2015 Ram 1500 mirror controls

Power Mirrors — If Equipped
The controls for the power mirrors are located on the
driver’s door trim panel.
The power mirror controls consist of mirror select but-
tons and a four-way mirror control switch.
To adjust a mirror, press either the L (left) or R (right)
button to select the mirror that you want to adjust.
Power Mirror Controls Location
Power Mirror Controls
1 — Mirror Select Buttons2—Four-WayMirrorControlSwitch
138 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

this function again will cause the MAX A/C operation to
switch into manual mode and the MAX A/C indicator
will turn off.
2. A/C Button
Press and release to change the current setting, the
indicator illuminates when A/C is ON. Performing this
function again will cause the A/C operation to switch
into manual mode and the A/C indicator will turn off.
3. Recirculation Button
Press and release to change the current setting, the
indicator illuminates when ON.
4. AUTO Operation Button
Automatically controls the interior cabin temperature by
adjusting airflow distribution and amount. Performing
this function will cause the ATC to switch between
manual mode and automatic modes. Refer to “Automatic
Operation” for more information.
5. Front Defrost Button
Press and release to change the current airflow setting to
Defrost mode. The indicator illuminates when this fea-
ture is ON. Air comes from the windshield and side
window demist outlets. When the defrost button is
selected, the blower level will increase. Use Defrost mode
with maximum temperature settings for best windshield
and side window defrosting and defogging. Performing
this function will cause the ATC to switch into manual
mode. If the front defrost mode is turned off the climate
system will return the previous setting.
6. Defrost Button
Press and release this button to turn on the rear window
defroster (if equipped) and the heated outside mirrors (if
equipped). An indicator will illuminate when the rear
window defroster is on. The rear window defroster
automatically turns off after 10 minutes.
412 UNDERSTANDING YOUR INSTRUMENT PANEL

STARTING PROCEDURES
Before starting your vehicle, adjust your seat, adjust both
inside and outside mirrors, and fasten your seat belt.
The starter should not be operated for more than 10-
second intervals. Waiting a few seconds between such
intervals will protect the starter from overheating.
WARNING!
Never leave children alone in a vehicle, or with
access to an unlocked vehicle. Leaving children in a
vehicle unattended is dangerous for a number of
reasons. A child or others could be seriously or
fatally injured. Children should be warned not to
touch the parking brake, brake pedal or the shift
lever/transmission gear selector. Do not leave the Key
Fob in or near the vehicle, or in a location accessible
(Continued)
WARNING!(Continued)
to children, and do not leave the ignition of a vehicle
equipped with keyless Enter-N-Go in the ACC or
ON/RUN mode. A child could operate power win-
dows, other controls, or move the vehicle.
Normal Starting
Normal starting of either a warm or cold engine is
obtained without pumping or pressing the accelerator
pedal. Cycle the ignition to the START position and
release when the engine starts. If the engine fails to start
within 10 seconds, cycle the ignition to the OFF position,
wait five seconds, then repeat the “Normal Starting”
procedure.
448 STARTING AND OPERATING

Illuminated Entry..........................23
Immobilizer (Sentry Key)....................18
Inflation Pressure Tires.....................620
Information Center, Vehicle..................302
Inside Rearview Mirror.....................126
Instrument Cluster........................289
Instrument Panel and Controls................286
Instrument Panel Lens Cleaning...............795
Integrated Trailer Brake Controls..............661
Interior Appearance Care....................793
Interior Lights...........................172
Intermittent Wipers (Delay Wipers).............179
Introduction..............................4
Inverter Outlet (115V)......................233
Jack Location............................688
Jump Starting............................729
Key Fob
Programming Additional Key Fobs...........20
Programming Additional Transmitters.........20
Key-In Reminder..........................18
Keyless Enter-N-Go........................42
Keyless Enter-N-Go™
Keyless Enter-N-Go™.....................42
Lock The Vehicle’s Doors..................364
Passive Entry...........................42
Passive Entry Programming.................42
Keyless Entry System.......................24
Key, Replacement..........................19
Keys...................................12
Key, Sentry (Immobilizer)....................18
Lane Change and Turn Signals................176
Lane Change Assist........................177
Lap/Shoulder Belts.........................53
Latches................................118
856 INDEX