2015 MITSUBISHI L200 ignition

Switch position 3-Driver + Full luggageloading
{Vehicles with heavy duty suspension}Switch position 4-Driver + Full luggageloading
{Vehicles without heavy
duty suspension}
Double cab
Vehicle con- ditionSwitch posi- tion“0”“2” or “3” or “4”●:1 person:Full luggage loadingSwitch position 0-Driver onlySwitch position 2-Driver + Full luggageloading
{Vehicles with heavy duty suspension for Rus-sia, Kazakhstan and Uk-
raine}Switch position 3-Driver + Full luggage loading
{Vehicles with heavy duty suspension except
for Russia, Kazakhstan
and Ukraine}
{Vehicles with head- lamp - type 2* and with-
out heavy duty suspen- sion}Switch position 4-Driver + Full luggageloading
{Vehicles with head-
lamp - type 1* and with- out heavy duty suspen-
sion}
*: Refer to “Outside” on page 10-25
Turn-signals lever
E00506501273
The turn-signal lamps flash when the lever is
operated (with the ignition switch in the “ON” position). At the same time, the turn-
signal indication lamps flash.
1- Turn-signals When making a normal turn, use posi-
tion (1). The lever will return automati- cally when cornering is completed.
There are times when the lever will not
return after cornering. This occurs when the steering wheel is turned only slight-
ly.
In such cases, return the lever by hand.
2- Lane-change signals When changing lanes, use position (2). It
will return to the neutral position when released.
Turn-signals lever
5-36OKTE15E3Instruments and controls5

NOTElThe front fog lamps are automatically turned
off when the headlamps or tail lamps are turned off. To turn the front fog lamps on again, turn the knob in the “ON” directionafter turning on the headlamps or tail lamps.
l Do not use fog lamps except in conditions of
fog, otherwise excessive lamp glare maytemporarily blind oncoming vehicle drivers.
l In case of vehicles with Daytime Running
Lamp, the front fog lamp can be operated even if the lamp switch is set to the “OFF”
position, because the low beam of the head- lamps, tail lamps, etc. illuminate when the
ignition key is at the “ON” position.Rear fog lamp switch
E00506900313
The rear fog lamp illuminates only when theheadlamps or front fog lamps (if so equipped)
are on.
An indication lamp in the instrument cluster
comes on when the rear fog lamp is turned on.

[Vehicles without front fog lamps]
Turn the knob once in the “ON” direction to
turn on the rear fog lamp. To turn the rear fog
lamp off, turn the knob once in the “OFF” di- rection. The knob will automatically return to
its original position when you release it.

[Vehicles with front fog lamps]
Turn the knob once in the “ON” direction to turn on the front fog lamps. Turn the knob
once more in the “ON” direction to turn on the rear fog lamp. To turn the rear fog lamp
off, turn the knob once in the “OFF” direc- tion. Turn the knob once more in the “OFF” direction to turn off the front fog lamps. The
knob will automatically return to its original
position when you release it.NOTEl The rear fog lamp is automatically turned off
when the headlamps and front fog lamps (if
so equipped) turned off.
l To turn the rear fog lamp on again, turn the
knob once in the “ON” direction after turn-ing on the headlamps. (Vehicles without
front fog lamps)NOTEl To turn the rear fog lamp on again, turn the
knob twice in the “ON” direction after turn-ing on the headlamps. (Vehicles with front
fog lamps)
l In case of vehicles with Daytime Running
Lamp, the rear fog lamp can be operated
even if the lamp switch is set to the “OFF”
position, because the low beam of the head- lamps, tail lamps, etc. illuminate when the ignition key is at the “ON” position.Wiper and washer switch
E00507101191CAUTIONlIf the washer is used in cold weather, the
washer fluid sprayed against the glass may
freeze, which may hinder visibility. Warm the glass with the defroster or rear window
demister before using the washer.Windscreen wipers
E00516900303
Except for vehicles equipped
with rain sensor
The windscreen wipers can be operated with the ignition switch in the “ON” or “ACC”
position.
Rear fog lamp switch
5-38OKTE15E3Instruments and controls5

If the blades are frozen to the windscreen, do
not operate the wipers until the ice has mel- ted and the blades are freed, otherwise thewiper motor may be damaged.MIST
-Misting function
The wipers will operate once.OFF-OffINT-Speed sensitive intermittent opera- tion
Interval between wipers varies in ac-
cordance with vehicle speed.LO-SlowHI-FastTo adjust intermittent intervals
With the lever in the “INT” (speed-sensitive) position, the intermittent intervals can be ad-justed by turning the knob (A).
1- Fast
2- Slow
NOTEl The speed-sensitive-operation function of
the windscreen wipers can be deactivated.
For further information, we recommend you to consult a MITSUBISHI MOTORS Au-
thorized Service Point.
Misting function
Move the lever in the direction of the arrow
and release, to operate the wipers once.
Use this function when you are driving in
mist or drizzle.
If the lever is held in the upward position
(MIST), the wipers continue operating until the lever is released.Vehicles with rain sensor
E00526400369
The windscreen wipers can be operated withthe ignition switch in the “ON” or “ACC”
position.
Wiper and washer switch
5-39OKTE15E3Instruments and controls5

If the blades are frozen to the windscreen, do
not operate the wipers until the ice has mel- ted and the blades are freed, otherwise thewiper motor may be damaged.MIST-Misting function
The wipers will operate once.OFF-OffAUTO-Auto-wiper control
Rain sensor
The wipers will automatically op- erate depending on the degree of
wetness on the windscreen.LO-SlowHI-Fast
Rain sensor
Can only be used when the ignition switch is in the “ON” position.
If the lever is put in the “AUTO” position,
the rain sensor (A) will detect the extent of rain (or snow, other moisture, dust, etc.) and the wipers will operate automatically.
Keep the lever in the “OFF” position if the
windscreen is dirty and the weather is dry.
Wiper operation under these conditions can scratch the windscreen and damage the wip-
ers.CAUTIONl With the ignition switch in the “ON” posi-
tion and the lever in the “AUTO” position,the wipers may automatically operate in the situations described below.
If your hands get trapped, you could suffer injuries or the wipers could malfunction. Be sure to turn the ignition switch to the “OFF”
position or move the lever to the “OFF” po-
sition to deactivate the rain sensor.
• When cleaning the outside surface of the
windscreen, if you touch the rain sensor.
• When cleaning the outside surface of the
windscreen, if you wipe with a cloth the
rain sensor.
• When using an automatic car wash.
• A physical shock is applied to the wind-
screen.
• A physical shock is applied to the rain
sensor.NOTEl To protect the rubber parts of the wipers,
this operation of the wipers does not take
place when the vehicle is stationary and the
ambient temperature is about 0 °C or lower.
l Do not cover the sensor by affixing a sticker
or label to the windscreen. Also, do not put
any water-repellent coating on the wind- screen. The rain sensor would not be able to
detect the extent of rain, and the wipers might stop working normally.
Wiper and washer switch
5-40OKTE15E3Instruments and controls5

The wipers will operate once if the lever ismoved to the “AUTO” position and the knob
(A) is turned in the “+” direction when the ig-
nition switch is “ON” position.Windscreen washer
E00507200805
The windscreen washer can be operated with the ignition switch in the “ON” or “ACC”
position.
The washer fluid will be sprayed onto the windscreen by pulling the lever towards you.The wipers operate automatically several
times while the washer fluid is being sprayed.
On a vehicle equipped with a headlamp
washer, the headlamp washer operates to-
gether with the windscreen washer the first time the windscreen washer is used if the headlamps are on.CAUTIONl If the washer is used in cold weather, the
washer fluid sprayed against the glass may
freeze resulting in poor visibility. Heat the
glass with the defroster or demister before using the washer.NOTEl It is possible to spray washer fluid without
activating the wipers. To do so, hold the lev- er in the pulled position and turn the ignition
switch to the “ON” or “ACC” position.NOTEl It is possible to cause the wipers never to op-
erate when washer fluid is sprayed. For fur-
ther information, we recommend you to con- sult a MITSUBISHI MOTORS Authorized
Service Point.Headlamp washer switch*
E00510100273
The headlamp washer can be operated when
the ignition switch is in the “ON” or “ACC” position and the headlamps are on.

Push the button once and the washer fluid will be sprayed on to the headlamps.
Wiper and washer switch
5-42OKTE15E3Instruments and controls5

NOTElIf the ignition switch is in the “ON” or
“ACC” position and the headlamps are on,
the headlamp washer operates together with the windscreen washer the first time thewindscreen washer lever is pulled.Precautions to observe when
using wipers and washers
E00507600014
l If the moving wipers become blocked by
ice or other deposits on the glass, the
motor may burn out even if the wiper switch is turned to OFF. If obstruction
occurs, park your vehicle in a safe place, turn off the ignition, and clean the de- posits from the glass so that the wipersoperate smoothly.
l Do not use the wipers when the glass is
dry.
They may scratch the glass surface and
the blades wear out prematurely.
l Before using the wipers in cold weather,
check that the wiper blades are not fro-
zen onto the glass. The motor may burn out if the wipers are used with the blades
frozen onto the glass.
l Avoid using the washer continuously for
more than 20 seconds. Do not operate the washer when the fluid reservoir isempty.
Otherwise, the motor may burn out.
l Periodically check the level of washer
fluid in the reservoir and refill if re- quired.
During cold weather, add a recommen- ded washer solution that will not freeze
in the washer reservoir. Failure to do so
could result in loss of washer function and frost damage to the system compo- nents.Rear window demister
switch E00507900961
The rear window demister switch can be op-erated with the ignition switch in the “ON”position.
Push the switch to turn on the rear window
demister. It will be turned off automatically
in about 20 minutes. To turn off the demister
within about 20 minutes, push the switch again.
The indication lamp (A) will illuminate while
the demister is on.Type 1Type 2
NOTEl If your vehicle is equipped with heated mir-
rors, these operate in conjunction with thedemister. Refer to “Heated mirror” on page
6-11.
Rear window demister switch
5-43OKTE15E3Instruments and controls5

Economical driving............................................................................. 6-02
Driving, alcohol and drugs.................................................................. 6-02
Safe driving techniques....................................................................... 6-03
Running-in recommendations............................................................. 6-04 Parking brake...................................................................................... 6-07
Parking................................................................................................ 6-08
Steering wheel height adjustment....................................................... 6-09
Inside rear-view mirror....................................................................... 6-09 Outside rear-view mirrors................................................................... 6-10
Ignition switch.....................................................................................6-12 Steering wheel lock............................................................................. 6-13
Starting................................................................................................ 6-13 Diesel particulate filter (DPF)*........................................................... 6-15Manual transmission........................................................................... 6-16Automatic transmission Sports Mode 4A/T, 5A/T............................. 6-19Easy select 4WD*............................................................................... 6-25
Super select 4WD*..............................................................................6-29
Rear differential lock*........................................................................ 6-34 4-wheel drive operation...................................................................... 6-38
Inspection and maintenance following rough road operation............. 6-41
Cautions on handling of 4-wheel drive vehicles................................. 6-41
Limited-slip differential*.................................................................... 6-43
Braking................................................................................................ 6-43
Brake assist system*........................................................................... 6-44
Anti-lock brake system (ABS)*.......................................................... 6-45
Power steering system.........................................................................6-48 Active Stability & Traction Control (ASTC)*....................................6-48
Cruise control*.................................................................................... 6-50 Cargo loads......................................................................................... 6-55Trailer towing......................................................................................6-55Starting and driving
OKTE15E36

Drinking coffee or taking a cold shower willnot make you sober.
Similarly, prescription and nonprescription
drugs affect your alertness, perception and re- action time. Consult with your doctor or
pharmacist before driving while under the in- fluence of any of these medications.WARNINGl NEVER DRINK AND DRIVE.
Your perceptions are less accurate, your
reflexes are slower and your judgment is
impaired.Safe driving techniques
E00600300491
Driving safety and protection against injury
cannot be fully ensured. However, we recom- mend that you pay extra attention to the fol-
lowing:
Seat belts
Before starting the vehicle, make sure that you and your passengers have fastened your
seat belts.
Floor matsWARNINGl Keep floor mats clear of the pedals by
correctly laying floor mats that are suita-ble for the vehicle.
To prevent the floor mats from slipping
out position, securely retain them using the hooks etc.
Note that laying a floor mat over a pedal or laying one floor mat on top of another
can obstruct pedal operation and lead to a
serious accident.
Carrying children in the vehi-
cle
l Never leave your vehicle unattended
with the key in the ignition and children
inside the vehicle. Children may play with the driving controls and this could
lead to an accident.
l Make sure that infants and small chil-
dren are properly restrained in accord-
ance with the laws and regulations, and for maximum protection in case of an
accident.
l Prevent children from playing in the car-
go area. It is quite dangerous to allow
them to play there while the vehicle is
moving.
Safe driving techniques
6-03OKTE15E3Starting and driving6