services, the hood latch, release mecha-
nism and safety catch should be cleaned and lubricated.
The external lock cylinders should be lubricated twice a
year, preferably in the Fall and Spring. Apply a small
amount of a high quality lubricant, such as MOPAR®
Lock Cylinder Lubricant directly into the lock cylinder.
Windshield Wiper Blades
Clean the rubber edges of the wiper blades and the
windshield periodically with a sponge or soft cloth and a
mild nonabrasive cleaner. This will remove accumula-
tions of salt or road film.Operation of the wipers on dry glass for long periods
may cause deterioration of the wiper blades. Always use
washer fluid when using the wipers to remove salt or dirt
from a dry windshield.
Avoid using the wiper blades to remove frost or ice from
the windshield. Keep the blade rubber out of contact with
petroleum products such as engine oil, gasoline, etc.
NOTE:
Life expectancy of wiper blades varies depending
on geographical area and frequency of use. Poor perfor-
mance of blades may be present with chattering, marks,
water lines or wet spots. If any of these conditions are
present, clean the wiper blades or replace as necessary.
Wiper Service Position
If it is necessary to lift the blade from the windshield (In the
event of snow or blade replacement) Proceed as directed:
1. Rotate the end of the multifunction lever to the OFF position.
7
MAINTAINING YOUR VEHICLE 339
Page 404 of 414

Speedometer......................... .147
Tachometer ........................... .147
Gear Ranges ............................ .206
Gear Select Lever Override ..................321
General Information ....................180, 260
Glass Cleaning .......................... .358
Gross Axle Weight Rating ................267, 270
Gross Vehicle Weight Rating ..............267, 270
Guide, Body Builders ........................6
GVWR ................................ .267
Hazard Driving Through Flowing, Rising, or Shallow
Standing Water ........................ .214
Hazard Warning Flasher ....................287
Headlights ..............................110
Cleaning ............................ .358
Passing ..............................111
Head Restraints ......................... .103Heated Mirrors
.......................... .140
Heated Seats ............................ .102
Heater, Engine Block ...................... .201
Hill Start Assist .......................... .223
Hitches Trailer Towing ........................ .273
Holder, Cup ............................ .135
Hood Release ........................... .107
Ignition .................................12
Key..................................12
Ignition Key Removal .......................12
Immobilizer (Sentry Key) ....................14
Inside Rearview Mirror ......................94
Instrument Cluster .....................146, 147
Instrument Panel and Controls ................145
Instrument Panel Cover .....................357
Instrument Panel Lens Cleaning ...............359
Interior Appearance Care ....................357
402 INDEX