2015 Peugeot Partner Tepee roof

26
Partner_2_VP_en_Chap03_Pret-a-partir_ed02-2014
REAR ROOF FLAPSupport bar
A support bar is provided for
transporting long loads, after opening
the rear roof flap.
Fold back the support bar by lifting the
lever.
g
uide it to the door pillar.
Support the long loads to be
transported, lift them and reposition the
support bar with one hand.
e

nsure that it is secured correctly by
pressing the handle downwards past
the point of resistance and secure the
loads firmly.
t
he rear bumper has been
reinforced to serve as a footrest
when entering the vehicle.
t

he rear doors only lock when the
support bar is installed.
When the rear roof flap is open, take
care when driving where height is
restricted.
Never rest loads directly on the rear
doors.
Comply with the usual indications, to
warn other drivers.
Reserve the use of the rear roof flap
for short journeys.
t
he side supports can be used as
hooking points.
-
lower the black paddle to secure
the rear roof flap.
Securing the rear roof flap places it on
the seal correctly and ensures sealing
without noise.
This rear roof flap is only compatible
with side-hinged rear doors.
T

o open the rear roof flap:
-

raise the black paddle of the toggle,
-


relieve the toggle by pressing the
rear roof flap (downwards) then
release the hook,
-

lift the rear roof flap,
-

pass the point of resistance to
secure the rear roof flap using the
support stays.
Never drive without the stays in place.
T

o close the rear roof flap:
-

check that the support bar is
secured correctly

,
-

lower the rear roof flap,
-


while pressing the rear roof flap
(downwards), take hold of the two
loops of the spring then place the
hook in its housing, Never attach any load to the rear roof
flap.
Never drive without the support bar in
place.
Access

90
Partner_2_VP_en_Chap04_ergonomie_ed02-2014
ZENITH ROOF
the multifunction roof extends the
overhead storage unit. It consists of
the following components:
Storage compartments
Storage compartments are provided
on each side of the roof. t he maximum
authorised load is 6 kg.
t

he translucent base assists with
finding objects stored inside.
Do not store objects which could
present a risk to the occupants.
Courtesy lamp
the operation of the courtesy lamp is
identical to that of the front courtesy lamp.
Refer to chapter 4 "Comfort and
Safety", "Courtesy lamps" section.
Practical information

91
Partner_2_VP_en_Chap04_ergonomie_ed02-2014
From insideFrom outside
Rear box
this roof box can be accessed from
the rear seats and the boot.
From the rear seats, slide the flaps
to
open.
Vents
A 3-position control allows you to
adjust the air flow through the vents.
The vents are also fitted with a scented
air freshener.From the boot, place your thumb on the
recess then pull the handle to open.
Open carefully to prevent objects
stored in this interior roof box from
falling out.
t

he maximum authorised load is 10 kg.
Practical information
eASe OF uSe and COMFORt
4

92
Partner_2_VP_en_Chap04_ergonomie_ed02-2014
SCENTED AIR FRESHENER
the scented air freshener diffuses
a fragrance in the passenger
compartment from the roof console
vents.
Adjusting the flow
turn the chromed button to adjust the
dif fusion:
-

to the left to decrease,
-


to the right to increase.
to stop the dif

fusion, turn the chromed
button fully to the left.
Removing the scented air
freshener
- Press the button down while turning
it a quarter of a turn to the left to
the stop.
-

Remove the scented air freshener
from the roof console.
-


Replace the cartridge.
Practical information

93
Partner_2_VP_en_Chap04_ergonomie_ed02-2014
Replacing a cartridge
The scented air freshener refill consists
of a cartridge B and its sealing case C.
-
Remove the protective film
D.
-

Place the head of the cartridge
B
on the button A of the scented air
freshener.
-
t
urn it a quarter of a turn to lock it
on the button and remove the case.
-


Insert the scented air freshener in
its location.
Y

ou can change the cartridges at any
time and store cartridges which have
already been started in their original
case.
t

he scented air freshener button A is
independent of the cartridge.
t

he cartridges are supplied without the
button A.
Inserting the scented air
freshener
After fitting or changing the cartridge:
-

Put the scented air freshener back
in place in its location.
-

t
urn it a quarter of a turn to the
right.
Good practice
As a safety precaution, only use the
cartridges provided for this purpose.
Do not dismantle the cartridges.
Keep the cartridge sealing cases
which are used as packaging when the
cartridges are not in use.
Never try to refill the cartridges
with fragrances other than those
recommended by the P
euge O t

network.
Keep out of reach of children and
animals.

Avoid contact with the skin
and eyes. If swallowed, consult a
doctor and show him the packaging or
product label.t
he scented air freshener button A can
only be fixed on the multifunction roof
console with a cartridge.
t

herefore, always retain button A and
a cartridge.
t

he cartridges are available from
P
euge
O
t
dealers.
Practical information
eASe OF uSe and COMFORt
4

94
Partner_2_VP_en_Chap04_ergonomie_ed02-2014
ZENITH ROOF BARS
the maximum authorised weight on
each roof bar is 35 kg. In all cases, the load must rest on
the non-slip bands provided for this
purpose and must not touch the roof or
the glazing of the roof.
Recommendations for loading the
roof
t
his procedure requires the use of
a spanner supplied with the tools for
changing a wheel.
t
hese two longitudinal Zenith roof bars
can be removed.
Chapter 9, "Changing a wheel"
section.
-

Open the protective covers.
-


Slacken the four screws using the
spanner and remove them.
-

t
urn the bars 90° placing the
hollow parts towards the front.
-


Refit the the 4 screws and tighten
them using the spanner

.
-

Close the protective covers.
-

u se the strap passages A only to
secure the load firmly.
Practical information

95
Partner_2_VP_en_Chap04_ergonomie_ed02-2014
ROOF BARS
If you install transverse bars on these bars, refer to the weight values\
indicated
by the manufacturer but do not exceed 75 Kg.
Practical information
eASe OF uSe and COMFORt
4

100
Partner_2_VP_en_Chap04_ergonomie_ed02-2014
Storage flaps
Raise the corresponding flap.Next to the boot sill, the recess is
intended to receive the roller tube
containing the load space cover.
Seat belts
ensure that the centre seat belt has
reeled in correctly to its strengthener
on the roof.
Prevent the row 3 seat belt buckles
from knocking by raising them as

close as possible to the anchorages in
the roof.
t

he seat belt buckle attachment rings
on each side of the boot must not be
used to retain loads.
Practical information