2015 Ram Cargo Van radio

WARNING ALERTS
Rear Distance (in/cm) Greater than
79 in (200 cm) 79-39 in
(200-100 cm) 39-25 in
(100-65 cm) 25-12 in
(65-30 cm) Less than
12 in (30 cm)
Audible Alert Chime None
Single 1/2
Second Tone Slow
FastContinuous
Arcs None3 Solid
(Continuous) 3 Slow
Flashing 2 Slow
Flashing 1 Slow
Flashing
Radio Volume Reduced No
Yes YesYes Yes
NOTE: ParkSense® will reduce the radio volume, if on,
when the system is sounding an audio tone.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 221

Cleaning The ParkSense® System
Clean the ParkSense® sensors with water, car wash soap
and a soft cloth. Do not use rough or hard cloths. Do not
scratch or poke the sensors. Otherwise, you could dam-
age the sensors.
ParkSense® System Usage Precautions
NOTE:
•Ensure that the rear bumper is free of snow, ice, mud,
dirt and debris to keep the ParkSense® system oper-
ating properly.
• Jackhammers, large trucks, and other vibrations could
affect the performance of ParkSense®.
•
When you turn ParkSense® OFF, the instrument cluster
will display “PARK ASSIST SYSTEM OFF.” Further-
more, once you turn ParkSense® off, it remains off until
you turn it on again, even if you cycle the ignition key.
• When you move the shift lever to the REVERSE
position and ParkSense® is turned OFF, the EVIC will
display “PARK ASSIST SYSTEM OFF” message for as
long as the vehicle is in REVERSE.
• ParkSense®, when on, will reduce the radio volume
when it is sounding a tone.
• Clean the ParkSense® sensors regularly, taking care
not to scratch or damage them. The sensors must not
be covered with ice, snow, slush, mud, dirt or debris.
Failure to do so can result in the system not working
properly. The ParkSense® system might not detect an
obstacle behind the fascia/bumper, or it could provide
a false indication that an obstacle is behind the fascia/
bumper.
• Ensure the ParkSense® system is OFF if objects such as
bicycle carriers, trailer hitches, etc. are placed within
12 in (30 cm) from the rear fascia/bumper. Failure to
do so can result in the system misinterpreting a close
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 223

Before You Begin Programming HomeLink®
Be sure that your vehicle is parked outside of the garage
before you begin programming.
For more efficient programming and accurate transmis-
sion of the radio-frequency signal it is recommended that
a new battery be placed in the hand-held transmitter of
the device that is being programmed to the HomeLink®
system.
To erase the channels place the ignition in the ON/RUN
position and push and hold the two outside HomeLink®
buttons (I and III) for up 20 seconds or until the red
indicator flashes.NOTE:
•
Erasing all channels should only be performed when
programming HomeLink® for the first time. Do not
erase channels when programming additional buttons.
• If you have any problems, or require assistance, please
call toll-free 1-800-355-3515 or, on the Internet at
HomeLink.com for information or assistance.
Programming A Rolling Code
For programming garage door openers that were manu-
factured after 1995. These garage door openers can be
identified by the “LEARN” or “TRAIN” button located
where the hanging antenna is attached to the garage door
opener. It is NOT the button that is normally used to
open and close the door. The name and color of the
button may vary by manufacturer.
234 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Canadian/Gate Operator Programming
For programming transmitters in Canada/United States
that require the transmitter signals to “time-out” after
several seconds of transmission.
Canadian radio frequency laws require transmitter sig-
nals to time-out (or quit) after several seconds of trans-
mission – which may not be long enough for HomeLink®
to pick up the signal during programming. Similar to this
Canadian law, some U.S. gate operators are designed to
time-out in the same manner.
It may be helpful to unplug the device during the cycling
process to prevent possible overheating of the garage
door or gate motor.
1. Cycle the ignition to the ON/RUN position.2. Place the hand-held transmitter 1 to 3 inches (3 to
8 cm) away from the HomeLink® button you wish to
program while keeping the HomeLink® indicator
light in view.
3. Continue to push and hold the HomeLink® button, while you push and release (“cycle”) your hand-held
transmitter every two seconds until HomeLink® has
successfully accepted the frequency signal. The indi-
cator light will flash slowly and then rapidly when
fully trained.
4. Watch for the HomeLink® indicator to change flash rates. When it changes, it is programmed. It may take
up to 30 seconds or longer in rare cases. The garage
door may open and close while you are programming.
5. Push and hold the programmed HomeLink® button and observe the indicator light.
238 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

▫Compass / Temperature Display ..........318
▫ Turn Menu Off ...................... .321
▫ Customer-Programmable Features
(System Setup) ...................... .321
 Uconnect® 730N/430/430N CD/DVD/
HDD/NAV — IF EQUIPPED ..............328
▫ Operating Instructions (Voice Command
System) — If Equipped .................328
▫ Operating Instructions (Uconnect® Phone) —
If Equipped ......................... .328
 Uconnect® 130 ....................... .329
▫ Operating Instructions — Radio Mode ......329
▫ Operation Instructions — CD MODE For
CD And MP3 Audio Play ...............332
▫ Notes On Playing MP3 Files .............334▫
Operation Instructions — Auxiliary Mode . . . .337
 Uconnect® 130 WITH SATELLITE RADIO .....338
▫ Operating Instructions — Radio Mode .......338
▫ Operation Instructions — CD MODE For
CD And MP3 Audio Play ................344
▫ Notes On Playing MP3 Files .............346
▫ LIST Button — CD Mode For MP3 Play ......349
▫ INFO Button — CD Mode For MP3 Play .....350
▫ Uconnect® (Satellite Radio) — If Equipped . . .350
▫ Operating Instructions (Uconnect® Phone) —
If Equipped ......................... .355

iPod®/USB/MP3 CONTROL — IF EQUIPPED . .355
▫ Connecting The iPod® Or External USB
Device ............................ .356
282 UNDERSTANDING YOUR INSTRUMENT PANEL

▫Using This Feature .....................357
▫ Controlling The iPod® Or External USB Device
Using Radio Buttons ...................357
▫ Play Mode ......................... .357
▫ List Or Browse Mode ...................359
▫ Bluetooth® Streaming Audio (BTSA) .......361
 Uconnect® MULTIMEDIA — VIDEO
ENTERTAINMENT SYSTEM (VES™) —
IF EQUIPPED ........................ .362
▫ Getting Started ...................... .362
▫ Blu-ray™ Disc Player ...................363
▫ Play Video Games .....................364
▫ Listen To An Audio Source On Channel 2
While A Video Is Playing On Channel 1 ......367▫
Dual Video Screen .....................369
▫ Play A DVD Using The Touchscreen Radio . . .369
▫ Play A DVD Using The VES™ Player —
If Equipped ......................... .372
▫ Play A Blu-ray™ Disc Using The Blu-ray™
Player — If Equipped ..................375
▫ Listen To An Audio Source While A Video
Is Playing .......................... .376
▫ Important Notes For Dual Video Screen
System ............................ .379
▫ VES™ Remote Control — If Equipped .......380
▫ Blu-ray™ Player Remote Control —
If Equipped ......................... .383
▫ Remote Control Storage .................384
▫ Locking The Remote Control .............385
4
UNDERSTANDING YOUR INSTRUMENT PANEL 283

▫Replacing The Remote Control Batteries ......385
▫ Headphones Operation .................386
▫ Blu-ray™ Headphones Operation ..........387
▫ Controls ........................... .388
▫ Replacing The Headphone Batteries .........389
▫ Unwired® Stereo Headphone Lifetime
Limited Warranty .....................389
▫ System Information ....................390
▫ Shared Modes ....................... .390
▫ Information Mode Display ...............392
▫ Numeric Keypad Menu .................392
▫ Station List Menu .....................393
▫ Disc Menu ......................... .394▫
Display Settings ...................... .394
▫ Listening To Audio With The Screen Closed . . .395
▫ Disc Formats ........................ .395
▫ Display ............................ .401
▫ Product Agreement ....................406
 STEERING WHEEL AUDIO CONTROLS —
IF EQUIPPED ........................ .409
▫ Radio Operation ..................... .410
▫ CD Player .......................... .410
 CD/DVD/Blu-ray™ Disc MAINTENANCE . . . .411

RADIO OPERATION AND MOBILE PHONES . . .411
▫ General Information ...................412
 CLIMATE CONTROLS ...................412
284 UNDERSTANDING YOUR INSTRUMENT PANEL

INSTRUMENT PANEL FEATURES
1 — Air Vents5 — Upper Glove Compartment 9 — Storage Bin 13 — Hood Release
2 — Instrument Cluster 6 —Lower Glove Compartment10 — Cup Holders14 — Dimmer Switch
3 — Shift Lever 7 — Climate Controls11 — Switch Bank15 — Headlight Switch
4 — Radio 8 — DVD – If Equipped 12 — Ignition Switch
286 UNDERSTANDING YOUR INSTRUMENT PANEL