2
208_en_Chap00a_sommaire_ed01-2016
Unlocking - Key 35
Doors 35
3 -door
3
6
Locking - Key
3
7
Alarm
4
1
Boot
43
Window controls
4
6
Access
Instruments
PEUGEOT i- Cockpit 4
8
Front seats 4 9
One-piece rear seats
5
3
Ventilation
56
Heating
5
9
Air conditioning
6
1
Dual-zone digital air conditioning
6
3
Demisting - defrosting
6
6
Courtesy lamp
6
8
Mood lighting
6
9
Sunroof blind
7
0
Interior fittings
7
1
Ports and sockets - Connectivity
7
2
Boot fittings
7
3
Rear parcel shelf
7
4
Ease of use and comfort
Mirrors 75
Lighting 77
Automatic illumination of headlamps
7
9
Daytime running lamps
8
3
Direction indicators
8
4
Headlamp adjustment
8
5
Cornering lighting
8
6
Wipers
87
Lighting and visibility
Hazard warning lamps 9 0
Road holding 9 0
Seat belts
9
3
Airbags
96
Carrying children
1
00
Deactivating the passenger's front airbag
1
02
ISOFIX child seats
1
09
Child lock
1
14
Safety
Eco-driving 115
Driving recommendations 1 17
Starting
118
Switching off
1
20
Parking brake
1
21
Manual gearbox
1
22
Electronic gearbox
1
23
Automatic gearbox
1
26
Gear shift indicator
1
29
Hill start assist
1
30
Stop & Start
1
31
Speed limiter
1
34
Cruise control
1
36
Active City Brake
1
41
Parking sensors
1
44
Reversing camera
1
46
Park Assist
1
47
Under-inflation detection
1
51
DrivingInstrument panels 1 1
Library of indicator and warning lamps 1 4
Engine coolant temperature
2
5
Touch screen
2
9
Trip computer
3
0
Date and time
3
3
Lighting dimmer
3
4
Over view
Exterior view 4
I nterior view 5
I
nstruments and controls
6
M
iddle console
8
Upp
er console
9
L
ower console
9
U
nderbonnet view
1
0
Contents
14
208_en_Chap01_instruments-bord_ed01-2016
Library of indicator and warning lamps
When the ignition is switched on
Certain warning lamps come on for a few
seconds in the instrument panel and/or
instrument panel screen when the vehicle's
ignition is switched on.
When the engine is started, these same
warning lamps should go off.
If they remain on, before moving off, refer to the
information in the table on the warning lamp
concerned.
Associated warnings
The illumination of certain warning lamps
may be accompanied by an audible signal
and a message in the instrument panel or
multifunction screen.
The warning lamps may come on continuously
(fixed) or flash.
Certain warning lamps may come on in one of
two modes. Only by relating the type of lighting
to the operating status of the vehicle can it be
ascertained whether the situation is normal or
whether a fault has occurred.
Indicator and warning
lamps
● indicator lamp informing that a system is switched on,
●
w
arning lamp for preventive purposes or for
a fault.
Instruments
16
208_en_Chap01_instruments-bord_ed01-2016
Warning / indicator lamp State Cause Action / Observations
Foot on the
clutch fixed.
In the STOP mode of Stop & Start,
changing to START mode is refused
because the clutch pedal is not fully
down. You must declutch fully to allow the change to engine
S TA R T m o d e .
Stop & Star t fixed. When the vehicle stops (red lights,
traffic jams, ...) the Stop & Start system
has put the engine into STOP mode. The warning lamp goes off and the engine restarts
automatically in START mode, as soon as you want to
move off.
flashes for a few
seconds, then goes
of f. STOP mode is temporarily
unavailable.
Or
START mode is invoked
automatically. For more information on Stop & Start, refer to the
corresponding section.
Automatic
wiping fixed.
The wiper control is pushed
downwards. Automatic front wiping is activated.
To deactivate automatic wiping, operate the control
stalk downwards or put the stalk into another position.
Passenger's
airbag system fixed.
The control, located in the glove box,
is set to the OFF position.
The passenger's front airbag is
deactivated.
You can install a rear ward facing
child seat, unless there is a fault with
the operation of the airbags (Airbag
warning lamp on). Set the control to the ON
position to activate the
passenger's front airbag.
In this case, do not fit a child seat in the rear ward
facing position.
Instruments
24
208_en_Chap01_instruments-bord_ed01-2016
Warning / indicator lamp State Cause Action / Observations
Left-hand
direction
indicato r Flashing with audible
signal.
The lighting stalk has been pushed
down. When changing lane.
Right-hand
direction
indicator Flashing with audible
signal.
The lighting stalk has been pushed
up.
Sidelamps fixed. The lighting control stalk is in the
"Sidelamps" position. On manual operation of the lighting or in automatic
mode.
Dipped beam
headlamps fixed.
The lighting control stalk is at the
"Dipped beam" position.
Main beam
headlamps fixed.
The lighting control stalk has been
pulled toward you. Pull the control stalk again to return to dipped beam.
Front foglamps fixed. The front foglamps are switched on
using the ring on the lighting control
stalk. Turn the ring on the lighting control stalk rear ward
once to switch off the front foglamps.
Rear
foglamp fixed.
The rear foglamp has been switched
on using the ring on the lighting
control stalk. Turn the ring on the lighting control stalk to the rear to
switch off the rear foglamp.
Instruments
Access
44
208_en_Chap02_ouvertures_ed01-2016
Changing the battery
Battery ref.: CR1620 / 3 volts. If the battery is flat, you are informed
by lighting of this warning lamp in the
instrument panel, an audible signal
and a message in the screen.
F
U
nclip the cover using a screwdriver in the
cutout.
F
R
emove the cover.
F
E
xtract the flat battery from its location.
F
P
lace the new battery into its location
observing the original direction.
F
C
lip the cover in place.
Do not throw the remote control
batteries away, they contain metals
which are harmful to the environment.
Take them to an approved collection
point.
Remote control problem
Reinitialisation
F Switch off the ignition.
F
T urn the key to position 2 (Ignition) .
F
P
ress the closed padlock immediately for a
few seconds.
F
S
witch off the ignition and remove the key
from the ignition switch.
The remote control is fully operational again.
Following disconnection of the vehicle battery,
replacement of the remote control battery or
in the event of a remote control malfunction,
you can no longer unlock, lock or locate your
vehicle.
F
F
irst of all, use the key in the lock to unlock
or lock your vehicle.
F
T
hen, reinitialise the remote control.
If the problem persists, contact a PEUGEOT
dealer as soon as possible.
79
The sidelamps and dipped beam headlamps are
switched on automatically, without any action
on the part of the driver, when a low level of
ambient light is detected or in certain cases of
activation of the windscreen wipers.
As soon as the brightness returns to a sufficient
level or after the windscreen wipers are switched
off, the lamps are switched off automatically.
AUTO mode
On
F Turn the ring to the "AUTO" position.
Activation of the function is accompanied
by a message in the screen.
Off
F Turn the ring to another position. Deactivation of the function is
accompanied by a message in the screen.
Automatic guide-me-home
lighting
Association with the automatic lighting provides
the guide-me-home lighting with the following
additional options:
-
s
election of the lighting duration of 15, 30
or 60 seconds,
-
a
utomatic activation of guide-me-home
lighting when the automatic illumination of
headlamps is in operation. In the event of a fault with the
sunshine sensor, the lighting comes
In fog or snow, the sunshine sensor
may detect sufficient light. In this
case, the lighting will not come on
automatically.
Do not cover the sunshine sensor,
coupled with the rain sensor and
located in the centre of the windscreen
behind the rear view mirror; the
associated functions would no longer
be controlled.
Configuration
Press "MENU" to display the "MAIN
MENU" .
Select "Driving" .
Select "Secondary page" .
Select the "Driving assistance" tab.
Activate the "Guide me home"
function. Select "Vehicle settings" .Switching off
Switching on Deactivate the "Guide me home"
function.
on, this warning lamp is displayed in the
instrument panel and/or a message appears in
the screen, accompanied by an audible signal.
Contact a PEUGEOT dealer or a qualified
workshop.
4
Lighting and visibility
80
Temporarily keeping the dipped beam
headlamps on after the vehicle's ignition has
been switched off makes the driver's exit easier
when the light is poor.
Manual guide-me-home
lighting
On
F With the ignition off, "flash" the headlamps using the lighting stalk.
F
A f
urther "headlamp flash" switches the
function off.
Off
The manual guide-me-home lighting switches
off automatically after a set time.
Parking lamps
Side markers for the vehicle by illumination of
the sidelamps on the traffic side only.
F
W
ithin one minute of switching off the
ignition, operate the lighting control stalk
up or down depending on the traffic side
(for example: when parking on the left;
lighting control stalk upwards; the right
hand sidelamps are on).
Manual guide-me-home lighting
is also available from the remote
control lighting button (refer to the
corresponding section). This is confirmed by an audible signal and
illumination of the corresponding direction
indicator warning lamp in the instrument panel.
To switch off the parking lamps, return the
lighting control stalk to the middle position or
switch on the ignition.
Lighting and visibility
87
Wipers
Manual mode
The wipers are controlled directly by the driver.
Front
Wipe
Fast (heavy rain).
Normal (moderate rain).
Intermittent (proportional to the
speed of the vehicle).
Park.
Single wipe (press down and
release).
Switching on
Briefly push the control stalk downwards.
A wiping cycle confirms that the instruction has
been accepted.This warning lamp comes on in the
instrument panel and a message is
displayed. This warning lamp goes off in the
instrument panel and a message is
displayed.
Switching off
Briefly push the control stalk downwards again,
or place the control stalk in another position
(Int, 1 or 2).
AUTO mode
The windscreen wipers operate
automatically, without any action
on the part of the driver, when rain
is detected (sensor behind the rear
view mirror), adapting their speed to
the intensity of the rainfall.
4
Lighting and visibility