Page 62 of 292

60
RCZ_en_Chap03_confort_ed01-2015
In order for these systems to be fully effective, follow the operation
and maintenance guidelines below:
F
T
o obtain an even air distribution, take care not to obstruct
the exterior air intake grilles located at the base of the
windscreen, the nozzles, the vents and the air outlets, as well
as the air extractor located in the boot.
F
Do not cover the sunshine sensor
, located on the dashboard;
this is used for regulation of the air conditioning system.
F
Operate the air conditioning system for at least 5 to
10
minutes, once or twice a month to keep it in good working
order.
F Ensure
that the passenger compartment filter is in good
condition
and have the filter elements replaced regularly
(refer to the "Checks" section).
W
e recommend the use of a combined passenger
compartment
filter.
Thanks
to its special active additive,
it
contributes to the purification of the air breathed by the
occupants and the cleanliness of the passenger compartment
(reduction of allergic symptoms, bad odours and greasy
deposits).
F
T
o ensure correct operation of the air conditioning system,
you are also advised to refer to the warranty and maintenance
record for information on when it should be checked.
F
If the system does not produce cold air
, switch it off and
contact
a PEUGEOT
dealer or a qualified workshop.
When towing the maximum load on a steep gradient in high
temperatures, switching off the air conditioning increases the
available engine power and so improves towing performance. The condensation created by the air conditioning results in a
discharge of water under the vehicle which is perfectly normal. If after an extended stop in sunshine, the interior temperature is
very
high, first ventilate the cabin for a few moments.
Put
the air flow control at a setting high enough to quickly change
the air in the cabin.
The air conditioning system does not contain chlorine and does
not present any danger to the ozone layer
.
RECOMMENDATIONS FOR VENTILATION AND AIR CONDITIONING
Page 67 of 292

65
RCZ_en_Chap03_confort_ed01-2015
INTERIOR MOOD LIGHTING
The dimmed passenger compartment lighting improves visibility in the
vehicle when the light is poor.
SWITCHING ON
At night, the footwell lighting and the front courtesy mood lamp come on\
automatically when the sidelamps are switched on.
SWITCHING OFF
The interior mood lighting switches off automatically when the
sidelamps are switched off.
PROGRAMMING
The function is activated or deactivated via the vehicle
configuration menu.
This function is activated by default.
INTERIOR WELCOME LIGHTING
The remote switching on of the passenger compartment lighting
makes your entry into the vehicle easier in poor light. It is activated \
in
accordance with the light intensity detected by the brightness sensor.
SWITCHING ON
F Press the open padlock on the remote control.
The front door sill lighting, the footwell lighting and the courtesy lam\
ps
come on; your vehicle is also unlocked.
SWITCHING OFF
The interior welcome lighting switches off automatically after a certain
time, when one of the doors is opened or the ignition is switched on.
3/
EASE OF USE and COMFORT
Page 68 of 292
66
RCZ_en_Chap03_confort_ed01-2015
ExTERIOR WELCOME
LIGHTING
The remote switching on of the lighting makes your approach to the
vehicle easier in poor light. It is activated according to the level of \
light
detected by the sunshine sensor.
SWITCHING ON
F Press the open padlock on the remote control.
The dipped beam headlamps and the sidelamps come on; your
vehicle is also unlocked.
The duration of the welcome lighting is associated with and
identical to that of the automatic guide-me-home lighting.
SWITCHING OFF
The exterior welcome lighting switches off automatically after a set time,
when the ignition is switched on or on locking the vehicle.
Page 79 of 292

77
RCZ_en_Chap04_visibilite_ed01-2015
C. Foglamp selection ring.
The foglamp operates with the dipped and main beam headlamps.
Rear foglamp.
F
T
urn the ring C forwards and release to switch on the rear foglamp.
When the lighting is switched off automatically (with AUTO model)
or when the dipped beam headlamps are switched off manually, the
foglamp and the sidelamps will remain on.
F
T
urn the ring C rearwards and release to switch off all the lamps. In good or rainy weather, both day and night, use of the rear
foglamp is prohibited. In these situations, the power of its beam
may dazzle other drivers. It should only be used in fog or snow.
In these weather conditions, it is your responsibility to switch
on the foglamp and dipped beam headlamps manually as the
sunshine
sensor may detect sufficient light.
Do not forget to switch off the rear foglamp when it is no longer
needed.
Switching off the lamps when the ignition is switched off
On switching off the ignition, all of the lamps turn off immediately,
except for dipped beam if guide-me-home lighting is activated.
Switching on the lamps after the ignition is switched off
To reactivate the lighting control, rotate ring A to the "0" position -
lamps off, then to the desired position.
On opening the driver's door a temporary audible signal warns the
driver that the lighting is on.
The lamps, with the exception of the sidelamps, switch off
automatically after a maximum duration of thirty minutes to
prevent discharging of the battery.
4/
VISIBILITY
Page 81 of 292

79
RCZ_en_Chap04_visibilite_ed01-2015
AUTOMATIC ILLUMINATION OF HEA d LAMPS
When a low level of ambient light is detected by a sunshine sensor, the
number plate lamps,
sidelamps and dipped beam headlamps are switched
on automatically, without any action on the part of the driver. They can also
come on if rain is detected, at the same time as automatic operation of \
the
windscreen wipers.
As
soon as the brightness returns to a sufficient level or after the windscreen
wipers are switched of
f, the lamps are switched off automatically.
Activation
F Turn the ring to the "AUTO" position. The activation of the function is accompanied by the display of a message in the screen.
deactivation
F Turn the ring to another position. Deactivation of the function is accompanied by the display of a message in the screen.
MANUAL GUI d E - ME - HOME LIGHTING
The temporary illumination of the dipped beam headlamps after the
vehicle's ignition has been switched off makes the driver's exit easier
when the light is poor.
Switching on
F With the ignition off, "flash" the headlamps using the lighting stalk.
F A
further "headlamp flash" switches the function off.
Switching off
The manual guide-me-home lighting switches off automatically after a
set time.
4/
VISIBILITY
Page 82 of 292

80
RCZ_en_Chap04_visibilite_ed01-2015
AUTOMATIC GUId E - ME - HOME
LIGHTING
Operating fault
In the event of a malfunction of the sunshine sensor, the
lighting comes on, this warning lamp is displayed in the
instrument panel and/or a message appears in the screen,
accompanied by an audible signal.
Contact
a
PEUGEOT
dealer or a qualified workshop.
In
fog
or snow, the sunshine sensor may detect sufficient light. In
this case, the lighting will not come on automatically
.
Do not cover the sunshine sensor, coupled with the rain sensor
and located in the centre of the windscreen behind the rear view
mirror; the associated functions would no longer be controlled. When the automatic illumination of headlamps function is activated
(lighting control stalk in the "
AUTO" position), under low ambient light
the dipped beams headlamps come on automatically when the ignition
is switched off.
Programming
Activation or deactivation, as well as the duration of the guide-me-home\
lighting, is set in the vehicle configuration menu.
Page 87 of 292

85
RCZ_en_Chap04_visibilite_ed01-2015
AUTOMATIC RAIN SENSITIVE WIN d SCREEN
WIPERS
The windscreen wipers operate automatically, without any action on the
part of the driver, if rain is detected (sensor behind the rear view mirror),
adapting their speed to the intensity of the rainfall.
Activation
This is controlled manually by the driver by pushing the stalk
downwards to the "AUTO" position.
It is accompanied by a message in the screen.
Switching off
This is controlled manually by the driver by moving the stalk upwards
then returning it to position "0".
It is accompanied by a message in the screen.
Operating fault
If an automatic wiping malfunction occurs, the wipers will operate in
intermittent mode.
Have
it checked by a PEUGEOT
dealer or a qualified workshop.
The automatic rain sensitive wipers must be reactivated if the
ignition has been off for more than one minute, by pushing the
stalk downwards.
Do not cover the rain sensor, linked with the sunshine sensor
and located in the centre of the windscreen behind the rear view
mirror.
Switch off the automatic rain sensitive wipers when using an
automatic car wash.
In winter, to avoid damaging the wiper blades, it is advisable
to wait until the windscreen is completely clear of ice before
activating the automatic rain sensitive wipers.
4/
VISIBILITY
Page 129 of 292

127
RCZ_en_Chap06_conduite_ed01-2015
TYRE UNDER-INFLATION DETECTION
A pressure sensor is located in the valve of each of these tyres.
The system triggers an alert if a drop in pressure is detected in one or\
more tyres.This system does not avoid the need to check the tyre pressures
regularly and before a long journey.
Driving
with under-inflated tyres adversely affects road holding,
extends braking distances and causes premature tyre wear
,
particularly under arduous conditions (vehicle loaded, high speed,
long journey).
System which automatically checks the pressures of the tyres while
driving.
The system continuously monitors the pressures of the four tyres, as
soon as the vehicle is moving.
Driving with under-inflated tyres increases fuel consumption.
The tyre pressures for your vehicle can be found on the tyre
pressure label (see the "Identification markings" section).
The tyre pressures must be checked when the tyres cold (vehicle
stopped for 1 hour or after driving for less then 6 miles (10 km) at
moderate speed). Otherwise, add 0.3 bar to the values indicated
on the label.
Spare wheel
Don't forget to also check the tyre pressure of the spare wheel.
The alloy spare wheel also has a sensor.
The steel spare wheel does not have a sensor.
The
tyre
under-inflation
detection
system
is
an
aid
to
driving
which
does not replace the need for vigilance on the part of the driver
.
6/
DRIVING