2015 Ram 5500 Chassis Cab wheel torque

CAUTION!
Driving with a hot cooling system could damage
your vehicle. If the temperature gauge reads HOT
(H), pull over and stop the vehicle. Idle the vehicle
with the air conditioner turned off until the pointer
drops back into the normal range. If the pointer
remains on HOT (H), and you hear continuous
chimes, turn the engine off immediately and call for
service.
WARNING!
You or others can be badly burned by hot engine
coolant (antifreeze) or steam from your radiator. If
you see or hear steam coming from under the hood,
do not open the hood until the radiator has had time
to cool. Never try to open a cooling system pressure
cap when the radiator or coolant bottle is hot.
WHEEL AND TIRE TORQUE SPECIFICATIONS
Proper lug nut/bolt torque is very important to ensure
that the wheel is properly mounted to the vehicle. Any
time a wheel has been removed and reinstalled on the
vehicle the lug nuts/bolts should be torqued using a
properly calibrated torque wrench.
Torque Specifications
Lug Nut/BoltTorque Lug Nut/
Bolt
Type **Lug
Nut/Bolt Size Lug Nut/
Bolt
Socket Size
120-150 Ft-Lbs (160-200 N·m) Cone M14 x
1.5022 mm
130-160 Ft-Lbs (190-220 N·m) Flanged
**Use only Chrysler recommended lug nuts/bolts and
clean or remove any dirt or oil before tightening.6
WHAT TO DO IN EMERGENCIES 461

After 25 miles (40 km) check the lug nut/bolt torque to be
sure that all the lug nuts/bolts are properly seated
against the wheel.
WARNING!
To avoid the risk of forcing the vehicle off the jack,
do not tighten the lug nuts fully until the vehicle has
been lowered. Failure to follow this warning may
result in personal injury.8 Lug Nuts/Bolts Torque Pattern
10 Lug Nuts/Bolts Torque Pattern
6
WHAT TO DO IN EMERGENCIES 463

(SRW) models. On dual rear wheel models (DRW) the
lug nuts are a two-piece assembly with a flat face.
Lightly tighten the nuts. To avoid risk of forcing the
vehicle off the jack, do not fully tighten the nuts until
the vehicle has been lowered.
6.
Using the wheel wrench, finish tightening the nuts
using a crisscross pattern.
For the proper lug nut torque
specifications refer to “Wheel and Tire Torque Speci-
fications” in this section. If in doubt about the correct
tightness, have them checked with a torque wrench by
your authorized dealer or at a service station.
WARNING!
A loose tire or jack thrown forward in a collision or
hard stop could injure someone in the vehicle. Al-
ways stow the jack parts and the extra tire and wheel
in the places provided. 7. Install wheel center cap (if equipped) and remove
wheel blocks. Do not install chrome or aluminum
wheel center caps on the spare wheel. This may result
in cap damage.
8. Lower the jack to its fully closed position. If the jack will not lower by turning the dial (thumbwheel) by
hand, it may be necessary to use the jack drive tube in
order to lower the jack. Stow the replaced tire, jack,
and tools as previously described.
9. Adjust the tire pressure when possible.
Hub Caps/Wheel Covers — If Equipped
The hub caps must be removed before raising the vehicle
off the ground.
6
WHAT TO DO IN EMERGENCIES 469

Replace the wheel skins first using a rubber mallet. When
replacing the hub caps, tilt the cap retainer over the lug
nut bolt circle and strike the high side down with a
rubber mallet. Be sure that the hub caps and wheel skins
are firmly seated around the wheel.
Dual Rear Wheels
Slots in the wheels will assist in properly orienting the
inner and outer wheels. Align these slots when assem-
bling the wheels for best access to the tire valve on the
inner wheel. The tires of both dual wheels must be
completely off the ground when tightening to insure
wheel centering and maximum wheel clamping.
Dual wheel models require a special heavy-duty lug nut
tightening adapter (included with the vehicle) to cor-
rectly tighten the lug nuts. Also, when it is necessary to
remove and install dual rear wheels, use a proper vehicle
lifting device.NOTE:
When installing a spare tire (if equipped) as part
of a dual rear wheel end combination, the tire diameter of
the two individual tires must be compared. If there is a
significant difference, the larger tire should be installed in
a front location. The correct direction of rotation for dual
tire installations must also be observed.
It is recommended that wheel stud nuts be kept torqued
to specifications at all times. Torque wheel stud nuts to
specifications at each lubrication interval.
• Retighten the wheel nuts in the same sequence to the
torques listed in the table. Go through the sequence a
second time to verify that specific torque has been
achieved. Retighten to specifications at 100 miles
(160 km) and after 500 miles (800 km).
6
WHAT TO DO IN EMERGENCIES 471

Aging (Life of Tires).....................404
Air Pressure .......................... .394
Chains .............................. .407
Compact Spare ........................ .401
Dual ............................... .410
General Information .....................394
High Speed .......................... .397
Inflation Pressures ...................... .395
Life of Tires .......................... .404
Load Capacity ........................ .389
Pressure Monitor System (TPMS) ............411
Pressure Warning Light ...................207
Quality Grading ....................... .575
Radial .............................. .398
Replacement .......................... .405
Rotation ............................. .409
Safety .............................. .382
Sizes ............................... .383
Snow Tires ........................... .399Spinning
............................ .403
Tread Wear Indicators ....................403
Wheel Nut Torque ..................... .469
Tire Safety Information .....................382
Tongue Weight/Trailer Weight ................436
Torque Converter Clutch ....................347
Tow Hooks, Emergency .....................479
Towing ............................... .430
Disabled Vehicle ....................... .481
Guide .............................. .436
Recreational .......................... .451
Weight .............................. .436
Towing Vehicle Behind a Motorhome ...........451
Traction ............................... .362
Traction Control ......................... .372
Trailer Sway Control (TSC) ..................381
T
railer Towing .......................... .430
Cooling System Tips .....................447
Hitches ............................. .43510
INDEX 593

Viscosity, Engine Oil...................... .495
Voice Recognition System (VR) ................306
Warning Lights (Instrument Cluster Description) . . .201
Warnings and Cautions .......................6
Warranty Information ..................... .572
Washers, Windshield ...................... .163
Washing Vehicle ......................... .529
Water Driving Through ....................... .363
Wheel and Wheel Trim .....................531
Wheel and Wheel Trim Care .................531
Wheel Cover ........................... .469
Wheel Nut Torque ........................ .469
Wind Buffeting ............................47
Window Fogging ........................ .304Windows
................................43
Power ................................43
Rear Sliding .......................... .194
Reset Auto-Up ..........................45
Wind Buffeting ..........................47
Windshield Defroster .......................110
Windshield Washers ...................... .162
Fluid ............................... .162
Windshield Wiper Blades ....................505
Windshield Wipers ....................... .162
Wiper Blade Replacement ...................505
Wipers, Intermittent ...................... .163
Wipers, Rain Sensitive ..................... .164
10
INDEX 595